• Foundation
  • About 25 min
  • 5 practice questions

Phases of growth, growth rates and conditions for growth

Describe the meristematic, elongation and maturation phases, use the arithmetic and exponential growth equations, interpret the sigmoid curve, and compare absolute and relative growth rates.

If something looks wrong, please tell us.

By the end of this lesson you can

  • Describe the three phases of growth at a root or shoot tip.
  • Use Lt = L₀ + rt and W₁ = W₀eʳᵗ in calculations.
  • Explain the lag, exponential and stationary phases of a sigmoid curve.
  • Calculate absolute and relative growth rates.
  • List the conditions needed for growth.

Three phases of growth

Phases of growth behind a root tip

  1. Meristematic phase At the apex. Constantly dividing cells; dense protoplasm, large nuclei, thin cellulose primary walls, many plasmodesmata.
  2. Elongation phase Just behind it. Increased vacuolation, cell enlargement and new cell wall deposition.
  3. Maturation phase Further back. Cells reach maximum size, with wall thickening and protoplasmic changes.

A simple way to find the zone of elongation is the parallel line technique: mark a young root with evenly spaced lines and look again after a day. The lines just behind the apex move apart the most, showing that this is where cells elongate.

Growth rate: arithmetic and geometric

Growth rate is the increase in growth per unit time. Cells can be added in two ways.

  • Arithmetic growth: after mitosis, only one daughter cell keeps dividing while the other differentiates and matures. A root elongating at a constant rate is the simplest example. Length plotted against time gives a straight line.
  • Geometric growth: both daughter cells keep dividing. Growth is slow at first (lag phase), then rapid and exponential (log or exponential phase). With limited nutrients it slows to a stationary phase. Plotting size against time gives an S-shaped sigmoid curve, typical of cells, tissues and organs growing in a natural environment.

Arithmetic: Lt = L₀ + rt, where L₀ = length at time zero, Lt = length at time t, r = growth rate (elongation per unit time). Exponential: W₁ = W₀eʳᵗ, where W₀ = initial size, W₁ = final size, r = relative growth rate, t = time, e = base of natural logarithms (≈ 2.718).

In the exponential equation, r is the relative growth rate, a measure of the plant's ability to produce new material, also called the efficiency index. Because W₁ depends on W₀, a larger starting size gives a larger final size for the same r and t.

Phases of a sigmoid growth curve

  1. Lag phase Slow initial growth.
  2. Exponential (log) phase Rapid growth; both daughter cells divide.
  3. Stationary phase Growth slows and stops as nutrients become limiting.

Worked example 1: arithmetic growth

A root is 3.0 cm long and elongates at a constant 0.8 cm per day. How long is it after 5 days? Given: L₀ = 3.0 cm, r = 0.8 cm day⁻¹, t = 5 days. Step 1: rt = 0.8 × 5 = 4.0 cm. Step 2: Lt = L₀ + rt = 3.0 + 4.0 = 7.0 cm. A plot of length against days is a straight line with slope 0.8.

Worked example 2: exponential growth

A culture of plant cells weighs 2 g and grows exponentially with r = 0.1 per day. What is its weight after 10 days? Step 1: rt = 0.1 × 10 = 1. Step 2: W₁ = W₀eʳᵗ = 2 × e¹ = 2 × 2.718 ≈ 5.44 g. Note that the weight does not simply grow by a fixed amount each day; each day's gain is larger than the last.

Absolute and relative growth rate

Absolute growth rate is the total growth per unit time. Relative growth rate is the growth per unit time expressed on a common basis, for example per unit of initial size.

Worked example 3: two leaves

Leaf A grows from 5 cm² to 10 cm² and leaf B from 50 cm² to 55 cm² in the same time. Absolute growth: both increased by 5 cm², so the absolute rates are equal. Relative growth: A: 5 ÷ 5 = 1.0, i.e. 100% of its initial area; B: 5 ÷ 50 = 0.1, i.e. 10%. Conclusion: leaf A has ten times the relative growth rate of leaf B.

Conditions for growth

What a plant needs to grow
ConditionWhy it is needed
WaterCells enlarge by taking up water; turgidity drives extension growth; water is the medium for enzymes
OxygenReleases metabolic energy through respiration
NutrientsMacro- and micronutrients build protoplasm and act as an energy source
Optimum temperatureEach plant has a best range; going outside it can be harmful
Light and gravityEnvironmental signals that affect certain stages of growth

Key takeaways: growth passes through meristematic, elongation and maturation phases. Arithmetic growth is linear (Lt = L₀ + rt); geometric growth is exponential (W₁ = W₀eʳᵗ) and, in nature, levels off to give a sigmoid curve with lag, log and stationary phases. Absolute growth rate compares total increase; relative growth rate compares increase per unit initial size. Water, oxygen, nutrients, suitable temperature, light and gravity all influence growth.

Check your understanding

  1. 1. Cells with increased vacuolation, cell enlargement and new cell wall deposition belong to which phase of growth?

    1. Meristematic
    2. Maturation
    3. Elongation
    4. Senescence
    Show answer

    Answer: C. These are the features of the elongation phase, just behind the meristematic zone. Meristematic cells are small with dense protoplasm; mature cells have reached maximum size.

  2. 2. A shoot 12 cm long grows arithmetically at 1.5 cm per day. What will its length be after 6 days?

    1. 21 cm
    2. 18 cm
    3. 19.5 cm
    4. 13.5 cm
    Show answer

    Answer: A. Lt = L₀ + rt = 12 + 1.5 × 6 = 12 + 9 = 21 cm.

  3. 3. In a sigmoid growth curve, the phase in which growth is fastest is the

    1. lag phase
    2. stationary phase
    3. phase of senescence
    4. exponential (log) phase
    Show answer

    Answer: D. Growth is slow in the lag phase, fastest in the exponential phase when all cells divide, and levels off in the stationary phase.

  4. 4. Leaf P grows from 10 cm² to 12 cm² and leaf Q from 40 cm² to 42 cm² in the same period. Which statement is correct?

    1. P has the higher absolute growth rate
    2. P has the higher relative growth rate
    3. Q has the higher relative growth rate
    4. Their relative growth rates are equal
    Show answer

    Answer: B. Both gained 2 cm², so absolute rates are equal. Relative: P = 2 ÷ 10 = 0.2 (20%); Q = 2 ÷ 40 = 0.05 (5%). P has the higher relative growth rate.

  5. 5. Assertion (A): In arithmetic growth, a graph of length against time is a straight line.
    Reason (R): In arithmetic growth, both daughter cells continue to divide after every mitosis.

    1. Both A and R are true, and R is the correct explanation of A
    2. Both A and R are true, but R is not the correct explanation of A
    3. A is true, but R is false
    4. A is false, but R is true
    Show answer

    Answer: C. A is true: Lt = L₀ + rt is a linear equation. R is false: in arithmetic growth only one daughter cell keeps dividing; both dividing describes geometric growth.

Privacy · Terms · Refunds · Delivery