Unit 10 Representation of Relief Features and Climatic Data

Practice questions

Using 1 cm = 5% of days, a bar of 4.8 cm in the south-west direction means:

  1. 4.8% of days the wind blew towards the south-west
  2. 24% of days the wind blew from the south-west
  3. 48% of days were calm
  4. the wind speed was 24 knots
Answer and explanation

Answer: B

4.8 × 5 = 24%. Wind rose bars show the direction the wind blows from.

A wind rose has calm 8% and the directions N 30, NE 12, E 10, SE 10, S 10, SW 8, W 6 and NW. What is NW?

  1. 6%
  2. 8%
  3. 4%
  4. 14%
Answer and explanation

Answer: A

Directions given: 30 + 12 + 10 + 10 + 10 + 8 + 6 = 86. With calm 8, the total is 94, so NW = 100 - 94 = 6%.

Made-up monthly rainfall (mm): 10, 10, 20, 40, 80, 300, 350, 320, 200, 90, 20, 10. The wettest three-month spell is:

  1. October-December
  2. January-March
  3. June-August
  4. March-May
Answer and explanation

Answer: C

June 300 + July 350 + August 320 = 970 mm, far more than any other three months.

On a combined climatic diagram, why must the rainfall axis start at 0?

  1. Because temperatures are never negative
  2. Because the months start at January
  3. Because the textbook forbids other values
  4. Because bar lengths must be proportional to the amounts
Answer and explanation

Answer: D

A bar's length represents the amount; starting above zero would make the bars mislead.

A section line crosses 100, 200, 300 m within 1 cm, then a flat stretch at about 300 m for 6 cm, then 300, 200, 100 m within 1 cm. The landform is a:

  1. V-shaped valley
  2. plateau
  3. volcano
  4. col
Answer and explanation

Answer: B

Steep sides rising quickly to a broad, level top is a plateau.

In a cross section, between two crossings of the 250 m contour with no higher contour between them, the land is:

  1. above 250 m but below the next contour value
  2. exactly 250 m and perfectly flat
  3. below 250 m
  4. at sea level
Answer and explanation

Answer: A

With no higher contour crossed, the top lies above 250 m but below the next contour; draw it slightly above 250 m, not flat.

Which description fits a gorge?

  1. Very widely spaced contours
  2. A broad rectangular innermost contour
  3. Closely converging contours on both sides of a river at a high elevation
  4. A lower inner ring of contours
Answer and explanation

Answer: C

The textbook describes a gorge as a very steep valley at higher elevation, seen as closely converging contours in the river course.

Contours 400, 500, 600 and 700 m all touch one point on a river course, and 300 m does not. The waterfall's height is:

  1. 700 m
  2. 300 m
  3. 400 m
  4. 100 m
Answer and explanation

Answer: B

Highest minus lowest contour touching the point: 700 - 400 = 300 m.

Contours form a V with the apex pointing towards lower ground. The feature is a:

  1. gorge
  2. valley
  3. waterfall
  4. spur
Answer and explanation

Answer: D

A V pointing downhill is a spur; in a valley the V points uphill.

On a 1 : 25,000 map, two contours 40 m apart are 0.8 cm apart. The gradient is:

  1. 1 in 5
  2. 1 in 50
  3. 1 in 20
  4. 1 in 2
Answer and explanation

Answer: A

Horizontal distance = 0.8 × 25,000 = 20,000 cm = 200 m. Gradient = 40 ÷ 200 = 1/5, that is 1 in 5.

Between labelled contours of 1,200 m and 1,500 m there are five unlabelled contours. The CI is:

  1. 60 m
  2. 50 m
  3. 75 m
  4. 100 m
Answer and explanation

Answer: B

Five unlabelled lines between two labelled ones make 6 gaps. CI = 300 ÷ 6 = 50 m.

On a 1 : 50,000 sheet, the textbook says the usual contour interval is:

  1. 100 m
  2. 50 m
  3. 5 m
  4. 20 m
Answer and explanation

Answer: D

Generally 20 m on 1 : 50,000 sheets and 100 m on 1 : 250,000 sheets, according to the textbook.

In layer colouring, white is used for:

  1. snow-covered peaks
  2. plains
  3. deep seas
  4. deserts
Answer and explanation

Answer: A

Blue is water, green plains, browns highlands, white snow-covered peaks.

A small triangle with a height beside it marks a:

  1. bench mark
  2. trigonometrical station
  3. spot height
  4. form line
Answer and explanation

Answer: B

Trigonometrical stations are shown by triangles with their heights. Spot heights are dots; bench marks carry the letters BM.

Which method of showing relief gives exact heights and does not hide other features on the map?

  1. Hill shading
  2. Hachures
  3. Contours
  4. Layer colouring
Answer and explanation

Answer: C

The textbook notes that contours do not hide other features and show heights above mean sea level; hachures and shading give no heights.

A made-up station's percentages are N 20, NE 15, E 10, SE 10, S 10, SW 10, W 5, NW 5. What percentage of days is calm?

  1. 15%
  2. 5%
  3. 0%
  4. 25%
Answer and explanation

Answer: A

The directions add up to 20 + 15 + 10 + 10 + 10 + 10 + 5 + 5 = 85%. Calm = 100 - 85 = 15%.

Why do airport planners study the wind rose?

  1. To decide the colour of the runway
  2. To align the runway with the prevailing wind
  3. To measure rainfall
  4. To find the height of the land
Answer and explanation

Answer: B

The textbook notes that runways are generally oriented towards the prevailing wind, which the wind rose shows.

With a scale of 1 cm = 10% of days, a direction with 35% of days needs a bar of:

  1. 35 cm
  2. 0.35 cm
  3. 3.5 cm
  4. 10 cm
Answer and explanation

Answer: C

35 ÷ 10 = 3.5 cm.

In a wind rose, the longest bar points north-west. This means:

  1. the prevailing wind blows from the north-west
  2. the wind blows towards the north-west
  3. north-west has the highest temperature
  4. the day was calm
Answer and explanation

Answer: A

Wind rose bars point towards the direction from which the wind blows; the longest one is the prevailing wind.

Rainfall for a single station is generally shown as a:

  1. wind rose
  2. line graph
  3. contour map
  4. bar diagram
Answer and explanation

Answer: D

The textbook says rainfall is generally shown as a bar diagram; temperature as a line graph.

Privacy · Terms · Refunds · Delivery