Unit 5 Magnetism and Electromagnetism
Practice questions
In a loudspeaker, what makes the cone vibrate?
- A heating element
- A coil whose changing magnetic field is pushed and pulled by a permanent magnet
- A transformer core
- Air pressure from the room
Answer and explanation
Answer: B
The changing signal current keeps reversing the field of the coil attached to the cone, so the fixed permanent magnet alternately attracts and repels it, making the cone vibrate and produce sound.
An ideal transformer steps 220 V down to 11 V. If the secondary current is 4 A, what is the primary current?
- 80 A
- 2 A
- 0.2 A
- 4 A
Answer and explanation
Answer: C
Turns ratio Ns/Np = 11/220 = 1/20. Ip = Is × Ns/Np = 4 ÷ 20 = 0.2 A. Stepping voltage down steps current up, so the primary current is smaller.
What change turns an ac generator into a dc generator?
- Replacing the slip rings with a split-ring commutator
- Using a stronger magnet
- Removing the brushes
- Adding more turns
Answer and explanation
Answer: A
With a split-ring commutator the connections to the outer circuit swap every half turn, so the output current always flows in the same direction.
According to Lenz's law, the induced current
- always flows clockwise
- helps the change that causes it
- is always zero
- opposes the change that causes it
Answer and explanation
Answer: D
Lenz's law says the induced current flows so as to oppose the change in flux producing it. For example, a north pole pushed into a coil makes a north pole at that end of the coil, which repels it.
A magnet is pushed into a coil connected to a galvanometer, first slowly and then quickly. What do you observe?
- No deflection either time
- Same deflection both times
- A larger deflection when it is pushed quickly
- A larger deflection when it is pushed slowly
Answer and explanation
Answer: C
The induced e.m.f. is proportional to the rate of change of flux. Pushing the magnet in quickly changes the flux faster, giving a larger deflection.
Why does a coil in a motor without a commutator only rock to and fro instead of turning continuously?
- The magnet is too weak
- The forces reverse their turning effect after each half turn because the current in the coil does not reverse
- The coil has too many turns
- There is no current in the coil
Answer and explanation
Answer: B
After half a turn each side of the coil has swapped places. Unless the current in the coil reverses, the forces now turn it back. The split-ring commutator reverses the current each half turn to keep it rotating.
Two parallel wires carry currents in opposite directions. What happens?
- They attract
- They repel
- They feel no force
- Only one wire feels a force
Answer and explanation
Answer: B
Parallel currents in opposite directions repel each other; in the same direction they attract. The forces on the two wires are equal and opposite.
Fleming's left-hand rule is used in which device?
- Transformer
- ac generator
- Electric motor
- Compass
Answer and explanation
Answer: C
The left-hand (motor) rule gives the direction of the force on a current in a magnetic field, which is how a motor turns. Generators use the right-hand rule.
A wire 20 cm long carrying 2.5 A lies at right angles to a field of 0.8 T. What is the force on it?
- 0.4 N
- 40 N
- 4 N
- 0.04 N
Answer and explanation
Answer: A
F = ILB = 2.5 × 0.2 × 0.8 = 0.4 N. Using 20 instead of 0.2 m gives 40, a hundred times too large.
What did Oersted's experiment show?
- A changing magnetic field produces current
- A current-carrying conductor produces a magnetic field around it
- Magnets lose their magnetism when heated
- Like poles attract
Answer and explanation
Answer: B
Oersted saw a compass needle deflect near a current-carrying wire, showing that current produces a magnetic field. Producing current from a changing field was Faraday's later discovery.
Which of these does NOT affect the strength of the magnetic field at a point near a straight current-carrying wire?
- The current in the wire
- The distance of the point from the wire
- The magnetic nature of the medium
- The colour of the wire's insulation
Answer and explanation
Answer: D
The field depends on the current, the distance and orientation of the point and the medium. The colour of the insulation has no effect.
A vertical wire carries current downward. Seen from above, the magnetic field lines around it are
- clockwise circles
- anticlockwise circles
- straight lines pointing north
- absent
Answer and explanation
Answer: A
Right-hand thumb rule: thumb pointing down (away from an eye above). The fingers then curl clockwise as seen from above.
Which pair is correctly matched?
- Magnetic material: wood
- Non-magnetic material: iron
- Current and magnetism: Faraday
- Electromagnetic induction: Faraday
Answer and explanation
Answer: D
Faraday discovered electromagnetic induction in 1831. Iron is magnetic, wood is non-magnetic, and the link between current and magnetism was first shown by Oersted.
A uniform field of 0.4 T passes normally through a coil of area 25 cm². What is the flux through it?
- 10 Wb
- 1 × 10⁻³ Wb
- 0.1 Wb
- 1.6 × 10⁻² Wb
Answer and explanation
Answer: B
Area = 25 cm² = 25 × 10⁻⁴ m² = 2.5 × 10⁻³ m². ϕ = B × A = 0.4 × 2.5 × 10⁻³ = 1 × 10⁻³ Wb. Forgetting to convert cm² to m² gives 10.
Which statement about magnetic field lines is FALSE?
- They are closed continuous curves
- They never intersect
- They run from S to N outside the magnet
- They are crowded near the poles
Answer and explanation
Answer: C
Outside a magnet field lines run from N to S, not S to N. The other statements (closed curves, never intersecting, crowded at the poles where the field is strongest) are all true.
A radio built to run on 6 V has a transformer so it can be used from the 220 V mains. What kind is it?
- Step-up, because the radio needs more current
- Step-up, because 6 V is more than 220 V
- No transformer can do this
- Step-down, because it lowers 220 V to about 6 V
Answer and explanation
Answer: D
The transformer must reduce the mains voltage to the much lower voltage the radio needs, so it is a step-down transformer with fewer turns in the secondary.
In a step-down transformer,
- the secondary has more turns than the primary
- the primary has more turns than the secondary
- both coils have the same number of turns
- there is no secondary coil
Answer and explanation
Answer: B
To lower the voltage, the secondary must have fewer turns than the primary (Ns < Np), since Vs/Vp = Ns/Np.
A transformer's primary has 800 turns and its secondary 8 turns. It is connected to 220 V ac. What is the output voltage?
- 22 000 V
- 22 V
- 2.2 V
- 0.22 V
Answer and explanation
Answer: C
Vs = Vp × Ns/Np = 220 × 8/800 = 220 ÷ 100 = 2.2 V.
A transformer works on
- ac only
- dc only
- both ac and dc
- neither ac nor dc
Answer and explanation
Answer: A
Induction needs a changing flux. Only ac in the primary produces a changing flux; a steady dc gives no induced e.m.f. in the secondary.
Which part of an ac generator passes the current from the armature coil to the external circuit?
- Field magnet
- Split ring
- Iron core
- Brushes
Answer and explanation
Answer: D
In an ac generator the slip rings turn with the coil, and the fixed brushes pressing on them carry the current out to the external circuit.