• Practice
  • About 14 min
  • 5 practice questions

Finding where the time went in a mock

Use your checkpoints to compare planned and actual section times, spot time-sink questions, and estimate how many questions the lost minutes could have covered.

If something looks wrong, please tell us.

Many students lose more marks to the clock than to lack of knowledge. They spend four minutes on one stubborn question and then cannot reach five easy ones at the end. Time loss is invisible on the score card, so you have to dig it out. This lesson shows how, using the checkpoints you write during the mock.

Three kinds of time

Where the minutes go
Kind of timeMeaningWhat to do about it
ProductiveTime spent on questions you got rightLook for faster methods later, but this time was earned
LostTime on questions you got wrong or abandonedReduce through earlier decisions to move on
UnreachedQuestions you never saw because time ran outThe cost of lost time elsewhere

A time-sink is a question that took more than about twice your average time for its section and did not end in a correct answer. These are the first things to look for. Many online mocks show the time spent on each question; on a paper mock, put a small dot beside a question whenever you notice you have been on it too long, and use your checkpoints for the rest.

Worked example 1: Manish counts the cost

Suppose Manish sits a 60-minute paper with 100 questions. His review shows he spent about 3 minutes each on 10 long questions, a total of 10 × 3 = 30 minutes. Of those 10, he got 4 right, 3 wrong and abandoned 3. In the remaining 30 minutes he handled 50 other questions, an average of 30 × 60 ÷ 50 = 36 seconds each. He never reached the last 100 − 10 − 50 = 40 questions.

  1. Time on the 6 long questions that did not end correct: 6 × 3 = 18 minutes.
  2. At his normal pace of 36 seconds, 18 minutes is 18 × 60 ÷ 36 = 30 questions.
  3. So the time sunk into 6 failed questions could have let him see 30 of the 40 questions he never reached.

Decision: he sets a personal limit of 90 seconds on a first look. If a question is not clearly moving towards an answer by then, he marks it and moves on, returning only if time is left.

Worked example 2: Lata's checkpoints

Lata's 60-minute mock has four sections of 25 questions. She planned to finish each section in 15 minutes. Her checkpoints show:

Planned versus actual (22 + 14 + 14 + 10 = 60)
SectionPlanned endActual endMinutes usedTime per question
115 min22 min22about 53 s
230 min36 min14about 34 s
345 min50 min14about 34 s
460 min60 min1024 s

Section 1 overran by 22 − 15 = 7 minutes, and section 4 paid for it with only 10 minutes for 25 questions, 10 × 60 ÷ 25 = 24 seconds each, so she skipped many questions there that she could normally do. Fix: she allows section 1 a maximum of 17 minutes, a little more than planned because it is her slowest, and when the 17th minute arrives she moves on whatever is left. That leaves 43 minutes for the other three sections instead of 38.

Lost time is paid for at the end of the paper. Find the time-sinks, and set a move-on limit before the next mock.

Key takeaways

  • Split mock time into productive, lost and unreached.
  • A time-sink is a question taking about twice your average that did not end correct.
  • Convert lost minutes into 'questions I could have seen' to feel their real cost.
  • Compare planned and actual checkpoints; cap the section that overruns.

Check your understanding

  1. 1. Which question is a time-sink by this lesson's definition?

    1. One that took twice your average time and was answered correctly in the end
    2. One that you skipped after five seconds
    3. One that took about three times your average and was answered wrongly
    4. One that took less than your average and was wrong
    Show answer

    Answer: C. A time-sink takes about twice your average or more and does not end in a correct answer. A slow but correct answer is productive time.

  2. 2. A student lost 12 minutes on failed questions. Her normal pace is 40 seconds a question. How many questions could that time have covered?

    1. 18
    2. 30
    3. 12
    4. 24
    Show answer

    Answer: A. 12 minutes = 720 seconds. 720 ÷ 40 = 18 questions.

  3. 3. Lata planned to finish section 1 at 15 minutes but finished at 22. By how much did she overrun?

    1. 22 minutes
    2. 15 minutes
    3. 37 minutes
    4. 7 minutes
    Show answer

    Answer: D. 22 − 15 = 7 minutes.

  4. 4. In the lesson's terms, what is 'unreached' time?

    1. Time spent on questions you got right
    2. Questions you never saw because the time ran out
    3. Time spent reading the instructions before the start
    4. Time left over at the end of the paper
    Show answer

    Answer: B. Unreached questions are the cost paid at the end for time lost elsewhere in the paper.

  5. 5. Section 4 had 10 minutes for 25 questions. What was the average time per question?

    1. 40 seconds
    2. 25 seconds
    3. 2.5 minutes
    4. 24 seconds
    Show answer

    Answer: D. 10 minutes = 600 seconds. 600 ÷ 25 = 24 seconds.

Privacy · Terms · Refunds · Delivery