Chapter 3 Current Electricity
Practice questions
In a house, the TV stops working because of a fault inside it. What happens to the other appliances?
- They keep working, because each is connected in parallel with its own path
- They all stop, because the appliances are in series
- They all work at a lower voltage
- They all draw more current and their fuses melt
Answer and explanation
Answer: A
Household appliances are connected in parallel between the live and neutral wires. A fault in one path does not break the others, which still get the full supply voltage.
What is the purpose of the earth wire in household wiring?
- To bring current into the house
- To carry the current back to the pole in normal use
- To increase the voltage of the supply
- Safety: it gives a path to the ground through a metal plate buried near the house
Answer and explanation
Answer: D
The earth wire is joined to a metal plate buried deep in the ground. It is there for safety; in normal use the live wire brings current in and the neutral wire carries it back.
On a 220 V circuit protected by a 5 A fuse, a 55 Ω heater and a 1100 Ω lamp are on. A second 55 Ω heater is switched on. What happens?
- Nothing; the total current is 4.2 A
- The lamp goes dim but the fuse holds
- The fuse melts because the total current becomes 8.2 A
- The fuse melts because the current through the lamp becomes 5 A
Answer and explanation
Answer: C
Each heater draws 220 ÷ 55 = 4 A and the lamp 220 ÷ 1100 = 0.2 A. With both heaters the total is 4 + 4 + 0.2 = 8.2 A, more than 5 A, so the fuse melts. The lamp still gets 220 V, so it is not dimmed.
Resistors of 10 Ω and 15 Ω are connected in parallel across a 6 V battery. What current flows through the 15 Ω resistor?
- 1.0 A
- 0.6 A
- 2.5 A
- 0.4 A
Answer and explanation
Answer: D
In parallel each resistor has the full 6 V across it. Through 15 Ω: I = 6 ÷ 15 = 0.4 A. (Through 10 Ω it is 0.6 A, and the total is 1.0 A.)
Two 6 Ω resistors are connected in parallel, and this pair is connected in series with a third 6 Ω resistor. What is the total resistance?
- 18 Ω
- 2 Ω
- 9 Ω
- 4 Ω
Answer and explanation
Answer: C
The parallel pair: 6 ÷ 2 = 3 Ω. In series with 6 Ω: 3 + 6 = 9 Ω.
Two resistors have an effective resistance of 50 Ω in series and 12 Ω in parallel. What are their values?
- 25 Ω and 25 Ω
- 20 Ω and 30 Ω
- 10 Ω and 40 Ω
- 15 Ω and 35 Ω
Answer and explanation
Answer: B
R₁ + R₂ = 50. In parallel, Rp = R₁R₂/(R₁ + R₂) = 12, so R₁R₂ = 600. Two numbers adding to 50 and multiplying to 600 are 20 and 30. Check: 20 × 30 ÷ 50 = 12 Ω.
Why is the heating coil of an electric iron made of nichrome while the connecting cord is made of copper?
- Nichrome is cheaper than copper
- Copper melts at a lower temperature than nichrome
- Nichrome is a better conductor than copper
- Nichrome has a high resistivity so it heats up; copper has a low resistivity so the cord stays cool
Answer and explanation
Answer: D
A heating element needs high resistance to produce a lot of heat, so a high-resistivity alloy like nichrome is used. The cord should waste as little energy as possible, so low-resistivity copper is used.
A 1.5 m length of nichrome wire has a resistance of 9 Ω. What length of the same wire has a resistance of 3 Ω?
- 0.5 m
- 4.5 m
- 3 m
- 0.33 m
Answer and explanation
Answer: A
Resistance per metre = 9 ÷ 1.5 = 6 Ω/m. Length for 3 Ω = 3 ÷ 6 = 0.5 m. (R is proportional to L, so one third of the resistance needs one third of the length.)
Wire A has length L and area of cross-section A. Wire B, of the same material, has length 2L and area 2A. How do their resistances compare?
- B has twice the resistance of A
- Both have the same resistance
- B has half the resistance of A
- B has four times the resistance of A
Answer and explanation
Answer: B
R = ρL/A. For B: ρ(2L)/(2A) = ρL/A, the same as A. Doubling the length doubles R, and doubling the area halves it, so the effects cancel.
