Chapter 3 Current Electricity
Practice questions
A Wheatstone bridge has R₁ = 10 Ω, R₂ = 30 Ω, R₃ = 20 Ω and R₄ = 50 Ω. What resistance must be connected in parallel with R₃ to balance it?
- 60 Ω
- 100 Ω
- 16.7 Ω
- 300 Ω
Answer and explanation
Answer: B
Balance needs R₂/R₁ = R₄/R₃′, so R₃′ = R₄ × R₁/R₂ = 50 × 10 ÷ 30 ≈ 16.7 Ω. A resistor X in parallel with 20 Ω gives 16.7 Ω when 1/X = 1/16.67 − 1/20 = 0.06 − 0.05 = 0.01, so X = 100 Ω.
In the two-loop circuit of lesson 5 (12 V with 2 Ω, 6 V with 2 Ω, 4 Ω in the middle), what is the potential difference across the 4 Ω resistor?
- 4.8 V
- 2.4 V
- 7.2 V
- 9.6 V
Answer and explanation
Answer: C
The current in the 4 Ω middle branch was found to be I₃ = 1.8 A, so V = I₃R = 1.8 × 4 = 7.2 V. Check from the left branch: 12 − 2.4 × 2 = 7.2 V.
Kirchhoff's loop rule is based on
- conservation of charge
- the fact that potential at a point has a single value (conservation of energy)
- Ohm's law
- conservation of momentum
Answer and explanation
Answer: B
Going round a closed loop returns you to the same point and so to the same potential, so the changes must add to zero. This expresses conservation of energy for a charge taken round the loop.
Two cells of emf 4 V and 2 V, each of internal resistance 2 Ω, are joined in parallel (like terminals together). What is the emf of the combination?
- 6 V
- 2 V
- 4 V
- 3 V
Answer and explanation
Answer: D
ε_eq = (ε₁r₂ + ε₂r₁)/(r₁ + r₂) = (4 × 2 + 2 × 2) ÷ 4 = 12 ÷ 4 = 3 V; r_eq = 1 Ω.
Two cells, 4 V with 1 Ω and 2 V with 1 Ω, are connected in series but with the 2 V cell reversed, across a 4 Ω resistor. What current flows?
- 1 A
- 0.33 A
- 0.67 A
- 0.5 A
Answer and explanation
Answer: B
With one cell reversed, ε_eq = 4 − 2 = 2 V, while internal resistances still add: r_eq = 2 Ω. I = 2 ÷ (4 + 2) ≈ 0.33 A.
A battery of emf 12 V gives a terminal voltage of 11 V when connected to a 5.5 Ω resistor. What is its internal resistance?
- 1 Ω
- 0.25 Ω
- 0.5 Ω
- 2 Ω
Answer and explanation
Answer: C
I = V/R = 11 ÷ 5.5 = 2 A. ε − V = Ir gives 12 − 11 = 2r, so r = 0.5 Ω.
Power of 200 kW is transmitted through a line of resistance 2 Ω. What is the power lost in the line if the transmission voltage is 20 kV?
- 200 W
- 2 kW
- 20 W
- 20 kW
Answer and explanation
Answer: A
I = P/V = 200 000 ÷ 20 000 = 10 A. Loss = I²R = 100 × 2 = 200 W.
Two bulbs rated 100 W, 220 V and 60 W, 220 V are compared. Which has the higher resistance, and by what ratio?
- The 100 W bulb, 5 : 3
- The 60 W bulb, 5 : 3
- The 60 W bulb, 3 : 5
- Both are equal
Answer and explanation
Answer: B
R = V²/P. At equal rated voltage, R ∝ 1/P, so R(60 W)/R(100 W) = 100/60 = 5 : 3. The 60 W bulb has the higher resistance.
A coil has resistance 40 Ω at 0 °C and 44 Ω at 50 °C. What will its resistance be at 100 °C, assuming the linear relation holds?
- 46 Ω
- 52 Ω
- 50 Ω
- 48 Ω
Answer and explanation
Answer: D
α = (44 − 40) ÷ (40 × 50) = 4 ÷ 2000 = 2 × 10⁻³ °C⁻¹. At 100 °C: R = 40 × (1 + 2 × 10⁻³ × 100) = 40 × 1.2 = 48 Ω.
The drift speed of electrons in a conductor is proportional to
- the time since the field was switched on
- the square of the field
- the field strength
- the length of the conductor only
Answer and explanation
Answer: C
vd = eEτ/m = μE: the drift speed is directly proportional to E. It does not keep growing with time because collisions limit it.
Assertion (A): A current is set up in a long circuit almost the instant the switch is closed, even though electrons drift very slowly. Reason (R): The electric field spreads through the circuit at nearly the speed of light, making electrons everywhere start drifting at once.
