• Foundation
  • About 26 min
  • 5 practice questions

Diffraction at a single slit and polarisation of light

Explain single-slit diffraction and the positions of its minima, distinguish it from interference, and use polaroids and Malus' law to show that light is a transverse wave.

If something looks wrong, please tell us.

By the end of this lesson you can

  • Describe the single-slit diffraction pattern and state where its minima and secondary maxima lie.
  • Explain the first minimum by dividing the slit into two halves.
  • Distinguish diffraction from interference.
  • Explain polarisation by polaroids and use Malus' law I = I₀ cos²θ.

Look closely at the edge of a shadow and you will find faint bright and dark bands. Light does bend a little around obstacles and spread after passing through narrow openings. This is diffraction, shown by every kind of wave: sound, water waves, light and even matter waves. We rarely notice it with light because its wavelength is tiny compared with everyday objects, but diffraction sets the ultimate limit on how much detail the eye, microscopes and telescopes can show. The colours seen on a CD also come from diffraction.

The single slit pattern

Let a parallel beam of monochromatic light fall normally on a single slit of width a, and observe the light on a distant screen. Instead of a sharp bright strip, we see a broad, bright central maximum with weaker, narrower bright bands on both sides, separated by dark bands. The intensity of the side maxima falls off quickly.

The explanation follows Huygens: every point of the wavefront in the slit acts as a source of secondary wavelets, all in phase (the incoming wavefront is parallel to the slit). At an angle θ, wavelets from different parts of the slit travel different distances. The path difference between the two edges of the slit is about a sin θ ≈ aθ.

  1. Straight ahead (θ = 0) all wavelets arrive in phase: the central maximum.
  2. At θ = λ/a the path difference between the edges is λ. Split the slit into two halves: each point in the upper half has a partner in the lower half a distance a/2 below, with path difference λ/2. Every pair cancels, so the intensity is zero: the first minimum.
  3. At θ = 2λ/a split the slit into four quarters; neighbouring quarters cancel in the same way: the second minimum.
  4. At θ ≈ 3λ/(2a), split the slit into three thirds: two thirds cancel and one third is left over, giving a weak secondary maximum.

Single slit of width a: minima at θ ≈ nλ/a (n = ±1, ±2, …); secondary maxima at θ ≈ (n + ½)λ/a; central maximum angular width 2λ/a, linear width 2λD/a on a screen at distance D.

Interference and diffraction

  • Young's double-slit interference
    • Superposition of waves from two coherent slits
    • Fringes of equal width
    • All bright fringes of nearly equal intensity
    • Central bright fringe same width as the others
  • Single-slit diffraction
    • Superposition of wavelets from all points of one slit
    • Central maximum twice as wide as the others
    • Secondary maxima much weaker, fading outwards
    • Narrower slit gives a wider pattern

Physicists agree there is no deep physical difference between the two: both are superposition. The word interference is usually used for a few sources and diffraction for very many. In fact the pattern of a real double slit is the double-slit interference pattern lying within the single-slit diffraction pattern of each slit. In both, light energy is only redistributed, never created or destroyed.

You can see single-slit diffraction yourself. Hold two razor blades with their edges parallel and nearly touching, and look through the narrow gap at a clear bulb with a straight filament kept parallel to the slit. Bands appear; with a red filter they are wider than with a blue one, because the pattern spreads in proportion to λ. Never look at the Sun this way: it damages the eye.

Worked example 1: single slit

Light of wavelength 600 nm falls on a slit of width 0.20 mm; the screen is 2.0 m away. First minimum: θ = λ/a = (600 × 10⁻⁹)/(0.20 × 10⁻³) = 3.0 × 10⁻³ rad. Its distance from the centre is y = Dθ = 2.0 × 3.0 × 10⁻³ m = 6.0 mm. Width of the central maximum: 2 × 6.0 = 12 mm.

Polarisation

Shake one end of a long string up and down: a wave runs along the string (the x-direction) while each point moves only along y. Its displacement is y(x, t) = a sin(kx − ωt), where k = 2π/λ and ω = 2πν. Since the displacement is perpendicular to the direction of travel the wave is transverse; since each point moves along one straight line, in one plane (x-y), it is linearly or plane polarised. If the plane of vibration keeps changing randomly, the wave is unpolarised.

Light is a transverse wave: its electric field always vibrates perpendicular to its direction of travel. Ordinary light (sunlight, a lamp) is unpolarised: the electric field direction changes rapidly and randomly in the transverse plane. A polaroid is a sheet of long-chain molecules lined up in one direction; it absorbs the electric field component along the molecules and passes the component perpendicular to them. That direction is its pass-axis.

