• Foundation
  • About 18 min
  • 5 practice questions

Mass movements, landslides, erosion and deposition

Explain mass movements and the conditions and causes that trigger them, classify landslides, compare landslide risk in the Himalayas and the Western Ghats, and describe erosion, its agents and deposition.

If something looks wrong, please tell us.

By the end of this lesson you can

  • Explain how mass movements differ from erosion and list their favourable conditions and activating causes.
  • Distinguish slump, debris slide, debris fall, rockslide and rock fall.
  • Explain erosion and deposition and classify agents as climate-controlled or not.

Weathered material does not stay on slopes forever. Gravity pulls it down, and agents such as rivers and wind carry it away. This lesson covers both kinds of movement.

Mass movements

Mass movements transfer masses of rock debris down slopes under the direct influence of gravity. Air, water or ice do not carry the debris; rather, the debris may carry air, water or ice with it. Movements range from slow to rapid, affect shallow to deep columns, and include creep, flow, slide and fall. Because gravity acts on all matter, weathering is not a pre-requisite for mass movement, though it aids it; mass movements are much more active on weathered slopes. Since no geomorphic agent takes part, mass movements do not come under erosion, even though material shifts from one place to another.

Materials on slopes resist disturbing forces and move only when the force exceeds their shearing resistance. Conditions that favour mass movement: weak unconsolidated materials, thinly bedded rocks, faults, steeply dipping beds, vertical cliffs or steep slopes, abundant precipitation and torrential rains, and scarcity of vegetation.

Activating causes

  1. Removal of support from below, naturally or artificially.
  2. Increase in the gradient and height of slopes.
  3. Overloading by adding material naturally or by artificial filling.
  4. Overloading by heavy rainfall, saturation and lubrication of slope materials.
  5. Removal of material or load from the original slope surface.
  6. Earthquakes, explosions or machinery.
  7. Excessive natural seepage.
  8. Heavy drawdown of water from lakes, reservoirs and rivers, so water flows slowly out from under slopes or banks.
  9. Indiscriminate removal of natural vegetation.

The three forms of movement are heave (heaving up of soil, for example by frost growth), flow and slide. A debris avalanche, a rapid downslope rush of wet debris, is generally classed among rapid flow movements.

Landslides

Landslides are relatively rapid and perceptible movements of relatively dry material. The size and shape of the mass depend on discontinuities in the rock, the degree of weathering and the steepness of slope.

Types of landslides

  • Slump One or several units of debris slip with a backward rotation relative to the slope.
  • Debris slide Rapid rolling or sliding of earth debris without backward rotation.
  • Debris fall Nearly free fall of debris from a vertical or overhanging face.
  • Rockslide Sliding of rock masses down bedding, joint or fault surfaces; fast and destructive on steep slopes; affects material to a substantial depth.
  • Rock fall Free fall of rock blocks from the superficial layers of any steep slope, keeping away from the slope.

Landslides in India

Why landslides happen in two Indian hill regions

  • Himalayas: very frequent
    • Tectonically active
    • Mostly sedimentary rocks and unconsolidated or semi-consolidated deposits
    • Very steep slopes
  • Western Ghats and Nilgiris: less frequent
    • Relatively stable, very hard rocks
    • Steep slopes with almost vertical cliffs and escarpments
    • Strong mechanical weathering from temperature changes
    • Heavy rain over short periods; frequent rock falls

Erosion

Erosion involves the acquisition and transportation of rock debris. Agents such as running water, groundwater, glaciers, wind and waves remove and carry broken material. Abrasion by the debris they carry greatly aids erosion. By erosion, relief degrades: the landscape is worn down. Weathering aids erosion but is not a pre-condition for it. Weathering, mass wasting and erosion are degradational processes, and erosion is largely responsible for the continuous changes on the earth's surface. Erosion and transportation are controlled by kinetic energy.

