Tamil Nadu Board Class 12 Chemistry

Practice questions

Magnesium blocks are joined to an underground iron pipe. Which statement explains how this protects the pipe?

  1. Magnesium forms a coating that keeps water away from the iron.
  2. Magnesium makes the iron passive by oxidising it.
  3. Magnesium is a better electrical conductor than iron.
  4. Magnesium, with a more negative E°, is oxidised as a sacrificial anode, and the iron acts as the cathode.
Answer and explanation

Answer: D

E°(Mg²⁺/Mg) = −2.36 V is far more negative than E°(Fe²⁺/Fe) = −0.44 V, so magnesium gives up electrons first. It corrodes in place of the iron, which becomes the cathode of the cell: this is cathodic protection, and the blocks must be replaced from time to time.

While a lead storage battery is being recharged, what happens at the electrode that acted as the anode during discharge?

  1. PbSO₄ is reduced to Pb.
  2. PbSO₄ is oxidised to PbO₂.
  3. Pb is oxidised to PbSO₄.
  4. PbO₂ is reduced to PbSO₄.
Answer and explanation

Answer: A

During discharge the spongy lead anode is converted to PbSO₄. On recharging the reactions are reversed, so at that electrode (now the cathode) PbSO₄ + 2e⁻ → Pb + SO₄²⁻: PbSO₄ is reduced back to lead.

What mass of aluminium is deposited at the cathode by 9650 C in the electrolysis of a molten aluminium compound? (Al = 27 g mol⁻¹)

  1. 2.7 g
  2. 0.9 g
  3. 8.1 g
  4. 0.3 g
Answer and explanation

Answer: B

Al³⁺ + 3e⁻ → Al, n = 3. Moles of electrons = 9650 ÷ 96 500 = 0.1 mol, which deposit 0.1 ÷ 3 mol of Al. Mass = (0.1/3) × 27 = 0.9 g. Using n = 1 would give 2.7 g.

What is E at 25 °C for the cell Zn | Zn²⁺(0.01 M) || Cu²⁺(1.0 M) | Cu, given E° = 1.10 V?

  1. 1.04 V
  2. 1.10 V
  3. 1.16 V
  4. 1.13 V
Answer and explanation

Answer: C

Zn + Cu²⁺ → Zn²⁺ + Cu, n = 2. Q = [Zn²⁺]/[Cu²⁺] = 0.01/1.0 = 10⁻², log Q = −2. E = 1.10 − (0.0591/2)(−2) = 1.10 + 0.0591 = 1.159 ≈ 1.16 V. A small product concentration raises the emf above E°.

For the same reaction (n = 2, E° = 0.46 V), what is the equilibrium constant at 298 K?

  1. About 7.8 × 10⁷
  2. About 3.7 × 10¹⁵
  3. About 15.6
  4. About 1.4 × 10³¹
Answer and explanation

Answer: B

log K = nE° ÷ 0.0591 = 2 × 0.46 ÷ 0.0591 = 15.57. K = 10¹⁵·⁵⁷ = 10⁰·⁵⁷ × 10¹⁵ ≈ 3.7 × 10¹⁵. 15.6 is log K, not K.

For Cu(s) + 2Ag⁺(aq) → Cu²⁺(aq) + 2Ag(s), E° = 0.80 − 0.34 = 0.46 V. What is ΔG°?

  1. −88.8 kJ mol⁻¹
  2. −44.4 kJ mol⁻¹
  3. +88.8 kJ mol⁻¹
  4. −177.6 kJ mol⁻¹
Answer and explanation

Answer: A

Two electrons are transferred (Cu → Cu²⁺ + 2e⁻), so n = 2. ΔG° = −nFE° = −2 × 96 500 × 0.46 = −88 780 J mol⁻¹ ≈ −88.8 kJ mol⁻¹. Using n = 1 gives the wrong −44.4.

A cell is made from Pb²⁺/Pb (E° = −0.13 V) and Ag⁺/Ag (E° = +0.80 V) electrodes. Which is the correct description?

