Unit 10 Surface Chemistry
Practice questions
An oil-in-water emulsion stabilised by a potassium soap is shaken with a little CaCl₂ and becomes a water-in-oil emulsion. This change is called
- demulsification
- peptisation
- electro-osmosis
- inversion of phase
Answer and explanation
Answer: D
Changing an emulsion from one type to the other (here O/W to W/O) is inversion of phase. Demulsification would separate the liquids into layers instead.
Assertion (A): A small amount of gelatine added to a gold sol makes it much harder to coagulate with NaCl. Reason (R): Gelatine is a lyophilic colloid with a very small gold number.
- Both A and R are true, and R is the correct explanation of A.
- Both A and R are true, but R is not the correct explanation of A.
- A is true, but R is false.
- A is false, but R is true.
Answer and explanation
Answer: A
Gelatine is lyophilic and protects lyophobic gold sol; its tiny gold number (about 0.005-0.01) means very little is needed. That protective power is exactly why A happens, so R explains A.
Practice data: the flocculation values of three electrolytes for a sol (mmol L⁻¹) are: NaCl 52, BaCl₂ 0.69, AlCl₃ 0.09. What is the sign of charge on the sol and which electrolyte coagulates it best?
- Negative; AlCl₃
- Positive; NaCl
- Negative; NaCl
- Positive; AlCl₃
Answer and explanation
Answer: A
The values fall sharply as the cation charge rises (Na⁺, Ba²⁺, Al³⁺) while the anion (Cl⁻) is the same, so the cations are doing the coagulating and the sol must be negative. The smallest flocculation value (AlCl₃, 0.09) means the greatest coagulating power.
Which purification method would remove NaCl from a gold sol fastest?
- Ordinary filtration
- Electrodialysis
- Simple dialysis
- Adding more NaCl
Answer and explanation
Answer: B
Ordinary filter paper lets both pass. Dialysis removes the ions slowly by diffusion; electrodialysis drives them through the membrane with an electric field, so it is faster. Adding NaCl would coagulate the sol.
In the preparation of gold sol, 2AuCl₃ + 3HCHO + 3H₂O → 2Au + 6HCl + 3HCOOH, which statement is correct?
- Formaldehyde is reduced and gold is oxidised.
- It is a hydrolysis method.
- Each Au³⁺ gains 3 electrons, and 6 electrons in all are supplied by 3 HCHO molecules.
- The equation is not balanced for hydrogen.
Answer and explanation
Answer: C
Gold goes from +3 to 0, so 2 Au gain 6 electrons; carbon goes from 0 in HCHO to +2 in HCOOH, so 3 molecules lose 6 electrons. HCHO is the reducing agent (this is the reduction method). Hydrogen balances: 6 + 6 = 12 on the left, 6 + 6 = 12 on the right.
Which colloid has a solid dispersed phase in a liquid dispersion medium?
- Butter
- Paint
- Pumice stone
- Milk
Answer and explanation
Answer: B
Paint (like ink) is a sol: solid pigment particles in a liquid. Butter is a gel (liquid in solid), pumice a solid foam (gas in solid) and milk an emulsion (liquid in liquid).
A zeolite catalyst cracks a straight-chain alkane but leaves a highly branched alkane in the same feed untouched, because the branched molecule cannot enter the pores. This is
- product selectivity
- transition-state selectivity
- reactant selectivity
- phase transfer catalysis
Answer and explanation
Answer: C
When bulky reactant molecules are kept away from the active sites inside the pores, only the smaller reactants react: reactant shape selectivity.
In the decomposition of H₂O₂, the textbook gives activation energies of 18 kcal mol⁻¹ (no catalyst), 11.7 kcal mol⁻¹ (colloidal platinum) and less than 2 kcal mol⁻¹ (enzyme). By how much more does the enzyme lower the barrier than platinum does, at least?
- About 6.3 kcal mol⁻¹
- About 16 kcal mol⁻¹
- About 2 kcal mol⁻¹
- About 9.7 kcal mol⁻¹
Answer and explanation
Answer: D
Platinum lowers it by 18 − 11.7 = 6.3 kcal mol⁻¹. The enzyme lowers it by more than 18 − 2 = 16 kcal mol⁻¹. The difference is at least 16 − 6.3 = 9.7 kcal mol⁻¹ (equivalently 11.7 − 2 = 9.7).
Which is NOT a characteristic of enzyme catalysis?
- It is highly specific.
- It has an optimum pH.
- Its rate keeps increasing with temperature without limit.
- It can be inhibited by poisons.
Answer and explanation
Answer: C
Enzyme activity rises only up to the optimum temperature; above it the protein is denatured and the rate falls sharply, even to zero. The other three are genuine features of enzymes.
Which pair of reactions shows the intermediate compound theory for the formation of water from H₂ and O₂ over copper?