Agents of erosion

  • Controlled by climate
    • Wind: gaseous state
    • Running water: liquid state
    • Glaciers: solid state
  • Not controlled by climate
    • Waves: work decided by location at the land-sea interface (coasts)
    • Groundwater: work decided by the rocks; karst forms where rocks are permeable and soluble and water is available

Deposition

Deposition is a consequence of erosion. On gentler slopes the agents lose velocity and energy, and the material they carry settles. So deposition is not actually the work of any agent. Coarser materials are deposited first and finer ones later. Deposition fills depressions. The same agents, running water, glaciers, wind, waves and groundwater, therefore act as aggradational or depositional agents too.

Mass movement is driven by gravity alone, with no agent; erosion needs an agent that picks up and carries debris; deposition happens when the agent loses energy, coarse material first.

Worked example 1: mass movement or erosion?

Classify: (i) a block of rock breaks off a cliff and falls; (ii) a river carries sand downstream; (iii) soil on a hillside slowly creeps downhill; (iv) wind lifts dust from a dry field. Reasoning: if gravity alone moves the material, it is mass movement; if an agent picks it up and carries it, it is erosion. Answers: (i) mass movement (rock fall); (ii) erosion; (iii) mass movement (creep); (iv) erosion.

Worked example 2: sorting of deposits

A made-up stream entering a flat plain carries gravel, sand and clay. In what order are they deposited along its path? Reasoning: as velocity falls, the stream can no longer carry the heaviest particles first. Answer: gravel first, near where the slope eases; then sand; then clay farthest away or in still water. This illustrates the rule that coarser materials settle first.

Key takeaways: mass movements carry debris downslope by gravity alone, so they are not erosion; they are favoured by weak materials, steep slopes, heavy rain and lack of vegetation and set off by causes such as undercutting, overloading, earthquakes and deforestation. Landslides are rapid, perceptible movements of dry material: slump, debris slide, debris fall, rockslide and rock fall. Landslides are frequent in the tectonically active Himalayas and also occur in the steep, rain-soaked Western Ghats and Nilgiris. Erosion is acquisition and transport of debris by agents; wind, running water and glaciers are climate-controlled, waves and groundwater are not. Deposition follows loss of energy, coarse material first.

Check your understanding

  1. 1. Mass movements do not come under erosion because:

    1. they never move any material
    2. no geomorphic agent like running water or wind takes part; gravity alone moves the debris
    3. they happen only on flat land
    4. they need weathered rock
    Show answer

    Answer: B. In mass movements debris moves directly under gravity, without an agent carrying it, so they are not counted as erosion.

  2. 2. Slipping of units of rock debris with a backward rotation with respect to the slope is called:

    1. rock fall
    2. debris slide
    3. slump
    4. debris fall
    Show answer

    Answer: C. A slump is slipping of one or several units of rock debris with backward rotation; a debris slide has no backward rotation.

  3. 3. Debris avalanche can be included in the category of:

    1. slow flow mass movements
    2. subsidence
    3. deposition
    4. rapid flow mass movements
    Show answer

    Answer: D. A debris avalanche is a rapid downslope flow of debris, so it belongs with rapid flow mass movements.

  4. 4. Which agent of erosion is NOT controlled by climate?

    1. Waves
    2. Wind
    3. Glaciers
    4. Running water
    Show answer

    Answer: A. Wind, running water and glaciers are climate-controlled. The work of waves depends on location along coasts and that of groundwater on the rocks.

  5. 5. Assertion (A): Landslides and debris avalanches are very frequent in the Himalayas.
    Reason (R): The Himalayas are tectonically active, mostly made of sedimentary rocks and unconsolidated deposits, and have very steep slopes.

    1. A is true but R is false.
    2. Both A and R are true, and R is the correct explanation of A.
    3. A is false but R is true.
    4. Both A and R are false.
    Show answer

    Answer: B. The chapter gives exactly these reasons for the frequency of landslides and debris avalanches in the Himalayas. R explains A.

Privacy · Terms · Refunds · Delivery