  1. Lead is the cathode; E° = 0.67 V.
  2. Silver is the anode; E° = 0.93 V.
  3. Lead is the anode; E° = 0.93 V.
  4. Lead is the anode; E° = 1.73 V.
Answer and explanation

Answer: C

The electrode with the lower reduction potential (lead) is oxidised and is the anode; Ag⁺ is reduced at the silver cathode. E° = 0.80 − (−0.13) = 0.93 V.

Which statement about the standard hydrogen electrode is correct?

  1. It can act only as a cathode.
  2. Its potential is 0 V only when used as an anode.
  3. It uses a zinc electrode in 1 M HCl.
  4. It is platinum in 1 M H⁺ with H₂ at 1 atm, assigned exactly 0 V, and can act as anode or cathode.
Answer and explanation

Answer: D

The SHE is a platinum electrode in 1 M acid with hydrogen gas at 1 atm, assigned E° = 0 V by convention. Depending on the other electrode it can be the anode (H₂ → 2H⁺ + 2e⁻) or the cathode (2H⁺ + 2e⁻ → H₂).

Given E°(Fe³⁺/Fe²⁺) = +0.77 V and E°(I₂/I⁻) = +0.54 V, will Fe³⁺ ions oxidise iodide ions under standard conditions?

  1. Yes, E° for 2Fe³⁺ + 2I⁻ → 2Fe²⁺ + I₂ is +0.23 V.
  2. No, E° for the reaction is −0.23 V.
  3. Yes, E° for the reaction is +1.31 V.
  4. No, because both potentials are positive.
Answer and explanation

Answer: A

Fe³⁺ is reduced (cathode) and I⁻ oxidised (anode): E° = E°(cathode) − E°(anode) = 0.77 − 0.54 = +0.23 V. A positive E° means the reaction is spontaneous, so Fe³⁺ oxidises I⁻ to iodine.

According to the Debye-Huckel picture, why does Λm of a strong electrolyte fall as its concentration rises?

  1. The electrolyte dissociates less at higher concentration.
  2. Each ion's ionic atmosphere of opposite charge drags on it more when ions are crowded.
  3. The solvent's dielectric constant rises with concentration.
  4. Electrons in the solution are slowed down.
Answer and explanation

Answer: B

Strong electrolytes are fully dissociated, so the fall is not due to less dissociation. Each ion is surrounded by an atmosphere of oppositely charged ions; the closer the ions, the stronger this drag, giving Λm = Λ°m − (A + BΛ°m)√C.

A 0.02 M solution of HX has Λm = 8.0 S cm² mol⁻¹, and Λ°m = 400 S cm² mol⁻¹. What is Ka of HX?

  1. 4.0 × 10⁻⁴
  2. 8.2 × 10⁻⁶
  3. 1.6 × 10⁻⁷
  4. 2.0 × 10⁻²
Answer and explanation

Answer: B

α = 8.0 ÷ 400 = 0.02. Ka = α²C ÷ (1 − α) = (0.02)² × 0.02 ÷ 0.98 = 8.0 × 10⁻⁶ ÷ 0.98 = 8.2 × 10⁻⁶. The same result comes from CΛm² ÷ [Λ°m(Λ°m − Λm)] = 0.02 × 64 ÷ (400 × 392) = 8.2 × 10⁻⁶.

Given Λ°m (S cm² mol⁻¹): HCl 426, NaCl 126 and NaX 100, what is Λ°m of the weak acid HX?

  1. 652
  2. 200
  3. 452
  4. 400
Answer and explanation

Answer: D

Λ°m(HX) = Λ°m(NaX) + Λ°m(HCl) − Λ°m(NaCl) = 100 + 426 − 126 = 400 S cm² mol⁻¹.

On diluting a solution of KCl, what happens to its conductivity (κ) and its molar conductance (Λm)?

