• Practice
  • About 14 min
  • 5 practice questions

Plant growth: growth rates, phases and plasticity

Tell arithmetic from geometric growth, calculate absolute and relative growth rates, read a sigmoid growth curve, and use differentiation, dedifferentiation and plasticity correctly.

If something looks wrong, please tell us.

Growth questions mix vocabulary with small calculations, and the calculations are easier than they look. You only need to separate three ideas: how fast something grows, how fast it grows compared with its own size, and what stage of the growth curve it is in. In this lesson every number is made up for practice; it is not data from any real plant.

What growth is, and where it happens

Growth is a permanent, irreversible increase in the size of a cell, an organ or the whole organism. It can be measured as increase in length, fresh mass, dry mass, area, volume or cell number. In plants, growth is open: it continues through life because meristems keep producing new cells, unlike most animals, whose growth stops at a limit. Plant growth in a given region has three phases: a meristematic phase (cell division), an elongation phase (cells enlarge, with a large vacuole and new wall material) and a maturation phase (cells reach final size and structure).

Arithmetic and geometric growth

Two patterns of growth
FeatureArithmetic growthGeometric growth
What happens at each divisionOnly one daughter cell keeps dividing; the other maturesBoth daughter cells keep dividing
RateConstant (same increase in each time unit)Slow at first, then ever faster, then slows
Graph of size against timeStraight lineS-shaped (sigmoid) curve
Typical exampleA root tip lengthening at a steady rateCell number in a young embryo or culture

The S-shaped curve has three parts: a lag phase (slow start), a log or exponential phase (the fastest increase, since more cells are dividing) and a stationary phase (growth slows and stops because nutrients or space run short). Geometric growth is written W1 = W0 e^(rt), where W0 is the starting size, r the relative growth rate and t the time.

Absolute and relative growth rate

Absolute growth rate is the total increase in a given time, for example 3 cm per day. Relative growth rate is the increase per unit of the starting size: increase ÷ starting size. A small seedling that adds little can still have the higher relative rate, so the two can give opposite rankings.

Worked example 1: arithmetic growth

A root tip lengthens from 2.0 cm to 8.0 cm in 6 days at a constant rate (illustrative). Step 1: rate = (8.0 − 2.0) ÷ 6 = 1.0 cm per day. Step 2: length after 10 days from the start = 2.0 + 1.0 × 10 = 12.0 cm. Because the growth is arithmetic, the same rate applies in every day; no compounding is needed.

Worked example 2: absolute versus relative

Seedling A grows from 10 cm to 12 cm in one day; seedling B grows from 20 cm to 23 cm in the same day. Absolute rates: A = 2 cm per day, B = 3 cm per day, so B is faster. Relative rates: A = 2 ÷ 10 = 0.20, that is 20 per cent per day; B = 3 ÷ 20 = 0.15, that is 15 per cent per day. A has the higher relative growth rate even though B adds more length.

Worked example 3: reading a growth table

Dry mass of a seedling (illustrative) was 2, 3, 5, 10, 20, 35, 50, 56, 58 and 58 mg on days 0, 2, 4, 6, 8, 10, 12, 14, 16 and 18. The gains in successive two-day intervals are 1, 2, 5, 10, 15, 15, 6, 2 and 0 mg. The gains are tiny at first (lag phase), rise quickly to a maximum of 15 mg (log phase, days 8 to 12), then fall to zero (stationary phase). Plotted, the curve is sigmoid, so the growth is geometric overall.

Differentiation and plasticity

Cells made by meristems differentiate into the permanent tissues. Some living differentiated cells can regain the power to divide: this is dedifferentiation, as when interfascicular cambium forms from parenchyma between vascular bundles, or cork cambium forms from cortex cells. The new cells formed can then differentiate again, which is redifferentiation. Plasticity is the ability of a plant to form different structures in different conditions or stages of life. The leaves of cotton and coriander differ between juvenile and mature plants (heterophylly), and buttercup leaves differ in air and in water.

Growth needs water, oxygen, nutrients, suitable temperature and light. Relative rate = increase ÷ starting size: compare plants by relative rate, not by absolute increase.

Key takeaways. Growth is irreversible and, in plants, open. Arithmetic growth is linear; geometric growth is sigmoid with lag, log and stationary phases. Absolute and relative rates can rank organisms differently. Dedifferentiation restores division; redifferentiation follows it; heterophylly is one form of plasticity.

Check your understanding

  1. 1. Which of these shows arithmetic growth?

    1. Cell number rising slowly, then rapidly, then levelling off
    2. Both daughter cells dividing at every division
    3. A root tip lengthening by the same amount each day
    4. A culture doubling in number every few hours
    Show answer

    Answer: C. In arithmetic growth only one daughter cell keeps dividing, so the increase per unit time is constant and the graph of length against time is a straight line. The other options describe geometric growth.

  2. 2. Seedling P grows from 5 cm to 6 cm in a day; seedling Q grows from 40 cm to 42 cm in a day. Which statement is correct?

    1. P has the higher absolute and higher relative rate
    2. Q has the higher absolute rate and P the higher relative rate
    3. P has the higher absolute rate and Q the higher relative rate
    4. Q has the higher absolute and higher relative rate
    Show answer

    Answer: B. Absolute: P = 1 cm, Q = 2 cm, so Q is faster. Relative: P = 1 ÷ 5 = 0.20, Q = 2 ÷ 40 = 0.05, so P is higher in relative terms.

  3. 3. Formation of cork cambium from living cortex cells is an example of:

    1. Redifferentiation of a meristem
    2. Dedifferentiation of permanent cells
    3. Heterophylly in a mature stem
    4. Arithmetic growth of the cambium
    Show answer

    Answer: B. Mature cortex cells are differentiated but still living. When they regain the ability to divide and form a meristem, the process is dedifferentiation.

  4. 4. A culture starts with 100 cells and the number doubles every 4 hours (illustrative). How many cells are present after 12 hours?

    1. 400
    2. 800
    3. 1200
    4. 1600
    Show answer

    Answer: B. 12 hours is 3 doubling periods of 4 hours. 100 × 2 × 2 × 2 = 800 cells. Adding 100 per period (400) would be arithmetic, not geometric.

  5. 5. Different leaf shapes on the juvenile and mature parts of a coriander plant are an example of:

    1. Vernalisation by cold
    2. Dormancy of the shoot bud
    3. Heterophylly in the plant
    4. Photoperiodism in the leaves
    Show answer

    Answer: C. Heterophylly means different leaf forms on one plant at different stages or in different environments. It is one expression of plasticity of development.

Privacy · Terms · Refunds · Delivery