- Both A and R are true, and R is the correct explanation of A
- Both A and R are true, but R is not the correct explanation of A
- A is true, but R is false
- A is false, but R is true
Answer and explanation
Answer: A
Both are true. Current does not wait for electrons to travel round the circuit; the field reaches all parts almost instantly, so local drift starts everywhere together. R explains A.
A wire carries 3.4 A. The free-electron density is 8.5 × 10²⁸ m⁻³ and the cross-section is 2.5 × 10⁻⁶ m². How long does an electron take to drift 1.0 m?
- 1.0 × 10⁴ s
- 2.5 × 10³ s
- 1.0 × 10⁻⁴ s
- 1.6 × 10⁴ s
Answer and explanation
Answer: A
vd = I/(neA) = 3.4 ÷ (8.5 × 10²⁸ × 1.6 × 10⁻¹⁹ × 2.5 × 10⁻⁶) = 3.4 ÷ 3.4 × 10⁴ = 1.0 × 10⁻⁴ m s⁻¹. Time = 1.0 ÷ 1.0 × 10⁻⁴ = 1.0 × 10⁴ s.
A conductor has resistivity 2 × 10⁻⁸ Ω m and carries a current density of 5 × 10⁶ A m⁻². What is the electric field inside it?
- 0.4 V m⁻¹
- 2.5 × 10¹⁴ V m⁻¹
- 4 × 10⁻¹⁵ V m⁻¹
- 0.1 V m⁻¹
Answer and explanation
Answer: D
E = ρj = 2 × 10⁻⁸ × 5 × 10⁶ = 0.1 V m⁻¹.
Two wires of the same material have lengths in the ratio 1 : 2 and diameters in the ratio 2 : 1. What is the ratio of their resistances?
- 1 : 8
- 1 : 4
- 8 : 1
- 1 : 2
Answer and explanation
Answer: A
R = ρl/A with A ∝ d². R₁/R₂ = (l₁/l₂) × (d₂/d₁)² = (1/2) × (1/2)² = 1/8.
The current through a wire varies so that 3 × 10¹⁹ electrons pass a cross-section in 2 s. What is the average current?
- 4.8 A
- 2.4 A
- 9.6 A
- 1.5 A
Answer and explanation
Answer: B
Q = ne = 3 × 10¹⁹ × 1.6 × 10⁻¹⁹ = 4.8 C. I = Q/t = 4.8 ÷ 2 = 2.4 A.
Assertion (A): The balance condition of a Wheatstone bridge does not depend on the resistance of the galvanometer. Reason (R): At balance no current flows through the galvanometer, so there is no potential drop across it.
- Both A and R are true, and R is the correct explanation of A
- Both A and R are true, but R is not the correct explanation of A
- A is true, but R is false
- A is false, but R is true
Answer and explanation
Answer: A
Both are true. At balance I_g = 0, so the galvanometer arm contributes 0 × R_G = 0 to each loop equation, and its resistance drops out of R₂/R₁ = R₄/R₃. R explains A, and this is why a null method is so accurate.
A Wheatstone bridge is balanced with R₁ = 100 Ω, R₂ = 20 Ω and R₃ = 250 Ω. What is the fourth resistance R₄?
- 1250 Ω
- 8 Ω
- 50 Ω
- 500 Ω
Answer and explanation
Answer: C
R₂/R₁ = R₄/R₃, so R₄ = R₃ × R₂/R₁ = 250 × 20 ÷ 100 = 50 Ω.
Going round a loop in the direction of the current, you cross a 5 Ω resistor carrying 2 A and then a cell of emf 12 V from its negative to its positive terminal. The total change in potential over these two elements is
- −22 V
- +22 V
- −2 V
- +2 V
Answer and explanation
Answer: D
Across the resistor along the current: −IR = −2 × 5 = −10 V. Across the cell from − to +: +12 V. Total = −10 + 12 = +2 V.
Currents of 3 A and 2 A flow into a junction, and a current of 4 A flows out along one wire. What current flows in the only other wire, and which way?
- 1 A out of the junction
- 1 A into the junction
- 9 A out of the junction
- 5 A into the junction
Answer and explanation
Answer: A
Total in = 3 + 2 = 5 A. Out so far = 4 A. By the junction rule the remaining wire must carry 5 − 4 = 1 A out of the junction.
Kirchhoff's junction rule is a consequence of the conservation of
- energy
- charge
- momentum
- mass of the wires
Answer and explanation
Answer: B
For steady currents charge cannot pile up at a junction, so the total current entering must equal the total leaving. This is conservation of charge.