Short answer

go into the exam with a plan you have already tested in mock tests. Know your average time per question, attempt the paper in two rounds (easy and familiar questions first, the rest after), skip any question where you cannot see the method within about 30-45 seconds, and guess only when you can eliminate options. Most marks lost to time are lost on a few questions that should have been left for later.

Before the exam: know the rules of the paper

Read the official notification for these four things; they change how you manage time:

  • Total time and number of questions, to set your time budget.
  • Sectional time limits, if any. If each section has its own fixed time, you cannot move time between sections, and section order may be fixed.
  • Negative marking: whether wrong answers lose marks, and how many.
  • Sectional cut-offs, if any. If you must clear a minimum in every section, you cannot ignore your weakest one.

These rules differ between exams and sometimes between years of the same exam, so always take them from the latest notification. The numbers used below are illustrations, not any exam's pattern.

Set a time budget per question

Divide the time by the number of questions. For a paper of 100 questions in 60 minutes: 60 × 60 = 3,600 seconds, and 3,600 ÷ 100 = 36 seconds a question on average. That average hides big differences. A vocabulary or GK question takes 10-15 seconds; a data interpretation question may need 90. The point of the budget is to save time on quick questions and spend it on slow ones, never to spend 3 minutes on one question.

An example time plan for a 60-minute, four-section paper (no sectional timing)
OrderSectionPlanned timeWhy this order
1General awareness8 minutesFast: you know it or you do not; banks time for later
2English14 minutesModerate speed; reading needs a fresh mind
3Reasoning17 minutesPuzzles take time; leave the longest for the second round
4Quantitative aptitude17 minutesCalculation-heavy; uses the time saved earlier
-Second round and review4 minutesReturn to marked questions

There is no single correct order. A common rule is to start with the section you are fastest and most accurate in, because early marks settle nerves and save time. Try two or three orders in mock tests and keep the one that gives the best score, not the one that feels best.

The two-round method

  1. Round 1: go through the section answering every question you can solve confidently and quickly. If a question is long, unfamiliar, or you cannot see the method within 30-45 seconds, mark it and move on.
  2. Round 2: return to the marked questions, easiest first. Spend more time here, but keep an eye on the clock.
  3. Last minutes: review only questions you marked as doubtful, and decide on guesses using the rule below.

The reason this works: every question usually carries the same marks. A hard question solved in four minutes earns the same as an easy one solved in thirty seconds, and the four minutes could have earned several easy marks.

Negative marking: when does guessing pay?

Use expected value: the chance of being right times the marks gained, minus the chance of being wrong times the marks lost. Two illustrative schemes, both with four options per question:

Expected marks from a guess (illustrative schemes)
SituationScheme A: +1, −0.25Scheme B: +1, −1/3
Pure guess among 4 options0.25 × 1 − 0.75 × 0.25 = +0.06250.25 × 1 − 0.75 × 1/3 = 0
One option eliminated (guess among 3)1/3 × 1 − 2/3 × 0.25 ≈ +0.171/3 × 1 − 2/3 × 1/3 = 1/9 ≈ +0.11
Two options eliminated (guess between 2)0.5 × 1 − 0.5 × 0.25 = +0.3750.5 × 1 − 0.5 × 1/3 ≈ +0.33

What the table shows:

  • Under a scheme like B, a blind guess gains nothing on average and only adds risk.
  • Under any common scheme, eliminating even one option makes a guess worth taking on average. Eliminating two makes it clearly worth it.
  • Averages hold over many guesses, not one. Twenty blind guesses can still go badly. That is why blind guessing on a large number of questions is a poor plan even when the arithmetic is slightly positive.
  • If the exam has no negative marking, never leave a question blank.

In practice: answer what you know, make educated guesses where you can rule out an option, and leave pure blind guesses unless the scheme has no penalty. Track your guesses in mock tests; if your educated guesses are right less than about a third of the time, your elimination needs work.

Small habits that save minutes

  • Read the last line of a long question first, so you know what is being asked before reading the data.
  • Look at the options before calculating. If they are far apart, an estimate is enough. See calculation tricks.
  • Keep rough work in numbered boxes so you can find it again in round 2.
  • For OMR answer sheets, fill bubbles carefully as you go or after each page; filling everything in the last five minutes causes shifted answers.
  • Check the clock at fixed points (for example, after each section) rather than after every question.

Practise the plan in mock tests

Time management is a skill you build in mock tests, not on exam day. After each test, note how long each section took, how many questions you marked for round 2 and how many of them you solved, and how your guesses went. Adjust one thing at a time.

Course · Beginner · Free

Quantitative Aptitude — Simplification: Foundation

Foundation course on Simplification (Quantitative Aptitude): the basics, explained from the start.

Try your section order and skipping rule on a timed test.

Take a timed test

Frequently asked questions

Which section should I attempt first?

Usually the one you are fastest and most accurate in, so you bank marks and time early. If the exam has fixed sectional timing or a fixed order, that decides it for you. Test different orders in mock tests and keep the one that scores best.

How long should I spend on one question before skipping?

If you cannot see a method within about 30-45 seconds, mark it and move on. In round 2, you can give a marked question more time, but avoid spending more than two to three times your average on any single question.

Should I attempt all questions when there is negative marking?

No. Answer what you know, guess where you can eliminate at least one option, and leave pure blind guesses. The expected-value table above shows why. If there is no negative marking, attempt every question.

Is there a safe number of attempts?

No fixed number is safe for every exam or every year, because difficulty and cut-offs change. Aim for maximum accuracy on the questions you attempt, and use your mock test results to see what attempt level gives you your best score.

I always run out of time in maths. What should I do?

Use the two-round method strictly, skip long calculations in round 1, improve calculation speed with daily practice, and use approximation when options are far apart. Also check your error log: time trouble often comes from a few topics you have not fully learnt.

How do I stay calm when I see a hard question early?

Expect it. Every paper has some. Mark it, move on, and remember that all questions usually carry the same marks. Answering the next three easy questions is worth more than solving that one.