Revision notes

Chapter 4 Electricity: Magnetic and Heating Effects: Foundation

The key points, rules to remember, tables and diagrams from all 5 lessons, on one page for quick revision. To keep a copy, use your browser's Print and choose "Save as PDF".

Lesson 1

The magnetic effect of electric current

What the compass shows
SwitchCurrent in the wireCompass needle
OFFNo currentPoints in its usual north-south direction
ONCurrent flowsTurns away (deflects) from its usual direction
OFF againCurrent stopsReturns to its usual direction

When an electric current flows through a conductor, it produces a magnetic field around it. This is the magnetic effect of electric current; the field disappears when the current stops.

From a chance observation to accepted science

  1. Notice A compass needle moves when a circuit is switched
  2. Investigate Repeat carefully, switching on and off, changing positions
  3. Be sure Rule out other causes; the current is the cause
  4. Publish Share the method and results
  5. Others repeat Independent scientists confirm and build on it

Key takeaways: a compass needle deflects near a wire only while current flows, showing that current produces a magnetic field. The field vanishes when the current stops. Oersted discovered this link in 1820; others repeated and confirmed it. The magnetic effect is the basis of electromagnets, bells, motors and loudspeakers.

Read the full lesson

Lesson 2

Electromagnets: making and controlling magnets with current

A current-carrying coil that behaves as a magnet is called an electromagnet; an iron core makes it much stronger.

Changing an electromagnet

  • Make it stronger
    • More current (for example, a battery of two cells instead of one)
    • More turns of wire in the coil
    • An iron core inside the coil
  • Reverse its poles
    • Reverse the direction of the current by swapping the cell connections
  • Switch it off
    • Stop the current; the magnetism disappears
Unlike a bar magnet, an electromagnet can be adjusted.
Results of changing one thing at a time (same coil design)
ChangeCompass deflectionClips picked up
One cell, no iron coreSmallFew or none
One cell, iron coreLargerSome
Two cells, iron coreLarger stillMore
Two cells, iron core, more turnsLargestMost

Electromagnet and permanent magnet

  • Electromagnet
    • Magnetic only while current flows
    • Strength can be changed
    • Poles can be reversed
    • Needs a source of electricity
  • Permanent (bar) magnet
    • Always magnetic
    • Fixed strength
    • Fixed poles
    • Needs no electricity

Key takeaways: an electromagnet is a current-carrying coil that acts as a magnet, usually with an iron core to strengthen it. It has north and south poles, found with a compass using 'unlike poles attract'. More current or more turns make it stronger; reversing the current reverses its poles; stopping the current switches it off. Earth's magnetism also comes from electric currents in its molten iron core.

Read the full lesson

Lesson 3

Using electromagnets: cranes, bells and motors

Working cycle of a lifting electromagnet

  1. Current ON The electromagnet becomes a strong magnet
  2. Lift Iron and steel scrap is attracted and lifted
  3. Move The crane swings to the drop point
  4. Current OFF The magnetism disappears and the scrap falls

Then back to step 1: Current ON

How an electric bell rings

  1. Press the switch Current flows through the electromagnet's coil
  2. Electromagnet pulls It attracts an iron strip attached to a hammer, which strikes the gong
  3. Circuit breaks Moving the strip separates a contact, so the current stops
  4. Strip springs back With no magnetism, the strip returns and touches the contact again, so current flows and the cycle repeats

Then back to step 1: Press the switch

Devices using the magnetic effect of current
DeviceWhat the magnetic effect does
Lifting electromagnetPicks up iron and steel, releases them when switched off
Electric bellRepeatedly pulls a hammer onto a gong
Electric motor (fan, mixer, pump)Produces turning motion
LoudspeakerMoves a cone back and forth to make sound

Electromagnets are useful because they can be switched on and off, and their strength can be controlled.

Key takeaways: lifting electromagnets pick up iron and steel when current flows and release them when it stops, which also sorts magnetic from non-magnetic metals. An electric bell's electromagnet breaks and remakes its own circuit, so the hammer strikes repeatedly. Motors and loudspeakers also depend on the magnetic effect. A weak cell gives too little current, so an electromagnet loses strength.

Read the full lesson

Lesson 4

The heating effect of electric current

When an electric current passes through a conductor, the conductor gets heated: this is the heating effect of electric current.

Heat produced in a wire depends on

  • Current
    • More current gives more heat
    • Two cells heat the wire more than one in the same time
  • Material
    • Nichrome heats more than copper of the same size
  • Thickness and length
    • These change the wire's resistance
  • Time
    • The longer the current flows, the more heat is produced
Change one factor at a time to test each.
Copper or nichrome?
JobBetter wireReason
Heating element of an ironNichromeHigher resistance, so more heat for the same current
Wires that carry current to appliancesCopperLow resistance, so little energy is wasted as heat

Key takeaways: resistance turns some electrical energy into heat, so current-carrying wires get warm. Heat produced increases with current and time and depends on the wire's material, thickness and length. Heating elements use high-resistance nichrome; connecting wires use low-resistance copper. Overheating can melt fittings and start fires, so use correctly rated wiring and safety devices.

Read the full lesson

Lesson 5

Cells and batteries: how they produce electricity

A Voltaic cell

  • Electrodes
    • Two different metals, for example copper and zinc
    • One becomes the positive terminal, the other the negative
  • Electrolyte
    • A liquid that conducts, such as a weak acid or salt solution
  • Container
    • Glass or plastic
Electricity comes from a chemical reaction.
Metal pairs and liquids that can make a cell
Electrode pairElectrolyte that works
Copper and zincWeak acid or salt solution
Copper and ironLemon juice or salt solution
Copper and aluminiumSalt solution

Dry cell and rechargeable battery

  • Dry cell
    • Paste electrolyte
    • Used once, then disposed of
    • Torches, remotes, clocks
  • Rechargeable battery
    • Can be recharged many times
    • Wears out slowly over years
    • Phones, laptops, vehicles, inverters

A cell produces electricity from a chemical reaction between two different electrodes and an electrolyte.

Key takeaways: a Voltaic cell has two different metal electrodes in an electrolyte; a chemical reaction produces current, and the cell dies when the chemicals are used up. Volta showed the electricity came from the metals and liquid, not the frog. A lemon cell works the same way. Dry cells use a paste electrolyte and are single-use; rechargeable batteries are reused many times. Used batteries belong in e-waste recycling.

Read the full lesson

Privacy · Terms · Refunds · Delivery