• Foundation
  • About 13 min
  • 5 practice questions

Using water: wells, groundwater and care of the coast

Understand groundwater, why salt water can enter coastal wells, and simple ways of saving rain water.

If something looks wrong, please tell us.

Rivers and tanks are only part of the water story. A great deal of the water used in Puducherry lies hidden under the ground. This lesson explains groundwater in simple terms, shows why it needs care near the sea, and ends with easy steps that any household or village can take.

What groundwater is

When rain falls on soil, some of it runs off into streams and some soaks down. Water that soaks down fills the small spaces between sand, gravel and rock. A layer of rock or sand that holds water in this way, and gives it out to wells, is called an aquifer. A well or a bore well is a hole dug or drilled to reach the aquifer. The refilling of the aquifer by rain and by water seeping from tanks and rivers is called recharge.

In a coastal region the picture has a second part. Fresh water is lighter than sea water. In many coastal aquifers a layer of fresh water floats above salt water from the sea. If too much fresh water is pumped out, the salt water can move inland and enter wells. This is called sea-water intrusion, and it makes well water salty. It is a known problem on coasts where groundwater is heavily used, and the Coromandel coast is one of them.

Ways of using and saving water

Water sources and cares
SourceHow it is usedWhat to watch
Rivers and canalsIrrigation of delta fields such as Karaikal and YanamWater depends on the rain and releases upstream
Tanks (eri)Store monsoon rain for farmsSilt and weeds must be cleared
Wells and bore wellsDrinking water and farmingToo much pumping can bring in salt water
Rain water harvestingCollecting roof rain into a tank or into the groundNeeds clean roofs and filters

Why a coastal well turns salty

  1. Rain recharges the aquifer Fresh water soaks down and fills the aquifer
  2. People pump out water Wells and bore wells draw water for homes and farms
  3. Too much is taken The fresh layer becomes thin
  4. Sea water moves inland Salt water pushes into the empty spaces under the coast
  5. The well water turns salty The well gives brackish water that is not good for drinking or crops
Sea-water intrusion in a coastal aquifer

Rain water harvesting means catching rain where it falls. Water from a roof can be led by a pipe into a storage tank or into a pit, so that it soaks into the ground and recharges the aquifer. Tanks like Bahour do the same job on a large scale. Cleaning and repairing old tanks is one of the cheapest ways to save water.

Water can also be too much. The Bay of Bengal brings cyclones in the post-monsoon season, and a cyclone can bring heavy rain and a storm surge that floods low land. Delta regions such as Karaikal and Yanam are flat and low, so they need drains, embankments and warning systems.

Worked examples

Example 1. Question: 'One millimetre of rain falling on one square metre of roof gives how much water?' Working: one square metre is 1 m by 1 m, and 1 mm is 0.001 m, so the volume is 0.001 cubic metre, which is 1 litre. Answer: 1 litre.

Example 2. Question: 'A roof of 50 square metres receives 20 mm of rain. How much water can be collected, ignoring losses?' Working: 50 x 20 = 1000 mm-square-metres, and each of these is 1 litre. Answer: 1000 litres.

Example 3. Question: 'Why can a well near the coast turn salty?' Working: heavy pumping lowers the fresh water layer, and salt water from the sea moves in under the land. Answer: sea-water intrusion.

Rain recharges, wells draw, too much pumping on a coast lets in the sea. 1 mm of rain on 1 square metre = 1 litre.

— Remember

Key takeaways: Groundwater is held in aquifers and reached by wells. Rain and tanks recharge it. On the coast, over-pumping can let salt water into wells. Rain water harvesting, clean tanks and careful pumping protect water. Delta regions also face the opposite risk, flooding from cyclones and heavy rain.

Check your understanding

  1. 1. A layer of rock or sand that holds groundwater and supplies wells is called an:

    1. Estuary
    2. Anicut
    3. Sluice
    4. Aquifer
    Show answer

    Answer: D. An aquifer stores groundwater. Wells and bore wells reach it.

  2. 2. Sea-water intrusion happens when:

    1. It rains too much
    2. Too much fresh water is pumped near the coast
    3. A river changes its name
    4. A tank is cleaned
    Show answer

    Answer: B. Heavy pumping thins the fresh layer, and salt water moves inland.

  3. 3. How much water does 1 mm of rain give on 1 square metre?

    1. 10 litres
    2. 100 litres
    3. 1 litre
    4. 0.1 litre
    Show answer

    Answer: C. 1 m2 x 0.001 m = 0.001 cubic metre = 1 litre.

  4. 4. A roof of 40 square metres gets 25 mm of rain. Water collected, ignoring losses, is:

    1. 1000 litres
    2. 650 litres
    3. 100 litres
    4. 10 000 litres
    Show answer

    Answer: A. 40 x 25 = 1000 litres, since each mm on each square metre is 1 litre.

  5. 5. Which regions of Puducherry are most at risk of flooding from river and cyclone water?

    1. The low delta lands of Karaikal and Yanam
    2. Hills of Mahe only
    3. Ousteri lake only
    4. None of them
    Show answer

    Answer: A. Flat, low delta lands near the Bay of Bengal are the most exposed to flood and storm surge.

Privacy · Terms · Refunds · Delivery