Unit 2 Current Electricity

Practice questions

When a current is passed through a copper-iron thermocouple with both junctions at the same temperature, one junction becomes hot and the other cold. This is the:

  1. Seebeck effect
  2. Thomson effect
  3. Peltier effect
  4. Joule effect
Answer and explanation

Answer: C

Heat being evolved at one junction and absorbed at the other when a current passes is the Peltier effect, and reversing the current swaps the hot and cold junctions. Joule heating would warm both and does not reverse.

A 1000 W immersion heater is used to heat 2.0 kg of water from 30 °C to 80 °C (s = 4200 J kg⁻¹ K⁻¹). Assuming no heat loss, the time taken is:

  1. 420 s
  2. 4.2 s
  3. 210 s
  4. 840 s
Answer and explanation

Answer: A

Q = msΔT = 2.0 × 4200 × 50 = 4.2 × 10⁵ J. t = Q/P = 4.2 × 10⁵/1000 = 420 s (7 minutes).

A potentiometer is preferred to a voltmeter for measuring the emf of a cell because:

  1. it has a lower resistance
  2. it uses a stronger battery
  3. it can measure only small voltages
  4. at balance it draws no current from the cell
Answer and explanation

Answer: D

A voltmeter draws some current, so it reads the terminal voltage ε − Ir, slightly less than ε. At the balance point a potentiometer draws no current, so it measures the emf itself.

In a meter bridge with 20 Ω in the right gap, the balance point is at 60 cm from the left. If the two resistances are interchanged, the new balance point is at:

  1. 60 cm
  2. 50 cm
  3. 40 cm
  4. 30 cm
Answer and explanation

Answer: C

First P = 20 × 60/40 = 30 Ω. After interchanging, 20/30 = l/(100 − l), so 2(100 − l) = 3l, 200 = 5l, l = 40 cm. Interchanging simply swaps l₁ and l₂.

In a Wheatstone network P = 300 Ω, Q = 200 Ω, S = 400 Ω, and the arm R is an unknown resistance x in series with 150 Ω. The bridge is balanced when x is:

  1. 600 Ω
  2. 450 Ω
  3. 150 Ω
  4. 267 Ω
Answer and explanation

Answer: B

P/Q = R/S gives R = PS/Q = 300 × 400/200 = 600 Ω. Since R = x + 150, x = 450 Ω.

In a closed loop, going through a cell from its positive terminal to its negative terminal, the emf term in Kirchhoff's voltage rule is taken as:

  1. +ε
  2. −ε
  3. zero
  4. +IR
Answer and explanation

Answer: B

By the sign rule, going from − to + through a cell counts +ε, and going from + to − counts −ε.

A cell of emf 12 V delivers 2.0 A to an external resistor, and its terminal voltage is 11 V. The power wasted inside the cell is:

  1. 24 W
  2. 22 W
  3. 4 W
  4. 2 W
Answer and explanation

Answer: D

Ir = ε − V = 1 V, so r = 0.5 Ω. Power lost inside = I²r = 4 × 0.5 = 2 W (equivalently Iε − IV = 24 − 22 = 2 W).

Six cells, each of emf 1.5 V and internal resistance 0.5 Ω, are in series with an external 6 Ω resistor. The current is:

  1. 1.0 A
  2. 1.5 A
  3. 0.25 A
  4. 9 A
Answer and explanation

Answer: A

Total emf = 6 × 1.5 = 9 V; total resistance = 6 × 0.5 + 6 = 9 Ω; I = 9/9 = 1.0 A.

One third of the length of a heater coil is cut off and the rest is used on the same supply voltage. The new power compared with the old is:

  1. the same
  2. 2/3 times
  3. 9/4 times
  4. 3/2 times
Answer and explanation

Answer: D

R ∝ length, so the new resistance is (2/3)R. With V fixed, P = V²/R, so P_new/P_old = R/((2/3)R) = 3/2. A shorter coil draws more current and gives more power.

The resistance of a coil is 40 Ω at 20 °C and 44 Ω at 45 °C. Its temperature coefficient of resistance is:

  1. 0.1 (°C)⁻¹
  2. 4 × 10⁻³ (°C)⁻¹
  3. 2.2 × 10⁻³ (°C)⁻¹
  4. 1.6 × 10⁻² (°C)⁻¹
Answer and explanation

Answer: B

α = ΔR/(R₀ΔT) = (44 − 40)/(40 × 25) = 4/1000 = 4 × 10⁻³ (°C)⁻¹.

