- Advanced
- About 12 min
- 5 practice questions
The freshwater lens as a water budget
Treat the lens as a store with inflow and outflow, apply the simple density model and reason about island width and seasons.
If something looks wrong, please tell us.
Advanced questions on island water rarely ask what a lens is. They ask what happens to it when something changes: a dry year, a new well field, a wider or narrower island. To answer, think of the lens as a store with inflow (recharge) and outflow (abstraction and seepage to the sea), and reason about the balance. All numbers below are illustrative, not real data from any island.
By the end of this lesson you can
- Write and use a simple water budget for a lens.
- Apply the density rule of thumb with care.
- Reason about how island width and season change the lens.
The budget idea
Change in store = inflow - outflow. Inflow is rain that soaks in, less what plants and the air take back. Outflow is water pumped from wells plus the slow natural seep to the sea at the edges. If inflow exceeds outflow the store grows; if outflow exceeds inflow it shrinks. Because the store is a thin layer sitting on salt water, a shrinking store does not just mean less water: the boundary with salt water moves up, so quality falls too.
The lens budget through the year
- Monsoon Inflow is large; the lens thickens
- Post-monsoon Wells and seepage slowly draw it down
- Dry months Outflow exceeds inflow; lens thins
- Next monsoon Recharge starts the cycle again
Then back to step 1: Monsoon
The density rule of thumb
Fresh water is slightly lighter than sea water. In a simple textbook model with an idealised island, the depth of fresh water below sea level is about 40 times the height of the water table above sea level. Real lenses are affected by rock, mixing and tides, so the rule is a classroom model, not a measurement. Its useful lesson is that a very small drop at the top corresponds to a much larger loss of thickness below: lowering the water table by 0.1 m removes about 4 m of fresh water thickness in the model.
Width, wells and thickness
- A wider island collects more rain and its centre is farther from the sea, so its lens is generally thicker. A narrow strip has a thin lens.
- Wells near the centre take from the thickest part; wells near the shore sit close to salt water and turn salty sooner.
- Many shallow wells spread the pumping and are safer than one deep pumped well, which can pull salt water up beneath it.
| Change | Effect on lens (reasoned) |
|---|---|
| Wetter monsoon | More recharge; thicker lens |
| Two dry years | Less recharge; thinner lens, higher salt risk |
| New heavy pumping at the shore | Salt water rises near the well |
| Narrower island | Thinner lens |
| More water saved | Less outflow; lens holds |
Exam-style example 1
Illustrative: recharge 600 cubic metres a month, wells 450, natural seepage 100. Working: outflow = 450 + 100 = 550; change = 600 - 550 = +50 cubic metres a month, so the lens is slowly gaining.
Exam-style example 2
Illustrative: pumping rises to 560 with the same recharge and seepage. Working: outflow = 660; change = 600 - 660 = -60. The lens loses 60 cubic metres a month, and over 6 months about 360 cubic metres.
Exam-style example 3
Illustrative: in the model, the water table is 0.4 m above sea level. Depth of fresh water below sea level = 0.4 x 40 = 16 m. If pumping lowers the table to 0.3 m, depth = 12 m, a fall of 4 m of thickness for a 0.1 m drop.
Change in store = recharge - (pumping + seepage). A small fall in the water table means a large loss of thickness below (rule of thumb: 1 to 40). Wells near the shore and heavy single wells risk salt water.
Key takeaways
- Treat the lens as a budget of inflow and outflow.
- The 1 to 40 rule is a classroom model, not a measured fact for any island.
- Wider islands generally hold thicker lenses.
- Pump gently and spread wells away from the shore.
Check your understanding
-
1. Illustrative: recharge 800, pumping 700, seepage 150 (cubic metres a month). Net change?
- +100
- -50
- +50
- -150
Show answer
Answer: B. Outflow = 850; 800 - 850 = -50.
-
2. In the simple model, a water table 0.25 m above sea level gives a fresh water depth below sea level of about
- 0.25 m
- 1 m
- 100 m
- 10 m
Show answer
Answer: D. 0.25 x 40 = 10 m.
-
3. Why is a wider island generally better for a lens?
- It gathers more rain and the centre is far from the sea
- It has more rivers
- It has no salt water below
- It never needs wells
Show answer
Answer: A. More catchment and more distance from salt water give a thicker lens.
-
4. Which pumping pattern is safest?
- One deep well pumped hard
- Wells at the shore only
- Several shallow wells pumped gently
- No wells and no rain
Show answer
Answer: C. Spread, gentle pumping avoids pulling salt water up.
-
5. The 1 to 40 rule is best described as
- a measured fact for every island
- a law about rivers
- a classroom model with limits
- a rule for lagoons
Show answer
Answer: C. Real lenses vary; the rule shows the idea.
Sign in to keep track of the lessons you finish.