• Practice
  • About 14 min
  • 5 practice questions

Irrigation, groundwater and rain: methods and numbers

Practise questions on tanks, canals, wells, rain water harvesting and simple rainfall-to-volume sums.

If something looks wrong, please tell us.

Water-use questions come in two forms: short facts (which method is used where) and small numerical sums (how much water can be caught or stored). Both are easy once you know the method. This lesson gives a classification, the one conversion that unlocks the sums, and examples with full working.

Three ways of irrigating

Methods of irrigation
MethodWater sourceWhere it fits Puducherry
Canal irrigationRiver water carried by channelsDelta lands such as Karaikal and Yanam
Tank irrigationStored rain waterPuducherry region, for example Bahour
Well irrigationGroundwaterMany farms across the regions, with care on the coast

Canals depend on rivers that begin outside the Union Territory. Tanks depend on monsoon rain falling in the local catchment. Wells depend on the aquifer being recharged. A question may ask which method suits a delta: the answer is canal irrigation, because the river is close and the land is flat.

The conversion that solves rain sums

1 mm of rain on 1 square metre = 1 litre. 1000 litres = 1 cubic metre.

— Rule

Why? One square metre covered 1 mm deep is 1 x 1 x 0.001 = 0.001 cubic metre, and 1 cubic metre is 1000 litres, so 0.001 cubic metre is 1 litre. For roofs and plots, multiply the area in square metres by the rain in millimetres to get litres. A hectare is 10 000 square metres, so 1 mm of rain on a hectare is 10 000 litres, which is 10 cubic metres.

A real harvest is less than the sum because some water is lost to splash, evaporation and first flush. The sums below say 'ignoring losses'. Where a runoff factor is given, multiply by it.

Steps for a rain-harvest sum

  1. Write the area Roof or plot area in square metres
  2. Write the rain Rainfall in millimetres
  3. Multiply Area x rain gives litres
  4. Apply any loss Multiply by the fraction collected if the question gives one
  5. Convert if needed Divide by 1000 for cubic metres
Method for harvest sums

Common slips. Students forget to convert units: a rain figure in centimetres must first be changed to millimetres (1 cm = 10 mm), and an area in hectares to square metres. Another slip is to divide when the question needs multiplying. A quick check helps: a big roof and a big storm must give a big number, so if your answer is smaller than the area, look again. Finally, read whether the question asks for litres or cubic metres, because the two answers differ by a factor of 1000.

Worked examples

Example 1. A roof of 60 square metres gets 25 mm of rain. Water collected, ignoring losses? Working: 60 x 25 = 1500. Answer: 1500 litres.

Example 2. The same roof collects only 80 per cent of the rain. Working: 80 per cent of 1500 = 1200. Answer: 1200 litres.

Example 3. A farm of 2 hectares receives 30 mm of rain in a storm. How many cubic metres fall on it? Working: 2 hectares = 20 000 square metres. 20 000 x 30 = 600 000 litres = 600 cubic metres. Answer: 600 cubic metres.

Example 4. Which irrigation method is most suited to a flat delta village beside a river channel? Working: canal irrigation brings river water directly. Answer: canal irrigation.

Groundwater facts to keep ready

  • Rain and tank seepage recharge an aquifer; pumping removes water.
  • On a coast, over-pumping can let in sea water, which is called sea-water intrusion.
  • The river water of Puducherry comes from upstream states, so it varies with their rain and use.
  • Rain water harvesting and repair of tanks are cheap ways of recharge.

Key takeaways: Canals, tanks and wells are the three ways of irrigating. 1 mm of rain on 1 square metre is 1 litre. Multiply area by rain for litres, divide by 1000 for cubic metres. Sea-water intrusion is the coastal danger of over-pumping.

Check your understanding

  1. 1. 1 mm of rain on 1 square metre gives:

    1. 1 litre
    2. 10 litres
    3. 0.1 litre
    4. 1 cubic metre
    Show answer

    Answer: A. 1 x 1 x 0.001 m3 = 0.001 m3 = 1 litre.

  2. 2. A roof of 80 square metres gets 15 mm of rain. Water collected, ignoring losses:

    1. 95 litres
    2. 12 000 litres
    3. 1200 litres
    4. 120 litres
    Show answer

    Answer: C. 80 x 15 = 1200 litres.

  3. 3. Which method suits a flat delta village by a river?

    1. Glacier irrigation
    2. Canal irrigation
    3. Sea water irrigation
    4. No irrigation
    Show answer

    Answer: B. Canals carry river water to flat delta fields.

  4. 4. A hectare is how many square metres?

    1. 1000
    2. 100
    3. 100 000
    4. 10 000
    Show answer

    Answer: D. A hectare is 100 m by 100 m = 10 000 square metres.

  5. 5. If 1 mm of rain falls on one hectare, the volume is:

    1. 1 cubic metre
    2. 100 cubic metres
    3. 1000 cubic metres
    4. 10 cubic metres
    Show answer

    Answer: D. 10 000 litres = 10 cubic metres.

Privacy · Terms · Refunds · Delivery