• Practice
  • About 15 min
  • 5 practice questions

Nuclear division and the phases of the cell cycle

Distinguish mitosis and meiosis, define the cell cycle, read the time spent in each phase, use C-values for DNA content, and explain G1, its checkpoint and the quiescent G0 phase.

If something looks wrong, please tell us.

By the end of this lesson you can

  • Compare mitosis and meiosis in terms of chromosome number.
  • Define the cell cycle and list its phases in order.
  • Work with the durations of the phases and with 2C and 4C DNA amounts.
  • Explain what happens in G1 and why some cells enter G0.

A root tip grows because its cells keep dividing; a wound heals because new cells replace damaged ones. All new cells arise from existing cells, and before a cell can divide it must grow and copy its DNA. The orderly sequence of these events is the cell cycle.

Two kinds of nuclear division

In mitosis the daughter nuclei receive the same number of chromosomes as the parent, usually the diploid (2n) number. It happens when an organism grows, replaces cells or reproduces asexually. In meiosis the daughter nuclei receive half the chromosome number, the haploid (n) state. Either kind of nuclear division is normally followed by cytokinesis, the division of the cytoplasm.

The cell cycle and its timing

The cell cycle is the series of events that leads to the formation of new cells. It has two main parts: interphase (G1, S and G2) and the M phase (mitosis plus cytokinesis). Interphase takes up about 95% of the cycle.

The cell cycle

  1. G1 First gap: growth, 2C DNA
  2. S DNA synthesis: 2C to 4C
  3. G2 Second gap: preparation, 4C
  4. M Mitosis and cytokinesis

Then back to step 1: G1

Cell cycle of a proliferating human cell (Tamil Nadu textbook)
PhaseHours
G111
S8
G24
M1

Worked example 1: share of each phase

Total cycle = 11 + 8 + 4 + 1 = 24 hours. Interphase = 11 + 8 + 4 = 23 hours. Share of interphase = 23 ÷ 24 × 100 ≈ 95.8%, which matches the textbook's figure of about 95%. M phase = 1 ÷ 24 × 100 ≈ 4.2%. So if you look at many dividing cells at random, only about 4 in every 100 will be in mitosis.

C-value: measuring DNA

The C-value is the amount of DNA, in picograms, in a haploid nucleus. A diploid cell in G1 therefore has 2C DNA. During S phase the DNA is copied, so a cell in G2 or early mitosis has 4C. After mitosis each daughter cell returns to 2C.

G1 = 2C → S = 2C to 4C → G2 = 4C → after mitosis each daughter = 2C. Chromosome number does not change in S; only DNA amount doubles.

Worked example 2: DNA amounts (made-up value)

Suppose the haploid nucleus of a plant has 3 pg of DNA (C = 3 pg). A diploid root cell in G1 has 2C = 6 pg. In G2 it has 4C = 12 pg. Each daughter cell after mitosis has 6 pg again. A gamete formed by meiosis has 1C = 3 pg.

Interphase is not a resting stage

Interphase is the longest and most variable part of the cycle. The nucleus may look inactive because the chromosomes have spread out as thin threads, but the cell is busy making proteins and copying DNA.

G1 phase

In the first gap phase the cell is metabolically active and grows, making proteins, lipids, carbohydrates and organelles such as mitochondria and ER. At the end of G1 is the first checkpoint (restriction point), which decides whether the cell will go on to divide, enter G0, or die. Proteins called cyclins and kinases switch on the genes needed for division; cyclins form the major checkpoint in G1. Cells are held in G1 by lack of nutrients, lack of growth factors or density-dependent inhibition.

G0 phase

Some cells leave G1 and enter G0, a quiescent stage in which they stay metabolically active but do not divide, with reduced RNA and protein synthesis. G0 is not dormancy and is usually not permanent: many animal cells remain in G0 until growth factors call them back. Mature neurons and skeletal muscle cells, however, stay in G0 permanently. The textbook notes that the cloned sheep Dolly was made using a donor nucleus from mammary cells pushed into G0 by starving them of nutrients.

Key takeaways: mitosis keeps the chromosome number, meiosis halves it. The cell cycle runs G1 → S → G2 → M, with interphase taking about 95% of the time. DNA goes 2C → 4C in S. The G1 checkpoint, run by cyclins and kinases, sends a cell on to divide or into the non-dividing G0 state.

Check your understanding

  1. 1. The correct sequence of the cell cycle is:

    1. S → M → G1 → G2
    2. G1 → S → G2 → M
    3. S → G1 → G2 → M
    4. M → G2 → S → G1
    Show answer

    Answer: B. A cell grows in G1, copies DNA in S, prepares in G2 and divides in M.

  2. 2. Using the textbook's human cell cycle (G1 11 h, S 8 h, G2 4 h, M 1 h), what fraction of the cycle is S phase?

    1. One-sixth
    2. One-quarter
    3. One-third
    4. One-half
    Show answer

    Answer: C. Total = 24 h. S = 8 h, and 8 ÷ 24 = 1/3.

  3. 3. A diploid cell has 10 pg of DNA in G1. How much DNA does it have in G2?

    1. 20 pg
    2. 10 pg
    3. 5 pg
    4. 40 pg
    Show answer

    Answer: A. DNA doubles during S, from 2C to 4C, so 10 pg becomes 20 pg in G2.

  4. 4. Which statement about G0 is correct?

    1. Cells in G0 are dead
    2. Cells in G0 are dividing rapidly
    3. G0 cells cannot ever divide again in any tissue
    4. Cells in G0 are metabolically active but do not proliferate
    Show answer

    Answer: D. G0 is a quiescent state: the cell works but does not divide. Many G0 cells can re-enter the cycle when signalled; only some, like mature neurons, stay permanently.

  5. 5. Which molecules act as the major checkpoint deciding whether a cell divides at the end of G1?

    1. Histones
    2. Tubulins
    3. Cyclins
    4. Cohesins
    Show answer

    Answer: C. Cyclins, working with kinases, activate the genes needed for division and form the major G1 checkpoint.

Privacy · Terms · Refunds · Delivery