Electricity
Practice questions
Which quantity does NOT change when a copper wire is cut in half?
- Resistance
- Length
- Resistivity
- Area times length
Answer and explanation
Answer: C
Resistivity is a property of the material at a given temperature, so cutting does not change it. Resistance and length both halve, and area times length (the volume) also halves.
A wire of resistance 4 Ω is stretched to three times its length (volume constant). Its new resistance is:
- 12 Ω
- 36 Ω
- 4/3 Ω
- 16 Ω
Answer and explanation
Answer: B
R ∝ L², so R = 4 × 9 = 36 Ω.
A metal coil has R₀ = 50 Ω at 0 °C and α = 0.004 per °C. At 100 °C its resistance is:
- 50.4 Ω
- 90 Ω
- 20 Ω
- 70 Ω
Answer and explanation
Answer: D
R = 50 × (1 + 0.004 × 100) = 50 × 1.4 = 70 Ω.
If the current in a wire is doubled, the drift velocity of the electrons becomes:
- doubled
- unchanged
- halved
- four times
Answer and explanation
Answer: A
I = nAev, so with n, A and e unchanged, v is proportional to I and doubles.
The diameter of a wire is doubled, with length and material unchanged. Its resistance becomes:
- double
- four times
- one quarter
- half
Answer and explanation
Answer: C
Area becomes 4 times, so R = ρL/A becomes one quarter.
When a source delivers maximum power to its load, the efficiency of the circuit is:
- 50 percent
- 100 percent
- 25 percent
- 75 percent
Answer and explanation
Answer: A
At R = r the load and the internal resistance get equal power, so half the power reaches the load: 50 percent.
A cell of EMF 6 V and internal resistance 1 Ω is being charged with a current of 2 A. Its terminal voltage is:
- 4 V
- 6 V
- 7 V
- 8 V
Answer and explanation
Answer: D
While charging, V = E + Ir = 6 + 2 × 1 = 8 V, which is above its EMF.
A cell of EMF 9 V and internal resistance 1.5 Ω supplies a load. The maximum power that can be delivered to the load is:
- 13.5 W
- 6.75 W
- 27 W
- 54 W
Answer and explanation
Answer: A
The best load is R = 1.5 Ω. P_max = E²/4r = 81/6 = 13.5 W.
Four identical cells, each with internal resistance 2 Ω, are joined in parallel. The net internal resistance is:
- 8 Ω
- 0.5 Ω
- 1 Ω
- 2.0 Ω
Answer and explanation
Answer: B
In parallel r_net = r/n = 2/4 = 0.5 Ω.
Four cells of 1.5 V each are joined in series. The net EMF is:
- 1.5 V
- 3 V
- 6 V
- 0.375 V
Answer and explanation
Answer: C
In series the EMFs add: 4 × 1.5 = 6 V.
A 5 Ω resistor is connected across two points that are joined by a thick copper wire of negligible resistance. The current in the 5 Ω resistor is:
- zero
- one fifth of the total
- one half of the total
- equal to the total
Answer and explanation
Answer: A
The wire short-circuits the resistor. Both ends are at the same potential, so no current flows through it.
A current of 3 A enters 2 Ω and 6 Ω in parallel. The current through the 6 Ω resistor is:
- 0.75 A
- 2.25 A
- 1.5 A
- 1 A
Answer and explanation
Answer: A
Current in 6 Ω = 3 × 2/(2 + 6) = 0.75 A. The remaining 2.25 A goes through the 2 Ω resistor.
A 36 Ω wire is cut into 3 equal pieces which are joined in parallel. The resistance becomes:
- 12 Ω
- 3 Ω
- 9 Ω
- 4 Ω
Answer and explanation
Answer: D
Each piece is 12 Ω. Three in parallel give 12/3 = 4 Ω, which is 36/3².
Four 10 Ω resistors form a bridge, with a 50 Ω resistor across the middle. The resistance between the input points is:
- 20 Ω
- 10 Ω
- 40 Ω
- 30 Ω
Answer and explanation
Answer: B
The bridge is balanced, so no current flows through the 50 Ω resistor. The two branches of 20 Ω are in parallel, giving 10 Ω.
A uniform ring of wire has resistance 8 Ω. The resistance between two diametrically opposite points is:
- 4 Ω
- 1 Ω
- 2 Ω
- 16 Ω
Answer and explanation
Answer: C
Each half is 4 Ω and the two halves are in parallel: (4 × 4)/8 = 2 Ω, which is 8/4.
A capacitor stays connected to a battery and a slab with K = 3 fills the gap. The charge on it becomes:
- three times larger
- three times smaller
- the same as before
- nine times larger
Answer and explanation
Answer: A
V is fixed by the battery and C becomes 3 times larger, so Q = CV becomes 3 times larger.
The energy stored in a 10 μF capacitor charged to 20 V is:
- 2 × 10⁻² J
- 4 × 10⁻³ J
- 2 × 10⁻³ J
- 1 × 10⁻³ J
Answer and explanation
Answer: C
U = ½CV² = ½ × 10 × 10⁻⁶ × 400 = 2 × 10⁻³ J.
A 2 μF capacitor charged to 50 V is joined to an uncharged 3 μF capacitor. The common voltage is:
- 20 V
- 25 V
- 10 V
- 30 V
Answer and explanation
Answer: A
Charge = 2 × 50 = 100 μC. Common voltage = 100/(2 + 3) = 20 V.
A 3 μF and a 6 μF capacitor in series are connected across 9 V. The voltage across the 3 μF capacitor is:
- 3 V
- 4.5 V
- 9 V
- 6 V
Answer and explanation
Answer: D
C = (3 × 6)/9 = 2 μF, so Q = 2 × 9 = 18 μC on each. V across 3 μF = 18/3 = 6 V; across 6 μF it is 3 V.
Three capacitors of 6 μF each are joined in series. The equivalent capacitance is:
- 18 μF
- 6 μF
- 2 μF
- 9 μF
Answer and explanation
Answer: C
For equal capacitors in series, C = 6/3 = 2 μF. 18 μF would be the parallel value.