Chapter 4 Effects of electric current

Practice questions

Why is electric power transmitted over long distances as AC?

  1. AC cannot cause shocks
  2. AC needs no wires
  3. AC flows only one way
  4. Power loss during transmission can be kept small
Answer and explanation

Answer: D

Transmitting power as AC allows the loss of power in long transmission lines to be kept small, which is why power stations supply AC.

What is the main difference between an AC generator and a DC generator?

  1. An AC generator uses slip rings; a DC generator uses a split ring
  2. An AC generator has no magnet
  3. A DC generator has no coil
  4. An AC generator needs a battery
Answer and explanation

Answer: A

With two full (slip) rings the outer current reverses every half turn (AC). A split ring keeps the outer current in one direction (DC).

A magnet is pushed quickly into a coil connected to a galvanometer, then held still inside. The galvanometer shows:

  1. A steady deflection all the time
  2. No deflection at any time
  3. Deflection only while the magnet moves, then zero
  4. Deflection only while the magnet is still
Answer and explanation

Answer: C

Current is induced only while the magnetic lines through the coil are changing, that is, while the magnet moves. When it is still, the current stops.

Which device converts mechanical energy into electrical energy?

  1. Electric generator
  2. Electric motor
  3. Galvanometer
  4. Voltmeter
Answer and explanation

Answer: A

A generator rotates a coil in a magnetic field using mechanical energy and produces an induced current. A motor does the reverse.

In an electric motor, the carbon brushes:

  1. Rotate with the coil
  2. Produce the magnetic field
  3. Stay still and press on the split ring to carry current to the coil
  4. Reverse the magnetic poles
Answer and explanation

Answer: C

The brushes are stationary contacts that press against the rotating split ring halves and carry current in and out of the coil.

A straight wire carries current in a magnetic field. Which change will reverse the force on it?

  1. Doubling the current
  2. Reversing the direction of the current
  3. Using a thicker wire
  4. Increasing the field strength
Answer and explanation

Answer: B

The force direction depends on the directions of the current and the field. Reversing either one reverses the force. Changing magnitudes changes only the size of the force.

Which change will NOT increase the magnetic field at the centre of a circular coil?

  1. Increasing the current
  2. Increasing the number of turns
  3. Reversing the direction of the current
  4. Using both more current and more turns
Answer and explanation

Answer: C

Reversing the current only reverses the direction of the field; its strength stays the same. More current or more turns make the field stronger.

A current flows vertically downwards through a wire passing through a horizontal card. Seen from above, the lines of force around the wire run:

  1. Anticlockwise
  2. Radially outwards
  3. Clockwise
  4. Parallel to the wire
Answer and explanation

Answer: C

Point your right thumb downwards (away from you, as seen from above). Your fingers curl clockwise as seen from above.

Why is an alloy such as nichrome, not pure copper, used in the heating coil of an electric iron?

  1. Nichrome is a better conductor than copper
  2. Nichrome has high resistivity and does not oxidise easily when red hot
  3. Nichrome is magnetic
  4. Copper cannot carry current
Answer and explanation

Answer: B

A heating element needs high resistance to produce heat, and must survive being very hot in air. Nichrome has high resistivity and resists oxidation; copper has low resistivity.

Bulbs of 40 W and 70 W are connected in parallel to a 220 V supply. What current flows in the main wire?

  1. 2 A
  2. 0.18 A
  3. 0.32 A
  4. 0.5 A
Answer and explanation

Answer: D

Total power = 40 + 70 = 110 W. I = P / V = 110 / 220 = 0.5 A.

A 1500 W geyser is used for 40 minutes daily for 30 days. At a made-up rate of ₹6 per unit, what is the cost?

  1. ₹180
  2. ₹270
  3. ₹30
  4. ₹1800
Answer and explanation

Answer: A

Energy = 1.5 kW × (40/60) h × 30 = 1.5 × 2/3 × 30 = 30 kWh = 30 units. Cost = 30 × 6 = ₹180.

Which uses more electrical energy: an 800 W microwave oven in 15 minutes or a 1200 W heater in 12 minutes?

  1. The microwave oven
  2. Both use the same
  3. The heater
  4. Cannot be found
Answer and explanation

Answer: C

Microwave: 800 W × 0.25 h = 200 Wh. Heater: 1200 W × 0.2 h = 240 Wh. The heater uses more energy.

Heat is produced in a resistance at 100 W when a current of 5 A flows. What is the resistance?

  1. 4 Ω
  2. 20 Ω
  3. 500 Ω
  4. 0.25 Ω
Answer and explanation

Answer: A

P = I² R, so R = P / I² = 100 / 25 = 4 Ω.

Two resistors of 10 Ω and 20 Ω carry the same current for the same time. The heat produced in the 20 Ω resistor is:

  1. Half that in the 10 Ω resistor
  2. The same
  3. Four times that in the 10 Ω resistor
  4. Twice that in the 10 Ω resistor
Answer and explanation

Answer: D

H = I² R t. With I and t the same, H is proportional to R, so the 20 Ω resistor produces twice the heat.

A 12 V battery sends a current of 0.5 A through a lamp for 2 minutes. How much energy does the lamp receive?

  1. 12 J
  2. 720 J
  3. 360 J
  4. 6 J
Answer and explanation

Answer: B

Energy = V I t = 12 × 0.5 × (2 × 60) = 6 × 120 = 720 J.

A galvanometer connected to a coil shows a deflection only while a magnet is moving near it. Why?

  1. The magnet loses its magnetism when still
  2. The galvanometer works only for moving magnets
  3. A current is induced only while the number of magnetic lines through the coil is changing
  4. The coil heats up when the magnet moves
Answer and explanation

Answer: C

By Faraday's law, a current is induced only when the magnetic lines passing through the coil change. A still magnet gives an unchanging field and no induced current.

Which part makes a generator give direct current instead of alternating current?

  1. Two full conducting rings
  2. A split ring
  3. A stronger magnet
  4. More turns in the coil
Answer and explanation

Answer: B

With a split ring, the brush connections swap every half turn, so the current in the outer circuit always flows one way. Two full rings give AC.

The frequency of AC supply in India is 50 Hz. How long does one cycle take?

  1. 0.5 s
  2. 50 s
  3. 0.2 s
  4. 0.02 s
Answer and explanation

Answer: D

Time for one cycle = 1 / frequency = 1/50 s = 0.02 s.

In Fleming's right hand rule, the middle finger gives the direction of the:

  1. Induced current
  2. Magnetic field
  3. Motion of the conductor
  4. Force on the conductor
Answer and explanation

Answer: A

Right hand rule: thumb = motion of the conductor, index finger = magnetic field, middle finger = induced current.

Electromagnetic induction means:

  1. Charging a conductor by rubbing
  2. Producing a magnetic field by a current in a coil
  3. Generating a current in a coil due to relative motion between the coil and a magnet
  4. Rotation of a coil in a motor
Answer and explanation

Answer: C

When the magnetic lines of force through a coil change, for example by moving a magnet and coil relative to each other, a current is induced. That is electromagnetic induction.

Privacy · Terms · Refunds · Delivery