• Foundation
  • About 16 min
  • 5 practice questions

Evaporation and condensation: how vapour is added and removed

Explain evaporation and latent heat of vaporisation, the factors that speed evaporation, how and when condensation happens around hygroscopic nuclei, and how forms of condensation are classified.

If something looks wrong, please tell us.

By the end of this lesson you can

  • Explain evaporation, latent heat of vaporisation and the factors that increase evaporation.
  • Explain condensation, the role of hygroscopic nuclei, and the conditions under which it occurs.
  • Classify the forms of condensation by temperature and by location.

The amount of water vapour in the atmosphere is added by evaporation and withdrawn by condensation. These two opposite processes control humidity, cloud and rain, and they also move huge amounts of heat.

Evaporation

Evaporation is the process by which water changes from the liquid to the gaseous state. Heat is the main cause of evaporation. The latent heat of vaporisation is the amount of heat energy required to convert a unit mass of a liquid into vapour without a change in temperature. This heat is not lost: it is stored in the vapour and released again when the vapour condenses (recall the 19 units of latent heat in the heat budget, Chapter 8).

Three things increase evaporation:

  • Higher temperature: warmer air has a greater capacity to absorb and retain moisture.
  • Dry air: if the moisture content is low, the air can absorb and retain more moisture.
  • Moving air: wind replaces the saturated layer above the water with unsaturated air, so the greater the movement of air, the greater the evaporation.

Condensation

Condensation is the transformation of water vapour into water. It is caused by the loss of heat. When moist air is cooled, it may reach a level at which its capacity to hold water vapour is used up; the excess vapour then condenses into liquid. In free air, condensation happens by cooling around very small particles called hygroscopic condensation nuclei. Dust, smoke and salt from the ocean are particularly good nuclei because they absorb water.

Condensation also takes place when moist air touches a colder object, and when the temperature is close to the dew point. So condensation depends on the amount of cooling and the relative humidity of the air. It is influenced by the volume of air, temperature, pressure and humidity. Condensation takes place:

  1. when the temperature of the air is reduced to the dew point with its volume remaining constant;
  2. when both the volume and the temperature are reduced;
  3. when moisture is added to the air through evaporation.

Of these, the most favourable condition for condensation is a decrease in air temperature.

Evaporation adds vapour and stores heat (latent heat of vaporisation); condensation removes vapour and releases that heat. Condensation needs cooling to the dew point and, in free air, hygroscopic nuclei such as dust, smoke and sea salt.

From moist air to condensed water

  1. Moist air Contains water vapour below saturation.
  2. Cooling Temperature falls (the most favourable condition).
  3. Dew point reached Air becomes saturated: relative humidity 100 per cent.
  4. Nuclei or a cold surface Vapour collects on dust, smoke, salt or a cold object.
  5. Condensation Droplets or ice crystals form: dew, frost, fog or cloud.

Forms of condensation

After condensation, moisture in the atmosphere takes one of these forms: dew, frost, fog and clouds. They can be classified on the basis of temperature and location. Condensation can take place when the dew point is higher than the freezing point (giving water droplets) and also when it is lower than the freezing point (giving ice crystals).

Forms of condensation classified by location

  • On cold solid surfaces
    • Dew: dew point above freezing
    • Frost: dew point at or below freezing
  • In the air at or near the ground
    • Fog: visibility below 1 km
    • Mist: visibility 1 to 2 km
  • In free air at considerable height
    • Clouds: droplets or ice crystals around nuclei

Worked example 1: which pan dries first?

Three identical pans of water are left out (a made-up experiment): pan X in a warm, windy, dry courtyard; pan Y in a warm, still, humid room; pan Z in a cool, still, humid shed. Rank their evaporation. Working: X has all three helpers (heat, dry air, moving air), so it evaporates fastest. Y has heat but humid still air, so it is slower. Z lacks all three, so it is slowest. Order: X, then Y, then Z.

Worked example 2: why sea air makes clouds easily

Explain why fog and cloud form readily in coastal air. Reasoning: (1) sea air is moist, so its relative humidity is high and only a little cooling brings it to the dew point; (2) it carries tiny salt particles from the ocean, which are excellent hygroscopic nuclei because they absorb water; (3) with both moisture and nuclei present, a small fall in temperature produces condensation.

Worked example 3: identifying the condition

Match each case to the condition for condensation. (a) Still night air cools to its dew point while its volume stays the same: condition 1. (b) A lake adds vapour to cool, nearly saturated air above it until it can hold no more: condition 3, moisture added through evaporation. In both cases the air ends up saturated; the difference is whether its capacity fell (cooling) or its vapour content rose (evaporation).

Key takeaways: evaporation turns liquid into vapour, driven by heat and speeded by warmth, dry air and wind; the latent heat of vaporisation is stored in the vapour. Condensation turns vapour into water through loss of heat, around hygroscopic nuclei (dust, smoke, sea salt) or on cold surfaces; a fall in temperature is the most favourable condition. Its forms are dew, frost, fog and clouds, classified by temperature (dew point above or below freezing) and location.

Check your understanding

  1. 1. The heat needed to change a unit mass of liquid into vapour without changing its temperature is called:

    1. specific heat
    2. latent heat of vaporisation
    3. terrestrial radiation
    4. adiabatic heat
    Show answer

    Answer: B. The latent heat of vaporisation is the heat energy required to convert a unit mass of a liquid into vapour without a change in temperature.

  2. 2. Which change would INCREASE the rate of evaporation from a lake?

    1. Calmer air above it
    2. Cooler air temperature
    3. Stronger wind over its surface
    4. More humid air above it
    Show answer

    Answer: C. Moving air replaces the saturated layer above the water with unsaturated air, so the greater the movement of air, the greater the evaporation. The other changes reduce evaporation.

  3. 3. Particles of dust, smoke and sea salt help condensation because they:

    1. are hygroscopic and absorb water
    2. raise the air temperature
    3. reflect sunlight
    4. add oxygen to the air
    Show answer

    Answer: A. They act as hygroscopic condensation nuclei: they absorb water, so vapour condenses around them in free air.

  4. 4. Assertion (A): The most favourable condition for condensation is a decrease in air temperature. Reason (R): Cooling reduces the capacity of air to hold water vapour, bringing it to saturation.

    1. Both A and R are true, and R is the correct explanation of A
    2. Both A and R are true, but R is not the correct explanation of A
    3. A is true, but R is false
    4. A is false, but R is true
    Show answer

    Answer: A. Both are true and R explains A: as air cools its capacity falls; at the dew point it is saturated, and further cooling forces the excess vapour to condense.

  5. 5. Read the case: In winter, a cold glass taken out of a refrigerator becomes covered with tiny droplets in a warm, humid room. What has happened?

    1. Water seeped through the glass
    2. Evaporation from the glass surface
    3. Precipitation from a cloud in the room
    4. Moist air touching the cold glass cooled below its dew point and condensed
    Show answer

    Answer: D. Condensation takes place when moist air comes in contact with a colder object: the air next to the glass is cooled below its dew point and the excess vapour condenses as droplets, just as dew forms on cold grass.

Sign in to keep track of the lessons you finish.

Next lesson → Dew, frost, fog, mist and smog

Privacy · Terms · Refunds · Delivery