Revision notes

Waves: Foundation

The key points, rules to remember, tables and diagrams from all 9 lessons, on one page for quick revision. To keep a copy, use your browser's Print and choose "Save as PDF".

Lesson 1

What is a wave?

Two types of mechanical waves
PropertyTransverseLongitudinal
Particle motionPerpendicular to wave directionParallel to wave direction
Parts of the waveCrests and troughsCompressions and rarefactions
ExamplesWaves on a rope, ripples on water (light is also transverse, but it is electromagnetic, not mechanical)Sound in air, a push-pull on a spring
Travels inSolids and on liquid surfacesSolids, liquids and gases

A wave transfers energy, not matter. Transverse: vibration perpendicular to travel. Longitudinal: vibration parallel to travel.

— Remember
  • A wave transports energy without transporting matter.
  • Mechanical waves need a medium; electromagnetic waves do not.
  • Transverse waves have crests and troughs; longitudinal waves have compressions and rarefactions.
Read the full lesson

Lesson 2

Wave terms and the wave equation

v = fλ. T = 1/f. If speed is fixed, a higher frequency means a shorter wavelength.

— Wave equation
  • f is measured in hertz and T = 1/f.
  • v = fλ for every kind of wave.
  • Amplitude is linked to the energy of a wave.
Read the full lesson

Lesson 3

Reflection, refraction and superposition of waves

On refraction, frequency stays the same; speed and wavelength change. On meeting, displacements add (superposition).

— Remember
  • Reflection: angle of incidence = angle of reflection.
  • Refraction changes speed and wavelength, not frequency.
  • Interference can reinforce or cancel waves.
Read the full lesson

Lesson 4

Electromagnetic waves and the spectrum

In order of increasing frequency (decreasing wavelength)
WaveTypical use
Radio wavesBroadcasting, communication
MicrowavesOvens, radar, mobile signals
InfraredRemote controls, heating
Visible lightSeeing
UltravioletSterilising, detecting fake notes
X-raysMedical imaging
Gamma raysTreating cancer, sterilising equipment

c = fλ = 3 × 10⁸ m/s in vacuum. Order by frequency: radio, microwave, infrared, visible, ultraviolet, X-ray, gamma.

— Remember
  • EM waves are transverse and need no medium.
  • All travel at 3 × 10⁸ m/s in a vacuum.
  • Frequency increases from radio waves to gamma rays.
Read the full lesson

Lesson 5

Stationary waves and mixed wave problems

Nodes are λ/2 apart. Fixed string: λ = 2L for the simplest pattern. Always use v = fλ.

— Remember
  • Stationary waves have nodes and antinodes.
  • Adjacent nodes are λ/2 apart.
  • Fundamental frequency of a fixed string: f = v ÷ 2L.
Read the full lesson

Lesson 6

Sound waves: speed, audible range and echoes

Speed of sound in different media (rounded, for practice)
MediumApproximate speed
Air at room temperature340 m/s
Water1500 m/s
Steel5000 m/s

Distance to a reflecting surface = (speed × time of echo) ÷ 2. The division by 2 is needed because the sound goes there and back.

— Rule to remember
  • Sound is a longitudinal mechanical wave and cannot travel in a vacuum.
  • In air at room temperature its speed is about 340 m/s; it is faster in liquids and fastest in solids.
  • Audible frequencies run from about 20 Hz to 20 kHz.
  • For an echo, divide the total distance travelled by 2.
Read the full lesson

Lesson 7

Pitch, loudness and quality of sound

Three properties of a musical sound
PropertyDepends onEveryday sign
PitchFrequencyHigh or low note
LoudnessAmplitude (and so intensity)Loud or soft
QualityNumber and strength of overtonesWhich instrument or voice

Pitch is frequency. Loudness is amplitude (intensity). Quality is the mixture of overtones.

— Rule to remember
  • Higher frequency means higher pitch.
  • Bigger amplitude means a louder sound; intensity varies as amplitude squared.
  • Intensity from a small source falls to one-quarter when the distance doubles.
  • Quality tells instruments and voices apart even when pitch and loudness match.
Read the full lesson

Lesson 8

Vibrating air columns: open and closed pipes

Comparison of the two pipes of length L
ItemClosed at one endOpen at both ends
Fundamental wavelength4L2L
Fundamental frequencyv/(4L)v/(2L)
Harmonics presentOdd only: f₁, 3f₁, 5f₁All: f₁, 2f₁, 3f₁

Closed pipe: L = λ/4, odd harmonics only. Open pipe: L = λ/2, all harmonics. Open fundamental = v/2L; closed fundamental = v/4L.

— Rule to remember
  • A closed end is a node; an open end is an antinode.
  • A pipe closed at one end gives odd harmonics only; a pipe open at both ends gives all harmonics.
  • For the same length, the open pipe's fundamental is twice that of the closed pipe.
  • Use f = v/λ to move between frequency and wavelength.
Read the full lesson

Lesson 9

The Doppler effect: why the pitch of a passing siren changes

Apparent frequency f′ heard by the observer
SituationFormula
Source moving towards a stationary observerf′ = f × v/(v − v_s)
Source moving away from a stationary observerf′ = f × v/(v + v_s)
Observer moving towards a stationary sourcef′ = f × (v + v_o)/v
Observer moving away from a stationary sourcef′ = f × (v − v_o)/v

Source or observer moving closer: apparent frequency rises. Moving apart: it falls. The true frequency of the source never changes.

— Rule to remember
  • The Doppler effect is a change in the apparent frequency because of relative motion between the source and the observer.
  • Approach raises the pitch and recession lowers it.
  • The source itself does not change its frequency.
  • Use f′ = f v/(v ∓ v_s) for a moving source and f′ = f (v ± v_o)/v for a moving observer.
Read the full lesson

Privacy · Terms · Refunds · Delivery