A component of resistance 0.25 kΩ carries a current of 0.2 A. What is the potential difference across it?
- 0.05 V
- 5 V
- 50 V
- 1250 V
Answer and explanation
Answer: C
0.25 kΩ = 250 Ω. V = IR = 0.2 × 250 = 50 V. Forgetting to convert kilo-ohms gives 0.05 V.
A student records V = 2 V, I = 0.5 A; V = 4 V, I = 1.0 A; V = 6 V, I = 1.5 A for a wire. What is its resistance?
- 4 Ω
- 0.25 Ω
- 2 Ω
- 12 Ω
Answer and explanation
Answer: A
V/I = 2/0.5 = 4/1.0 = 6/1.5 = 4 Ω every time, so the resistance is 4 Ω and the wire obeys Ohm's law. Taking I/V gives the wrong 0.25.
Which statement about a voltmeter is correct?
- It has a very low resistance and is connected in series
- It has a very low resistance and is connected in parallel
- It has a very high resistance and is connected in series
- It has a very high resistance and is connected in parallel
Answer and explanation
Answer: D
A voltmeter measures the potential difference across a component, so it is connected in parallel. Its very high resistance means it draws only a tiny current and does not disturb the circuit.
How much work is done in moving 4 C of charge across a potential difference of 1.5 kV?
- 375 J
- 6000 J
- 6 J
- 0.375 J
Answer and explanation
Answer: B
1.5 kV = 1500 V. W = V × Q = 1500 × 4 = 6000 J. Using 1.5 instead of 1500 gives the wrong 6 J.
How many electrons make up a charge of 0.8 C? (Charge of an electron = 1.6 × 10⁻¹⁹ C)
- 1.28 × 10⁻¹⁹
- 2 × 10¹⁸
- 5 × 10¹⁸
- 5 × 10¹⁹
Answer and explanation
Answer: C
Number of electrons = total charge ÷ charge of one electron = 0.8 ÷ (1.6 × 10⁻¹⁹) = 0.5 × 10¹⁹ = 5 × 10¹⁸.
A current of 2 mA flows through a circuit for 10 minutes. How much charge passes?
- 1.2 C
- 20 C
- 1200 C
- 0.012 C
Answer and explanation
Answer: A
I = 2 mA = 2 × 10⁻³ A and t = 10 × 60 = 600 s. Q = I × t = 0.002 × 600 = 1.2 C. Forgetting to convert milliamperes gives 1200.
On a 220 V supply, an iron of resistance 55 Ω and a fan of resistance 440 Ω are working together. What is the total current drawn?
- 4.5 A
- 4 A
- 0.44 A
- 0.5 A
Answer and explanation
Answer: A
Both are in parallel across 220 V. Iron: 220 ÷ 55 = 4 A. Fan: 220 ÷ 440 = 0.5 A. Total = 4 + 0.5 = 4.5 A.
Your friend is stuck to a live wire and getting a shock. What should you do first?
- Pull your friend away with your bare hands
- Switch off the main switch, or push your friend away with a dry wooden pole
- Pour water on your friend
- Touch the wire to check whether it is live
Answer and explanation
Answer: B
Touching the person would pass the current into you as well, and water conducts. Cut the supply at the main switch or plug, or use a dry wooden pole, which is an insulator, to push the person away.
How is a fuse wire connected in a circuit, and why?
- In parallel, so that it carries no current
- Across the earth wire, so that it never heats
- In parallel with each bulb, so the bulbs glow brighter
- In series, so that the whole current passes through it and it melts if the current is too large
Answer and explanation
Answer: D
The fuse must carry the same current as the circuit it protects, so it is in series. When the current exceeds its limit, the fuse wire heats up, melts and breaks the circuit.
Why are household appliances connected in parallel?
- So that each gets the same supply voltage and can be switched on or off independently
- So that the same current flows through all of them
- So that the total resistance of the house increases
- So that one switch controls every appliance
Answer and explanation
Answer: A
In parallel, every appliance is directly across the live and neutral wires, so each gets the full supply voltage and has its own path. One appliance can be turned off or fail without affecting the others.
What is the usual insulation colour of the earth wire in household wiring?
- Red or brown
- Blue or black
- Green or yellow
- White
Answer and explanation
Answer: C
The live wire is usually red or brown, the neutral wire blue or black, and the earth wire green or yellow.