Chapter 1 Solutions

Practice questions

A solute AB₂ dissociates completely in water into A²⁺ and 2B⁻. Its molar mass found from freezing point depression would be about what fraction of the true molar mass?

  1. One-third
  2. Three times
  3. One-half
  4. The same
Answer and explanation

Answer: A

Each formula unit gives 3 ions, so i = 3. Since i = normal molar mass ÷ observed molar mass, the observed (abnormal) molar mass = true molar mass ÷ 3, i.e. one-third of the true value.

Pressure greater than the osmotic pressure is applied to sea water separated from pure water by a suitable membrane. What happens?

  1. Water moves from the pure-water side into the sea water
  2. Pure water is pushed out of the sea water through the membrane
  3. Salt passes into the pure water
  4. Nothing happens
Answer and explanation

Answer: B

Applying more than the osmotic pressure reverses the natural flow: this is reverse osmosis. Water molecules are forced out of the sea water through the membrane, while ions are held back. This is how desalination plants work.

A solution of 0.83 g of a protein in 100 mL of water has an osmotic pressure of 0.0030 bar at 300 K. What is its molar mass? (R = 0.083 L bar mol⁻¹ K⁻¹)

  1. 6.9 × 10³ g mol⁻¹
  2. 2.3 × 10³ g mol⁻¹
  3. 6.9 × 10⁴ g mol⁻¹
  4. 2.3 × 10⁴ g mol⁻¹
Answer and explanation

Answer: C

M₂ = (w₂ R T) ÷ (π V) = (0.83 × 0.083 × 300) ÷ (0.0030 × 0.100) = 20.67 ÷ 0.00030 = 68 900 g mol⁻¹ ≈ 6.9 × 10⁴ g mol⁻¹.

Assertion (A): Osmotic pressure is preferred over elevation of boiling point to find the molar masses of proteins. Reason (R): Osmotic pressure is measured at about room temperature and is large even for very dilute solutions.

  1. Both A and R are true, and R is the correct explanation of A
  2. Both A and R are true, but R is not the correct explanation of A
  3. A is true, but R is false
  4. A is false, but R is true
Answer and explanation

Answer: A

Both are true. Proteins can break down on heating, and their solutions are very dilute in particles because of the huge molar mass, so ΔTb would be tiny and require heating. Osmotic pressure avoids both problems. R explains A.

Which aqueous solution has the lowest freezing point? (Assume complete dissociation of electrolytes.)

  1. 0.1 m glucose
  2. 0.1 m NaCl
  3. 0.1 m urea
  4. 0.1 m CaCl₂
Answer and explanation

Answer: D

ΔTf = i Kf m, and all have the same m. i = 1 for glucose and urea, 2 for NaCl and 3 for CaCl₂ (Ca²⁺ + 2Cl⁻). CaCl₂ gives the most particles, the largest ΔTf and therefore the lowest freezing point.

0.90 g of a non-electrolyte in 50 g of water raises the boiling point by 0.052 K. Kb for water = 0.52 K kg mol⁻¹. What is the molar mass of the solute?

  1. 90 g mol⁻¹
  2. 180 g mol⁻¹
  3. 360 g mol⁻¹
  4. 18 g mol⁻¹
Answer and explanation

Answer: B

M₂ = (Kb × 1000 × w₂) ÷ (ΔTb × w₁) = (0.52 × 1000 × 0.90) ÷ (0.052 × 50) = 468 ÷ 2.6 = 180 g mol⁻¹.

18 g of glucose (180 g mol⁻¹) is dissolved in 178.2 g of water. Pure water has a vapour pressure of 17.5 mm Hg at this temperature. What is the lowering of vapour pressure?

  1. 0.175 mm Hg
  2. 1.75 mm Hg
  3. 0.0175 mm Hg
  4. 0.35 mm Hg
Answer and explanation

Answer: A

n(glucose) = 18 ÷ 180 = 0.1 mol; n(water) = 178.2 ÷ 18 = 9.9 mol. x₂ = 0.1 ÷ (0.1 + 9.9) = 0.01. Lowering = x₂ p₁⁰ = 0.01 × 17.5 = 0.175 mm Hg.

Mixing two liquids releases heat and the final volume is slightly less than the sum of the two volumes. Which statement fits this mixture?

  1. It is an ideal solution
  2. It shows positive deviation and can form a minimum boiling azeotrope
  3. It obeys Raoult's law exactly
  4. It shows negative deviation and can form a maximum boiling azeotrope
Answer and explanation

Answer: D

ΔmixH < 0 and ΔmixV < 0 mean the A–B attractions are stronger than A–A and B–B. The vapour pressure is lower than Raoult's law predicts (negative deviation), and a large negative deviation gives a maximum boiling azeotrope, like nitric acid and water.

In the solution of the previous question, what is the mole fraction of A in the vapour?

  1. 0.40
  2. 0.57
  3. 0.29
  4. 0.71
Answer and explanation

Answer: B

p_A = 400 × 0.40 = 160 mm Hg. y_A = p_A ÷ p_total = 160 ÷ 280 = 0.57. The vapour is richer in A, the more volatile component.