- 2Cu + ½O₂ → Cu₂O, then Cu₂O + H₂ → H₂O + 2Cu
- Cu + H₂ → CuH₂, then CuH₂ → Cu + H₂
- 2Cu + O₂ → 2CuO, then 2CuO → 2Cu + O₂
- H₂ + O₂ → H₂O₂, then H₂O₂ → H₂O + ½O₂
Answer and explanation
Answer: A
Copper first forms the intermediate Cu₂O with oxygen; hydrogen then reduces it to water and copper. Adding the steps gives H₂ + ½O₂ → H₂O with copper regenerated. The other pairs either give no water or do not pass through a copper intermediate.
In 2SO₂ + O₂ → 2SO₃ over platinum, traces of As₂O₃ in the gases stop the reaction. In terms of the adsorption theory, this is because As₂O₃
- acts as a promoter
- occupies the active centres of the platinum
- reacts with SO₃ to form SO₂
- is a homogeneous catalyst
Answer and explanation
Answer: B
As₂O₃ is a catalytic poison for platinum: it is strongly adsorbed on the active centres, leaving no sites where SO₂ and O₂ can be adsorbed and activated.
Which of these statements about catalysts is correct?
- A catalyst increases the yield of ammonia at equilibrium in the Haber process.
- A catalyst can start a reaction that is not thermodynamically possible.
- A catalyst is used up in the reaction and must be replaced in equal amount.
- A catalyst provides a path of lower activation energy for both forward and backward reactions.
Answer and explanation
Answer: D
A catalyst lowers the activation energy of the forward and reverse reactions alike, so equilibrium is reached faster but its position (and the yield) is unchanged. It cannot make an impossible reaction occur and is not consumed.
For a Freundlich isotherm, x/m = 0.30 at 1 atm and 0.60 at 4 atm (same temperature). What is the value of n?
- 2
- 0.5
- 4
- 1
Answer and explanation
Answer: A
At p = 1, x/m = k = 0.30. Then 0.60 = 0.30 × 4¹ᐟⁿ, so 4¹ᐟⁿ = 2 and 1/n = log 2 ÷ log 4 = 0.5. Therefore n = 2 (the exponent 1/n is 0.5).
The chemisorption isobar first rises and then falls with temperature. What causes the initial rise?
- Desorption of the adsorbate
- The weakening of van der Waals forces
- The need for activation energy to form the chemisorbed activated complex
- The formation of multilayers
Answer and explanation
Answer: C
Chemisorption needs appreciable activation energy, so at low temperature few molecules can be chemisorbed. Warming supplies this energy and x/m rises; at still higher temperature desorption wins and x/m falls.
Which statement about physisorption is INCORRECT?
- It is reversible.
- It increases with increase in temperature.
- Its heat of adsorption is low.
- It increases with the surface area of the adsorbent.
Answer and explanation
Answer: B
Physisorption is exothermic and held by weak forces, so raising the temperature makes molecules desorb: the amount adsorbed falls. The other three statements are true.
An emulsion conducts electricity well and does not take up the colour of an oil-soluble dye. What type is it?
- Water in oil (W/O)
- A solid sol
- Oil in water (O/W)
- A gel
Answer and explanation
Answer: C
High conductivity means water, with its dissolved ions, is the continuous phase, and an oil-soluble dye colours only the small dispersed oil droplets, so the whole does not look coloured. Both point to an oil-in-water emulsion, like milk.
Gelatine has a gold number of about 0.005-0.01 and potato starch about 25. What does this tell you?
- Potato starch is the better protective colloid.
- Both protect gold sol equally well.
- Gelatine coagulates gold sol.
- Gelatine is a far better protective colloid than potato starch.
Answer and explanation
Answer: D
The gold number is the mass in milligrams needed to protect 10 mL of gold sol, so a smaller number means a stronger protective colloid. Gelatine needs thousands of times less than potato starch.
During electrophoresis the particles of a sol move towards the cathode. What can you conclude?
- The particles are positively charged, as in a ferric hydroxide sol.
- The particles are negatively charged, as in a gold sol.
- The particles have no charge.
- The dispersion medium is positively charged.
Answer and explanation
Answer: A
The cathode is negative, so particles that move to it carry a positive charge. Ferric hydroxide sol is a typical positive sol; the medium carries the opposite (negative) charge.
Which ion has the greatest power to coagulate a negatively charged arsenious sulphide sol?
- Na⁺
- Al³⁺
- Ba²⁺
- PO₄³⁻
Answer and explanation
Answer: B
A negative sol is coagulated by cations, and the higher the charge the greater the power: Al³⁺ > Ba²⁺ > Na⁺. PO₄³⁻ has the same sign of charge as the sol, so it does not coagulate it.
A beam of light is visible from the side when passed through a starch sol but not through a sugar solution. This is due to
- Brownian movement
- electrophoresis
- the Tyndall effect
- electro-osmosis
Answer and explanation
Answer: C
Colloidal particles are large enough to scatter light sideways, making the beam's path visible: the Tyndall effect. The molecules of a true sugar solution are too small to scatter it noticeably.