Unit 4 Electricity

Practice questions

Which is a merit of an LED bulb over a filament bulb?

  1. It needs mercury to work
  2. It uses less power and wastes much less energy as heat
  3. It works only on direct current from a battery
  4. It gives only white light
Answer and explanation

Answer: B

An LED has no filament, so it stays cool and turns more of its energy into light. It needs no mercury and comes in many colours.

What does an MCB do?

  1. It records the energy used
  2. It earths the metal body of an appliance
  3. It raises the supply voltage
  4. It switches off automatically when excess current flows, and can also be switched by hand
Answer and explanation

Answer: D

An MCB is a switching device. Excess current makes an electromagnet pull its spring-loaded switch, breaking the circuit; it can also be operated manually.

Three 60 W bulbs are used for 4 hours a day for 30 days. The energy used is

  1. 21.6 kWh
  2. 7.2 kWh
  3. 720 kWh
  4. 2.16 kWh
Answer and explanation

Answer: A

Energy = 3 × 60 W × 4 h × 30 = 21 600 Wh = 21.6 kWh.

Tungsten is used for bulb filaments, but not for fuse wires, because it

  1. has a low melting point
  2. is a poor conductor
  3. has a very high melting point
  4. oxidises quickly in air
Answer and explanation

Answer: C

A filament must glow white hot without melting, so it needs a very high melting point. A fuse needs the opposite: a low melting point so it melts on excess current.

A 4 Ω resistor carries 5 A for 1 minute. The heat produced is

  1. 1200 J
  2. 6000 J
  3. 100 J
  4. 20 J
Answer and explanation

Answer: B

H = I²Rt = 25 × 4 × 60 = 6000 J.

A heater is rated 1000 W, 250 V. Its resistance is

  1. 4 Ω
  2. 0.25 Ω
  3. 250 000 Ω
  4. 62.5 Ω
Answer and explanation

Answer: D

R = V²/P = 250² ÷ 1000 = 62 500 ÷ 1000 = 62.5 Ω. (I = 4 A, and 250/4 = 62.5 Ω too.)

Two 6 Ω resistors in parallel are joined in series with a 2 Ω resistor across a 10 V battery. The current from the battery is

  1. 2 A
  2. 0.71 A
  3. 1.25 A
  4. 5 A
Answer and explanation

Answer: A

6 ∥ 6 = 3 Ω. Total = 3 + 2 = 5 Ω. I = 10 ÷ 5 = 2 A.

Two resistors give 10 Ω in series and 2.4 Ω in parallel. Their values are

  1. 5 Ω and 5 Ω
  2. 2 Ω and 8 Ω
  3. 4 Ω and 6 Ω
  4. 3 Ω and 7 Ω
Answer and explanation

Answer: C

R₁ + R₂ = 10 and R₁R₂/(R₁ + R₂) = 2.4, so R₁R₂ = 24. The numbers adding to 10 and multiplying to 24 are 4 and 6. Check: 1/4 + 1/6 = 5/12, and 12/5 = 2.4 Ω.

Three 6 Ω resistors are connected first in series and then in parallel. The ratio of series resistance to parallel resistance is

  1. 3 : 1
  2. 9 : 1
  3. 1 : 9
  4. 6 : 1
Answer and explanation

Answer: B

Series: 3 × 6 = 18 Ω. Parallel: 6/3 = 2 Ω. Ratio 18 : 2 = 9 : 1 (for n equal resistors the ratio is n²).

A material has resistivity 2 × 10⁻⁸ Ω m. Its conductivity is

  1. 2 × 10⁸ mho m⁻¹
  2. 0.5 × 10⁻⁸ mho m⁻¹
  3. 2 × 10⁻⁸ mho m⁻¹
  4. 5 × 10⁷ mho m⁻¹
Answer and explanation

Answer: D

σ = 1/ρ = 1 ÷ (2 × 10⁻⁸) = 0.5 × 10⁸ = 5 × 10⁷ mho m⁻¹.

A wire 4 m long with cross-section 2 × 10⁻⁷ m² has a resistance of 5 Ω. Its resistivity is

  1. 2.5 × 10⁻⁷ Ω m
  2. 4 × 10⁻⁷ Ω m
  3. 1 × 10⁻⁷ Ω m
  4. 1 × 10⁸ Ω m
Answer and explanation

Answer: A

ρ = RA/L = (5 × 2 × 10⁻⁷) ÷ 4 = 10 × 10⁻⁷ ÷ 4 = 2.5 × 10⁻⁷ Ω m.

A wire of resistance 12 Ω is cut into 4 equal pieces. The resistance of each piece is

  1. 48 Ω
  2. 12 Ω
  3. 3 Ω
  4. 0.75 Ω
Answer and explanation

Answer: C

R ∝ L. Each piece is a quarter of the length, so its resistance is 12/4 = 3 Ω.

Point A is at 15 V and point B at 5 V. The work done in moving 2 C of charge from B to A is

  1. 20 J
  2. 40 J
  3. 10 J
  4. 5 J
Answer and explanation

Answer: A

Potential difference = 15 − 5 = 10 V. W = QV = 2 × 10 = 20 J.

A current of 0.8 A flows in a wire. How many electrons pass a point each second?

  1. 1.28 × 10⁻¹⁹
  2. 8 × 10¹⁸
  3. 1.6 × 10¹⁹
  4. 5 × 10¹⁸
Answer and explanation

Answer: D

Charge per second = 0.8 C. Number = 0.8 ÷ 1.6 × 10⁻¹⁹ = 0.5 × 10¹⁹ = 5 × 10¹⁸.

A current of 0.25 A flows through a bulb for 2 minutes. The charge that passes is

  1. 0.5 C
  2. 30 C
  3. 480 C
  4. 0.125 C
Answer and explanation

Answer: B

Q = It = 0.25 × 120 s = 30 C. Using 2 instead of 120 seconds gives the wrong 0.5 C.

A seven segment display uses

  1. seven filament bulbs
  2. seven LEDs arranged as the figure 8, plus one for the decimal point
  3. seven fuses
  4. one LED that changes shape
Answer and explanation

Answer: B

Seven LED segments (a to g) arranged as an 8 can show any digit, and an eighth LED shows the dot.

During a short circuit

  1. the resistance becomes very large and no current flows
  2. the voltage of the supply doubles
  3. the resistance becomes very small and a very large current flows
  4. the fuse makes the current larger
Answer and explanation

Answer: C

When the live wire touches the neutral wire, the path has almost no resistance, so a huge current flows and heats the wires. The fuse or MCB then breaks the circuit.

The earth wire in a domestic circuit

  1. carries leakage current from a metal body safely to the ground, preventing shocks
  2. supplies extra power to heavy appliances
  3. replaces the neutral wire
  4. measures the energy used
Answer and explanation

Answer: A

The earth wire gives a low-resistance path from the appliance's metal body to the ground, so a fault current does not pass through a person who touches it.

A 200 W television is used for 5 hours. The energy used is

  1. 40 kWh
  2. 0.1 kWh
  3. 1000 kWh
  4. 1 kWh
Answer and explanation

Answer: D

Energy = 0.2 kW × 5 h = 1 kWh, which is 1 unit.

One kilowatt hour is equal to

  1. 1000 J
  2. 3.6 × 10⁶ J
  3. 3600 J
  4. 3.6 × 10³ kJ per second
Answer and explanation

Answer: B

1 kWh = 1000 W × 3600 s = 3 600 000 J = 3.6 × 10⁶ J.

Privacy · Terms · Refunds · Delivery