• Foundation
  • About 12 min
  • 5 practice questions

A river from source to mouth

Follow a river through its upper, middle and lower course and link the speed, work and landforms of each stage.

If something looks wrong, please tell us.

A river begins as a trickle in the hills and ends as a broad stream entering the sea. Along the way it changes its speed, its load and the landforms it makes. Understanding the three stages of a river helps you to answer many questions on landforms. The numbers used are made up for practice.

The three courses

Geographers divide the river's path into the upper course near the source, the middle course, and the lower course near the mouth. The source is where the river starts, the mouth is where it ends, and a tributary is a smaller stream that joins it. The place where two streams meet is a confluence.

River stages
CourseSlope and energyMain workTypical landforms
UpperSteep; energy used to cut downErosionV-shaped valley, rapids, waterfall, gorge
MiddleGentler; more water joinsErosion and carryingWider valley, meanders
LowerVery gentle; wide channelDepositionFlood plain, levees, oxbow lake, delta

Upper course

The river is small but flows fast down steep slopes. It carries boulders that grind the bed and cut the valley deeper, so the valley takes the shape of a V. Where hard rock lies over softer rock, the soft rock wears away faster and the water falls over the edge in a waterfall. Below it a deep plunge pool and later a steep-sided gorge may form.

Middle and lower course

Tributaries join, the river widens and the slope grows gentler. The water now swings from side to side in loops called meanders, eroding the outer bank and depositing on the inner bank. In the lower course the river is slow, wide and loaded with silt. In floods it spreads the silt on either side, building a flat flood plain, and heaps of silt along the banks form natural embankments called levees. If a meander loop is cut off, it becomes an oxbow lake. At the mouth, where the river slows on entering the sea, it drops its remaining silt and may split into many channels, building a triangular delta.

Worked example 1: which course?

A stream flows fast over boulders in a narrow V-shaped valley with a waterfall. These features show steep slopes and strong downward cutting, so it is the upper course. A wide, flat valley with big meanders and oxbow lakes shows the lower course.

Worked example 2: the gradient

A river falls 600 m over a length of 120 km. Gradient = fall / length = 600 / 120 = 5 m per km. If, in the lower course, it falls only 10 m over 100 km, the gradient is 10 / 100 = 0.1 m per km, which is fifty times gentler. The gentle slope is why the lower river is slow and deposits silt.

Worked example 3: how an oxbow lake forms

Step 1: the river erodes the outer bank of a meander and the loop grows. Step 2: the narrow neck of land between two loops is worn away until the river breaks through. Step 3: the river takes the short cut and silt seals off the old loop, leaving a curved oxbow lake.

Upper: V valley and waterfall. Middle: meanders. Lower: flood plain, levee, oxbow lake and delta. Fast and cutting above, slow and depositing below.

— Rule to remember

Key takeaways

  • Rivers have an upper, middle and lower course.
  • The upper course erodes down; the lower course deposits.
  • Meanders form in the middle and lower course; oxbow lakes, flood plains and deltas belong to the lower river.
  • Gradient is the fall divided by the length.

Check your understanding

  1. 1. A V-shaped valley with a waterfall is typical of the river's:

    1. Lower course
    2. Delta
    3. Upper course
    4. Mouth
    Show answer

    Answer: C. Steep slopes and downward cutting in the upper course make V-shaped valleys and waterfalls.

  2. 2. A river falls 300 m in 60 km. Its gradient is:

    1. 5 m per km
    2. 20 m per km
    3. 0.2 m per km
    4. 50 m per km
    Show answer

    Answer: A. Gradient = 300 / 60 = 5 m per km.

  3. 3. A curved lake left when a meander is cut off is an:

    1. Delta
    2. Gorge
    3. Oxbow lake
    4. Plunge pool
    Show answer

    Answer: C. When a meander loop is cut off from the river, it becomes an oxbow lake.

  4. 4. Natural embankments built by silt along the sides of a river are called:

    1. Deltas
    2. Meanders
    3. Confluences
    4. Levees
    Show answer

    Answer: D. Levees are ridges of silt built up along the banks in floods.

  5. 5. A delta forms where a river:

    1. Slows on meeting the sea and drops silt
    2. Begins as a small spring in hills
    3. Plunges over a cliff in the hills
    4. Is joined by another tributary stream
    Show answer

    Answer: A. On entering the sea the river slows and deposits silt, building a delta.

Privacy · Terms · Refunds · Delivery