• Practice
  • About 25 min
  • 15 practice questions

Final self-assessment: Introduction to computer practice

Test yourself on the whole course: 15 questions with answers explained.

If something looks wrong, please tell us.

Attempt all 15 questions in one timed sitting of about 25 minutes, writing the working for every conversion. These questions mix ideas from the five lessons and include the traps discussed in them. Check your answers only when you have finished, and read each explanation.

Final self-assessment

  1. 1. Which list goes from the largest unit of time to the smallest?

    1. Nanosecond, microsecond, millisecond, picosecond
    2. Millisecond, microsecond, nanosecond, picosecond
    3. Picosecond, nanosecond, microsecond, millisecond
    4. Microsecond, millisecond, picosecond, nanosecond
    Show answer

    Answer: B. A millisecond is a thousandth of a second, a microsecond a millionth, a nanosecond a thousand-millionth and a picosecond a million-millionth. Each is a thousand times smaller than the one before.

  2. 2. A research centre must run one enormous weather simulation as fast as possible. Which type of computer suits it best?

    1. Supercomputer
    2. Mainframe
    3. Minicomputer
    4. Microcomputer
    Show answer

    Answer: A. Supercomputers are built for raw speed on huge scientific calculations. A mainframe is built to serve many users and transactions at once, which is not what this job needs.

  3. 3. Which statement is correct?

    1. 'COMPUTER' is an official acronym
    2. A computer can work without any instructions
    3. Wrong output usually comes from wrong input or wrong instructions
    4. Analog computers work only with 0s and 1s
    Show answer

    Answer: C. This is the GIGO idea: the computer processes exactly what it is given. 'Computer' comes from 'compute' and is not an acronym, every computer needs instructions, and it is digital computers that use 0s and 1s.

  4. 4. Which list puts the technologies in the order in which they were used?

    1. Transistor, vacuum tube, IC, microprocessor
    2. Vacuum tube, transistor, IC, microprocessor
    3. Vacuum tube, IC, transistor, microprocessor
    4. IC, transistor, vacuum tube, microprocessor
    Show answer

    Answer: B. First generation vacuum tubes, second transistors, third integrated circuits, fourth microprocessors.

  5. 5. Which machine used punched cards to process census data?

    1. Pascaline
    2. Napier's bones
    3. Hollerith's tabulating machine
    4. Slide rule
    Show answer

    Answer: C. Herman Hollerith built a tabulating machine that read punched cards to count census data. The Pascaline, Napier's bones and the slide rule were calculating aids without punched cards.

  6. 6. Which feature belongs to the fourth generation and not to the earlier ones?

    1. Use of transistors
    2. Use of vacuum tubes
    3. Use of punched cards for input
    4. A complete CPU on a single microprocessor chip
    Show answer

    Answer: D. Putting the whole processor on one chip defines the fourth generation. Vacuum tubes, transistors and punched-card input all belong to earlier generations.

  7. 7. A student says: 'ROM is primary memory and non-volatile; RAM is primary memory and volatile.' This statement is:

    1. Completely correct
    2. Wrong about ROM
    3. Wrong about RAM
    4. Wrong about both
    Show answer

    Answer: A. Both RAM and ROM are primary memory. RAM needs power to keep data (volatile) and ROM keeps data without power (non-volatile), so the whole statement is correct.

  8. 8. In a typical computer, which list goes from the smallest capacity to the largest?

    1. Hard disk, RAM, cache, registers
    2. Cache, registers, hard disk, RAM
    3. RAM, cache, registers, hard disk
    4. Registers, cache, RAM, hard disk
    Show answer

    Answer: D. Registers hold only a few values, cache is small, RAM is larger and the hard disk is largest. Capacity rises as speed falls down the memory hierarchy.

  9. 9. The flash memory in a pen drive is a form of which kind of ROM?

    1. PROM
    2. EPROM
    3. EEPROM
    4. Mask ROM
    Show answer

    Answer: C. Flash memory is a kind of EEPROM: it is erased and rewritten electrically. PROM can be written only once, EPROM is erased with ultraviolet light, and mask ROM is fixed at manufacture.

  10. 10. Taking 1 KB = 1024 bytes and 1 MB = 1024 KB, 3,145,728 bytes equal:

    1. 3 GB
    2. 3 KB
    3. 3 MB
    4. 30 MB
    Show answer

    Answer: C. 3,145,728 ÷ 1024 = 3,072 KB, and 3,072 ÷ 1024 = 3 MB.

  11. 11. What is binary 11010110 in octal?

    1. 326
    2. 652
    3. D6
    4. 214
    Show answer

    Answer: A. Group the bits in threes from the right: 11, 010, 110, which give 3, 2 and 6, so octal 326. D6 is the hexadecimal form and 214 is the decimal form of the same number.

  12. 12. A drive is sold as 500 GB, meaning 500 × 1000 × 1000 × 1000 bytes. Using 1 GB = 1024 × 1024 × 1024 bytes, the computer shows about:

    1. 500 GB
    2. 512 GB
    3. 466 GB
    4. 488 GB
    Show answer

    Answer: C. 500,000,000,000 ÷ 1,073,741,824 ≈ 465.66, which is about 466 GB. Dividing by 1024 only once gives about 488, a common slip.

  13. 13. Which group contains ONLY input devices?

    1. Scanner, printer, mouse
    2. Scanner, microphone, barcode reader
    3. Keyboard, speaker, webcam
    4. Joystick, plotter, light pen
    Show answer

    Answer: B. Scanner, microphone and barcode reader all send data into the computer. Each of the other groups contains an output device: printer, speaker or plotter.

  14. 14. Which group contains ONLY system software?

    1. Operating system, device driver, compiler
    2. Web browser, operating system, game
    3. Spreadsheet, word processor, compiler
    4. Media player, device driver, accounting package
    Show answer

    Answer: A. Operating systems, device drivers and compilers all run or serve the computer. Each other group contains application software such as a browser, a game, a spreadsheet or a media player.

  15. 15. A photo editor can be downloaded and used free of cost, but its source code is closed. It is best described as:

    1. Open-source software
    2. Freeware
    3. Firmware
    4. Hardware
    Show answer

    Answer: B. Freeware costs nothing to use but does not have to share its code. Open-source software makes the code available, firmware is fixed in a chip, and hardware is physical.

Questions 1-3: lesson 1 (computer basics and types). Questions 4-6: lesson 2 (generations and inventors). Questions 7-9: lesson 3 (CPU, memory and storage). Questions 10-12: lesson 4 (unit and number conversions). Questions 13-15: lesson 5 (devices, ports and software).

Sign in to keep track of the lessons you finish.

Privacy · Terms · Refunds · Delivery