Pure liquids A and B have vapour pressures 400 mm Hg and 200 mm Hg. An ideal solution of them has a total vapour pressure of 280 mm Hg. What is the mole fraction of A in the liquid?

  1. 0.60
  2. 0.70
  3. 0.40
  4. 0.30
Answer and explanation

Answer: C

p_total = p_B⁰ + (p_A⁰ − p_B⁰) x_A → 280 = 200 + 200 x_A → x_A = 80 ÷ 200 = 0.40.

Which change will increase the amount of oxygen dissolved in a sample of water?

  1. Lowering the temperature of the water
  2. Heating the water
  3. Reducing the pressure of air above it
  4. Dissolving more salt in it
Answer and explanation

Answer: A

Dissolving a gas is exothermic, so cooling favours dissolution; K_H falls and more oxygen dissolves. Heating and lowering the pressure both reduce gas solubility (Henry's law).

K_H for gas P in water is 2.0 × 10⁵ bar at 298 K. What is its mole fraction in water when its partial pressure is 1.0 bar?

  1. 2.0 × 10⁵
  2. 2.0 × 10⁻⁵
  3. 1.0 × 10⁻⁵
  4. 5.0 × 10⁻⁶
Answer and explanation

Answer: D

x = p ÷ K_H = 1.0 ÷ (2.0 × 10⁵) = 5.0 × 10⁻⁶.

Assertion (A): Molality is preferred to molarity for expressing concentration in experiments done at different temperatures. Reason (R): Molality depends on the mass of the solvent, which does not change with temperature.

  1. Both A and R are true, and R is the correct explanation of A
  2. Both A and R are true, but R is not the correct explanation of A
  3. A is true, but R is false
  4. A is false, but R is true
Answer and explanation

Answer: A

Both are true. Molarity uses volume, which changes with temperature; molality uses the mass of the solvent, which does not. R correctly explains why molality is preferred.

A 20% (by mass) aqueous solution of a solute X (M = 100 g mol⁻¹) is given. What is the mole fraction of X? (water = 18 g mol⁻¹)

  1. 0.20
  2. 0.043
  3. 0.25
  4. 0.045
Answer and explanation

Answer: B

In 100 g: 20 g of X = 0.20 mol and 80 g of water = 4.44 mol. x(X) = 0.20 ÷ (0.20 + 4.44) = 0.20 ÷ 4.64 = 0.043.

A solution of NaOH (40 g mol⁻¹) contains 2.0 g of NaOH in 200 g of water. What is its molality?

  1. 0.10 mol kg⁻¹
  2. 0.25 mol kg⁻¹
  3. 0.50 mol kg⁻¹
  4. 0.025 mol kg⁻¹
Answer and explanation

Answer: B

Moles of NaOH = 2.0 ÷ 40 = 0.050 mol. Mass of water = 0.200 kg. Molality = 0.050 ÷ 0.200 = 0.25 mol kg⁻¹.

A weak acid HA (HA ⇌ H⁺ + A⁻) has a van't Hoff factor of 1.05 in a dilute aqueous solution. What is its degree of dissociation?

  1. 0.5%
  2. 5%
  3. 50%
  4. 10.5%
Answer and explanation

Answer: B

For a solute giving two ions, i = 1 + α. So α = i − 1 = 1.05 − 1 = 0.05, which is 5% dissociation.

Assertion (A): The molar mass of ethanoic acid found from the freezing point depression of its benzene solution is about twice its true value. Reason (R): Ethanoic acid molecules form dimers in benzene through hydrogen bonding.

  1. Both A and R are true, and R is the correct explanation of A
  2. Both A and R are true, but R is not the correct explanation of A
  3. A is true, but R is false
  4. A is false, but R is true
Answer and explanation

Answer: A

Both are true. Dimerisation halves the number of particles, so ΔTf is about half the expected value. Since M₂ is inversely proportional to ΔTf, the calculated molar mass comes out about twice the true value. R explains A.

What is the van't Hoff factor for K₂SO₄ in a very dilute aqueous solution, assuming complete dissociation?

  1. 1
  2. 2
  3. 4
  4. 3
Answer and explanation

Answer: D

K₂SO₄ → 2K⁺ + SO₄²⁻ gives three ions per formula unit, so i = 3 for complete dissociation.

Red blood cells are placed in a 2% (mass/volume) NaCl solution. What happens to them?

  1. They swell and may burst
  2. Nothing, because the solution is isotonic
  3. They shrink as water flows out
  4. They absorb salt and grow
Answer and explanation

Answer: C

Blood cell fluid is isotonic with 0.9% NaCl. A 2% solution is hypertonic, so water moves out of the cells by osmosis and they shrink.

What is the osmotic pressure of a 0.20 M solution of a non-electrolyte at 300 K? (R = 0.083 L bar mol⁻¹ K⁻¹)

  1. 4.98 bar
  2. 2.49 bar
  3. 0.498 bar
  4. 49.8 bar
Answer and explanation

Answer: A

π = CRT = 0.20 × 0.083 × 300 = 4.98 bar.

Privacy · Terms · Refunds · Delivery