  1. Both increase.
  2. κ decreases but Λm increases.
  3. κ increases but Λm decreases.
  4. Both decrease.
Answer and explanation

Answer: B

κ is the conductance of a fixed volume, and dilution leaves fewer ions in it, so κ falls. Λm refers to one mole of electrolyte, and on dilution the ions interact less and move more freely, so Λm rises.

The same cell (l/A = 70 m⁻¹) filled with a 0.005 M solution of an electrolyte shows R = 1000 Ω. What is the molar conductance of this solution?

  1. 1.4 × 10⁻² S m² mol⁻¹
  2. 7.0 × 10⁻² S m² mol⁻¹
  3. 14 S m² mol⁻¹
  4. 1.4 × 10⁻⁵ S m² mol⁻¹
Answer and explanation

Answer: A

κ = (l/A) ÷ R = 70 ÷ 1000 = 0.070 S m⁻¹. Λm = κ × 10⁻³ ÷ M = 0.070 × 10⁻³ ÷ 0.005 = 1.4 × 10⁻² S m² mol⁻¹.

A conductivity cell filled with a KCl solution of κ = 0.14 S m⁻¹ has a resistance of 500 Ω. What is the cell constant?

  1. 0.00028 m⁻¹
  2. 3571 m⁻¹
  3. 70 m⁻¹
  4. 7.0 m⁻¹
Answer and explanation

Answer: C

κ = (1/R)(l/A), so l/A = κ × R = 0.14 S m⁻¹ × 500 Ω = 70 m⁻¹.

Why does a zinc coating protect iron even after the coating is scratched?

  1. Zinc has a higher melting point than iron.
  2. Zinc has a more negative reduction potential, so it is oxidised in preference to iron.
  3. Zinc is a better conductor of electricity than iron.
  4. Zinc forms an alloy with the iron.
Answer and explanation

Answer: B

E°(Zn²⁺/Zn) = −0.76 V is more negative than E°(Fe²⁺/Fe) = −0.44 V, so zinc is the stronger reducing agent and corrodes first, acting as a sacrificial anode while iron stays as the cathode.

What is the reaction at the cathode of the hydrogen-oxygen fuel cell?

  1. 2H₂ + 4OH⁻ → 4H₂O + 4e⁻
  2. H⁺ + OH⁻ → H₂O
  3. O₂ + 2H₂O + 4e⁻ → 4OH⁻
  4. 2H₂ + O₂ → 2H₂O
Answer and explanation

Answer: C

Reduction happens at the cathode: oxygen gains electrons and, in alkaline KOH, forms hydroxide ions. The first equation is the anode reaction and the last is the overall reaction.

Which of these is a secondary (rechargeable) battery?

  1. Lead storage battery
  2. Leclanche cell
  3. Mercury button cell
  4. Hydrogen-oxygen fuel cell
Answer and explanation

Answer: A

In the lead storage battery the discharge reaction can be reversed by applying more than 2 V, regenerating Pb, PbO₂ and H₂SO₄. Leclanche and mercury cells are primary cells, and a fuel cell is not recharged: it is fed with fuel continuously.

What mass of silver is deposited when 0.5 A passes through AgNO₃ solution for 32 minutes 10 seconds? (Ag = 108 g mol⁻¹)

  1. 0.54 g
  2. 1.08 g
  3. 2.16 g
  4. 0.27 g
Answer and explanation

Answer: B

t = 32 × 60 + 10 = 1930 s; Q = 0.5 × 1930 = 965 C = 965 ÷ 96 500 = 0.01 F. Ag⁺ + e⁻ → Ag needs 1 F per mole, so 0.01 mol Ag = 0.01 × 108 = 1.08 g.

In the electrolysis of molten NaCl, what is formed at the cathode?

  1. Chlorine gas
  2. Hydrogen gas
  3. Oxygen gas
  4. Liquid sodium
Answer and explanation

Answer: D

The cathode is joined to the negative terminal; Na⁺ ions are attracted to it and reduced: Na⁺ + e⁻ → Na(l). Chlorine is formed at the anode. With no water present, no hydrogen or oxygen forms.

Privacy · Terms · Refunds · Delivery