Revision notes

Chapter 12 Magnetic Effects of Electric Current: Foundation

The key points, rules to remember, tables and diagrams from all 5 lessons, on one page for quick revision. To keep a copy, use your browser's Print and choose "Save as PDF".

Lesson 1

Magnetic field and field lines

A magnetic field is the region around a magnet where its magnetic force can be felt. Its direction at a point is the direction a compass north pole points there.

Magnetic field lines of a bar magnet

  • Direction
    • Outside the magnet: from north pole to south pole
    • Inside the magnet: from south pole to north pole
    • So every field line is a closed curve
  • Strength
    • Lines crowded together where the field is strong
    • Lines most crowded near the poles
  • Never cross
    • Two field lines never intersect
    • A crossing would mean two field directions at one point, which is impossible
Common mistakes about field lines
StatementTrue or falseReason
Field lines start at N and end at SFalseThey are closed curves; inside the magnet they run from S back to N
Field lines can cross where the field is strongFalseA crossing would mean two directions at one point
Closer lines mean a stronger fieldTrueLine spacing shows relative strength

Key takeaways: a compass needle is a small magnet whose north pole points along the field. A magnetic field is the region where a magnet's force can be detected. Field lines go from N to S outside a magnet and from S to N inside, forming closed loops. They are closer where the field is stronger and never cross.

Read the full lesson

Lesson 2

Magnetic field of a current in a straight wire

Field around a long straight current-carrying wire

  • Shape
    • Concentric circles centred on the wire
    • In planes perpendicular to the wire
  • Direction
    • Given by the right-hand thumb rule
    • Reverses if the current reverses
  • Strength
    • Increases when the current increases
    • Decreases with distance from the wire

Right-hand thumb rule: hold the current-carrying wire in your right hand with the thumb pointing in the direction of the current; your curled fingers then point in the direction of the magnetic field lines.

Key takeaways: a current in a wire produces a magnetic field, as Oersted discovered. Around a straight wire the field lines are concentric circles in planes perpendicular to the wire. The right-hand thumb rule gives their direction: thumb along the current, fingers along the field. The field is stronger for a larger current and weaker farther from the wire, and it reverses when the current reverses.

Read the full lesson

Lesson 3

Field of a circular loop, a solenoid and electromagnets

Solenoid and bar magnet

  • Current-carrying solenoid
    • Field pattern outside like a bar magnet
    • Uniform field inside
    • Poles reverse if the current reverses
    • Field disappears when the current is switched off
  • Bar magnet
    • Field pattern outside from N to S
    • Field inside runs S to N
    • Poles are fixed
    • Magnetism is permanent

Looking at one end of a coil: if the current flows anticlockwise, that end is a north pole; if it flows clockwise, that end is a south pole.

Making an electromagnet stronger

  1. More current A larger current gives a stronger field.
  2. More turns Each turn adds to the field.
  3. Soft iron core The core becomes strongly magnetised while the current flows.
  4. Switch off Soft iron loses most of its magnetism when the current stops.

Key takeaways: at the centre of a current loop the field lines are straight and perpendicular to the loop, and n turns give n times the field. A solenoid's field is like a bar magnet's outside and uniform inside. Anticlockwise current seen at an end makes that end north; clockwise makes it south. An electromagnet is a soft iron core in a coil; it is stronger with more current and more turns, and works only while current flows.

Read the full lesson

Lesson 4

Force on a current-carrying conductor and Fleming's left-hand rule

The force on a current-carrying conductor

  • Direction depends on
    • The direction of the current
    • The direction of the magnetic field
    • Reversing either one reverses the force
  • Size of the force
    • Largest when current and field are perpendicular
    • Zero when current is parallel to the field
  • Direction rule
    • Fleming's left-hand rule

Fleming's left-hand rule: stretch the thumb, forefinger and middle finger of the left hand so that they are mutually perpendicular. If the forefinger points along the magnetic field and the middle finger along the current, the thumb points in the direction of the force (motion) on the conductor.

Practice pairs to check with your own left hand
FieldCurrentForce (by the left-hand rule)
NorthEastUpwards
NorthWestDownwards
DownwardsSouthEast
EastUpwardsNorth

Key takeaways: a current-carrying conductor in a magnetic field experiences a force. The force reverses when either the current or the field reverses, is largest when they are perpendicular and zero when they are parallel. Fleming's left-hand rule gives its direction: forefinger field, middle finger current, thumb force. Motors, loudspeakers and measuring instruments use this force.

Read the full lesson

Lesson 5

Domestic electric circuits and safety

From the pole to the appliance

  1. Mains supply Live and neutral wires reach the house.
  2. Main fuse Protects the whole house wiring.
  3. Electricity meter Measures the energy used in kW h.
  4. Main switch and distribution box Splits the supply into separate circuits.
  5. Separate circuits For example 15 A for heavy appliances, 5 A for bulbs and fans.
  6. Appliances Each connected in parallel with its own switch.

Live (red), neutral (black) and earth (green): 220 V AC at 50 Hz between live and neutral; the earth wire is a safety path that keeps metal bodies of appliances at earth potential.

Two dangers in a household circuit

  • Overloading
    • Too many appliances on one socket or circuit
    • Or a sudden rise in supply voltage
    • Total current exceeds the safe rating
    • Wires overheat and may catch fire
  • Short-circuiting
    • Live and neutral wires touch directly
    • Usually when insulation is damaged or an appliance is faulty
    • Resistance becomes very small
    • Current rises abruptly to a very large value

Key takeaways: homes in India receive 220 V AC at 50 Hz through live and neutral wires, with an earth wire for safety. The supply passes through a main fuse, a meter and a distribution box into separate 15 A and 5 A circuits, with appliances in parallel. Earthing protects users from shocks by metal-bodied appliances. Overloading and short-circuiting cause dangerously large currents; a fuse in series melts and breaks the circuit.

Read the full lesson

Privacy · Terms · Refunds · Delivery