A carbon resistor of (330 ± 33) Ω is marked with which colour sequence?

  1. Orange, orange, brown, silver
  2. Orange, orange, red, silver
  3. Orange, orange, brown, gold
  4. Red, red, brown, silver
Answer and explanation

Answer: A

330 Ω = 33 × 10¹: orange (3), orange (3), brown (multiplier 10¹). The tolerance 33/330 = 10% is silver. Orange, orange, red would be 3.3 kΩ, and gold would mean 5%.

A wire of resistance R is cut into four equal pieces, which are then connected in parallel. The resistance of the combination is:

  1. R/4
  2. 4R
  3. R
  4. R/16
Answer and explanation

Answer: D

Each piece has R/4. Four equal resistances R/4 in parallel give (R/4)/4 = R/16.

Which statement is correct?

  1. Current density is a scalar and current is a vector
  2. Both current and current density are vectors
  3. Current is a scalar and current density is a vector
  4. Both are scalars
Answer and explanation

Answer: C

Current density J⃗ = nev⃗_d has a direction at each point. Current is I = J⃗·A⃗, a scalar product, so it is a scalar.

In the relation J = σE, the conductivity σ of a metal is:

  1. m/(ne²τ)
  2. ne²τ/m
  3. eτ/m
  4. neτ/m
Answer and explanation

Answer: B

v_d = eEτ/m and J = nev_d give J = (ne²τ/m)E, so σ = ne²τ/m. Its reciprocal m/(ne²τ) is the resistivity, and eτ/m is the mobility.

A wire of cross-section 2.0 mm² carries 3.2 A. The free-electron density is 1.0 × 10²⁹ m⁻³. The drift speed of the electrons is:

  1. 1.0 × 10⁻⁴ m s⁻¹
  2. 2.0 × 10⁻⁴ m s⁻¹
  3. 1.0 × 10⁻² m s⁻¹
  4. 1.6 × 10⁻⁴ m s⁻¹
Answer and explanation

Answer: A

v_d = I/(neA) = 3.2/(1.0 × 10²⁹ × 1.6 × 10⁻¹⁹ × 2.0 × 10⁻⁶) = 3.2/(3.2 × 10⁴) = 1.0 × 10⁻⁴ m s⁻¹.

When the two junctions of a copper-iron circuit are kept at different temperatures, a current flows in it. This is the:

  1. Seebeck effect
  2. Peltier effect
  3. Thomson effect
  4. Joule effect
Answer and explanation

Answer: A

An emf produced by a temperature difference between two junctions of dissimilar metals is the Seebeck effect, the principle of the thermocouple. The Peltier effect is the reverse: a current producing heating and cooling at the junctions.

Nichrome is used for the heating elements of electric irons because it:

  1. has a low resistivity and melts easily
  2. is a superconductor
  3. has a high resistivity and does not oxidise easily when red hot
  4. has a negative temperature coefficient
Answer and explanation

Answer: C

A heating element needs a high resistivity (so a manageable length gives enough resistance) and must stand high temperatures without oxidising. Nichrome has both properties.

If the current through a heater coil is doubled, keeping its resistance the same, the heat produced in the same time becomes:

  1. twice
  2. half
  3. the same
  4. four times
Answer and explanation

Answer: D

H = I²Rt, so H ∝ I². Doubling I multiplies H by 2² = 4.

A cell balances at 150 cm on open circuit and at 125 cm when a 10 Ω resistance is connected across it. Its internal resistance is:

  1. 2 Ω
  2. 12 Ω
  3. 0.5 Ω
  4. 8.3 Ω
Answer and explanation

Answer: A

r = R(l₁ − l₂)/l₂ = 10 × (150 − 125)/125 = 10 × 25/125 = 2 Ω.

On a potentiometer wire, a cell of emf 1.2 V balances at 240 cm. A second cell balances at 300 cm. Its emf is:

  1. 0.96 V
  2. 1.5 V
  3. 1.2 V
  4. 2.0 V
Answer and explanation

Answer: B

ε₂/ε₁ = l₂/l₁, so ε₂ = 1.2 × 300/240 = 1.5 V.

Privacy · Terms · Refunds · Delivery