Unpolarised light through two polaroids

  1. Unpolarised light, intensity I Electric field in all transverse directions.
  2. Polaroid P₁ Passes only the component along its pass-axis: intensity I/2, linearly polarised.
  3. Polaroid P₂ at angle θ to P₁ Passes the component E cos θ.
  4. Emerging light Intensity (I/2) cos²θ: maximum at 0°, zero at 90°.

A single polaroid always transmits half the intensity of unpolarised light, whichever way it is turned. Put a second polaroid after it and turn it: the transmitted light varies from full (axes parallel) to almost nothing (axes crossed at 90°). If the polarised light from the first polaroid has intensity I₀, the second passes the field component E cos θ, so the intensity becomes:

Malus' law: I = I₀ cos²θ, where θ is the angle between the pass-axes. A single polaroid transmits half of unpolarised light.

This experiment works only because light is transverse; longitudinal waves such as sound show interference and diffraction but cannot be polarised. Polaroids are used to control light intensity in sunglasses and windowpanes, and in cameras and 3D film systems.

Worked example 2: two polaroids

Unpolarised light of intensity 80 units passes through two polaroids whose axes are at 60°. After the first: 80/2 = 40 units. After the second: 40 × cos² 60° = 40 × 1/4 = 10 units.

Worked example 3: a polaroid between crossed polaroids

Polaroids P₁ and P₃ are crossed, so no light passes. A third polaroid P₂ is placed between them with its axis at θ to P₁. Let I₀ be the intensity after P₁. After P₂: I₀ cos²θ. P₃ is at (90° − θ) to P₂, so after P₃: I = I₀ cos²θ sin²θ = (I₀/4) sin²2θ. This is greatest when 2θ = 90°, i.e. θ = 45°, giving I₀/4. Surprisingly, adding a polaroid lets light through.

Key takeaways

  • Single slit: central maximum at θ = 0, minima at θ = nλ/a, weak secondary maxima in between.
  • Narrower slit or longer wavelength gives a wider pattern.
  • Polarisation proves light is transverse; a polaroid passes half of unpolarised light.
  • Malus' law: I = I₀ cos²θ.

Check your understanding

  1. 1. Light of wavelength 500 nm falls on a slit 0.10 mm wide. The angular position of the first minimum is

    1. 5.0 × 10⁻³ rad
    2. 2.5 × 10⁻³ rad
    3. 1.0 × 10⁻² rad
    4. 5.0 × 10⁻⁴ rad
    Show answer

    Answer: A. θ = λ/a = (500 × 10⁻⁹)/(0.10 × 10⁻³) = 5.0 × 10⁻³ rad.

  2. 2. If the width of a single slit is halved, the central maximum of the diffraction pattern

    1. becomes half as wide
    2. becomes twice as wide
    3. stays the same width
    4. disappears
    Show answer

    Answer: B. The angular width of the central maximum is 2λ/a. Halving a doubles 2λ/a, so the central maximum spreads to twice the width.

  3. 3. Unpolarised light of intensity 64 units passes through two polaroids whose pass-axes make an angle of 30°. The emerging intensity is

    1. 48 units
    2. 16 units
    3. 32 units
    4. 24 units
    Show answer

    Answer: D. First polaroid: 64/2 = 32 units. Second: 32 × cos² 30° = 32 × 3/4 = 24 units.

  4. 4. Which property of light is shown by polarisation but not by interference or diffraction?

    1. Light is a wave
    2. Light has a very small wavelength
    3. Light waves are transverse
    4. Light carries energy
    Show answer

    Answer: C. Interference and diffraction occur for all waves, including longitudinal sound waves. Only transverse waves can be polarised, so polarisation shows that light is transverse.

  5. 5. Assertion (A): In single-slit diffraction, the intensity is zero at an angle θ for which a sin θ = λ. Reason (R): At this angle the slit can be divided into two halves whose corresponding wavelets differ in path by λ/2 and cancel in pairs.

    1. Both A and R are true, and R is the correct explanation of A
    2. Both A and R are true, but R is not the correct explanation of A
    3. A is true, but R is false
    4. A is false, but R is true
    Show answer

    Answer: A. Both are true. When the edges differ in path by λ, each point in one half has a partner a/2 away in the other half with path difference λ/2. These pairs cancel, so the intensity is zero: R explains A.

Sign in to keep track of the lessons you finish.

Next lesson → Final self-assessment: Wave Optics

Privacy · Terms · Refunds · Delivery