• Advanced
  • About 16 min
  • 5 practice questions

Mass defect and binding energy: why both fission and fusion release energy

Use mass defect, E = mc² and the binding-energy-per-nucleon curve to explain why heavy nuclei split and light ones fuse, and estimate the energy released by each.

If something looks wrong, please tell us.

At the foundation level you learnt that fission and fusion turn a little mass into energy. The advanced question is why splitting a heavy nucleus and joining light ones should both release energy - they look like opposite processes. The answer is one graph, the binding-energy curve, and it also explains why iron is the end point of stellar fusion and why fusion fuel is so much richer in energy than fission fuel.

Mass defect

Weigh a nucleus and then weigh the protons and neutrons that make it, separately. The nucleus is always lighter. The difference is the mass defect. It is the mass equivalent of the energy that would be needed to pull the nucleus apart, called the binding energy: binding energy = mass defect × c². A bigger binding energy means a more tightly held, more stable nucleus.

Binding energy per nucleon

To compare nuclei of different sizes, divide the binding energy by the number of nucleons. Plotted against mass number, this binding energy per nucleon rises steeply through the light nuclei, reaches a broad peak of about 8.8 MeV per nucleon near iron-56, and then falls slowly to about 7.6 MeV per nucleon for uranium. (1 MeV, a million electron-volts, is a tiny amount of energy suited to single nuclei.)

Points on the binding-energy curve
NucleusBinding energy per nucleon (approx.)Comment
Deuterium (hydrogen-2)1.1 MeVVery loosely bound
Helium-47.1 MeVUnusually tightly bound for its size
Iron-568.8 MeVNear the peak - the most stable region
Uranium-2357.6 MeVLess tightly bound than mid-sized nuclei

Any change that moves nucleons towards the peak releases energy. Splitting uranium (7.6) into two mid-sized fragments (around 8.5) raises every nucleon's binding energy by roughly 0.85 MeV, so about 0.85 × 236 ≈ 200 MeV comes out per fission. Fusing deuterium and tritium into helium-4 climbs the steep left side of the curve, giving 17.6 MeV from five nucleons. Iron sits at the top, so neither fusing nor splitting it releases energy - which is why fusion in massive stars stops at iron.

Worked example 1: energy per nucleon

Compare energy released per nucleon in fission and in D-T fusion. Working: fission ≈ 200 MeV ÷ 236 nucleons ≈ 0.85 MeV per nucleon. Fusion = 17.6 MeV ÷ 5 nucleons ≈ 3.5 MeV per nucleon. Ratio ≈ 3.5 ÷ 0.85 ≈ 4. Kilogram for kilogram, fusion fuel releases roughly four times more energy than fission fuel.

Worked example 2: one gram of uranium-235

Estimate the energy from fissioning all the nuclei in 1 g of uranium-235. Working: number of nuclei = 6.022 × 10²³ ÷ 235 ≈ 2.56 × 10²¹. Energy per fission = 200 MeV × 1.602 × 10⁻¹³ J per MeV ≈ 3.2 × 10⁻¹¹ J. Total ≈ 2.56 × 10²¹ × 3.2 × 10⁻¹¹ ≈ 8.2 × 10¹⁰ J, which is close to one megawatt running for a day. Taking good coal at an illustrative 25 MJ per kg, that equals about 3,300 kg of coal. The mass actually converted is only about 0.9 mg, less than a tenth of one per cent of the gram.

Worked example 3: complete conversion

If 1 g of mass were turned entirely into energy, E = mc² = 0.001 kg × (3 × 10⁸ m/s)² = 9 × 10¹³ J. Nuclear reactions convert only a small fraction of their fuel's mass, which is why the energy in Worked example 2 is about a thousand times smaller.

Binding energy = mass defect × c². Energy is released when nucleons move towards the iron-56 peak: heavy nuclei by splitting, light nuclei by fusing. Fission ≈ 200 MeV per event; D-T fusion = 17.6 MeV.

Key takeaways: the mass defect is the mass of the binding energy. The curve peaks near iron, so heavy nuclei release energy by fission and light ones by fusion. Per nucleon, fusion gives about four times more energy than fission, and both give millions of times more than chemical burning.

Check your understanding

  1. 1. Binding energy per nucleon is highest for nuclei near:

    1. Uranium-238
    2. Helium-4
    3. Iron-56
    4. Hydrogen-2
    Show answer

    Answer: C. The binding-energy curve peaks near iron-56 at about 8.8 MeV per nucleon. Uranium is lower (about 7.6) and the light nuclei lower still, except that helium-4 is unusually high for its size.

  2. 2. The mass defect of a nucleus is:

    1. The difference between the mass of its separate nucleons and the mass of the nucleus
    2. The mass lost by the nucleus in each alpha decay
    3. The mass of its electrons subtracted from the mass of its protons
    4. The mass of the neutrons in the nucleus
    Show answer

    Answer: A. A nucleus weighs less than its protons and neutrons taken separately. That difference, multiplied by c², is the binding energy.

  3. 3. Why does fusing two very light nuclei release energy?

    1. Light nuclei contain more neutrons than heavy nuclei
    2. The product has a higher binding energy per nucleon than the starting nuclei
    3. Fusion does not obey E = mc²
    4. The electrons of the atoms are destroyed
    Show answer

    Answer: B. The curve rises steeply for light nuclei, so the fused product is more tightly bound per nucleon. The extra binding energy is released, and the products weigh slightly less.

  4. 4. D-T fusion releases 17.6 MeV from 5 nucleons; fission of uranium-235 releases about 200 MeV from 236 nucleons. Per nucleon, fusion releases about:

    1. One-quarter as much as fission
    2. The same as fission
    3. Twenty times as much as fission
    4. Four times as much as fission
    Show answer

    Answer: D. Fusion: 17.6 ÷ 5 ≈ 3.5 MeV per nucleon. Fission: 200 ÷ 236 ≈ 0.85 MeV per nucleon. 3.5 ÷ 0.85 ≈ 4.

  5. 5. Why does fusion inside massive stars stop producing energy once the core is mainly iron?

    1. Iron is radioactive and decays too quickly
    2. Iron nuclei are too light to fuse
    3. Iron is at the peak of the binding-energy curve, so fusing it absorbs energy instead of releasing it
    4. Iron cannot be heated above a million degrees
    Show answer

    Answer: C. Nuclei at the peak are the most tightly bound. Fusing iron into heavier nuclei moves down the curve, which costs energy rather than releasing it.

Privacy · Terms · Refunds · Delivery