Revision notes

Unit 4 Hydrogen: Foundation

The key points, rules to remember, tables and diagrams from all 5 lessons, on one page for quick revision. To keep a copy, use your browser's Print and choose "Save as PDF".

Lesson 1

Hydrogen: its place in the periodic table, isotopes and spin isomers

Hydrogen compared with alkali metals and halogens

  • Like the alkali metals
    • Configuration 1s¹, like ns¹
    • Forms a positive ion, H⁺, like Na⁺ and K⁺
    • Forms halides HX, oxide H₂O, peroxide H₂O₂ and sulphide H₂S, like NaX, Na₂O, Na₂O₂, Na₂S
    • Acts as a reducing agent
  • Like the halogens
    • Is one electron short of a noble-gas configuration
    • Gains one electron to form the hydride ion H⁻, with helium's configuration
    • Forms a diatomic molecule, like Cl₂
  • Unlike either
    • Ionisation energy about 1312 kJ mol⁻¹, far above the alkali metals (roughly 377-520 kJ mol⁻¹)
    • Electron affinity much lower than the halogens', so H⁻ forms far less readily than X⁻
The isotopes of hydrogen
PropertyProtium, ¹₁H (H)Deuterium, ²₁H (D)Tritium, ³₁H (T)
Neutrons012
Atomic mass (u)1.0082.0143.016
Natural abundanceAbout 99.985%About 0.015%Traces, about 1 atom in 10¹⁸
Nuclear stabilityStableStableRadioactive, β-emitter, half-life 12.3 years

Ortho-H₂: nuclear spins parallel. Para-H₂: nuclear spins opposite. Room temperature: about 3 : 1 ortho : para; low temperature favours para.

— Spin isomers of hydrogen

Key takeaways: hydrogen resembles both alkali metals (1s¹, H⁺, reducing agent) and halogens (H⁻, diatomic), but its high ionisation energy and low electron affinity set it apart; it is placed in group 1 because it is usually +1. Protium, deuterium and tritium have 0, 1 and 2 neutrons; tritium is radioactive with a 12.3-year half-life. Ortho- and para-hydrogen differ in nuclear spin.

Read the full lesson

Lesson 2

Preparation, properties and uses of hydrogen

Hydrogen from methane on an industrial scale

  1. Steam reforming CH₄ + H₂O → CO + 3H₂ over Ni at 800-900 °C.
  2. Shift reaction CO + H₂O → CO₂ + H₂ over Fe-Cu at about 400 °C.
  3. Remove CO₂ Absorbed by K₂CO₃ solution as KHCO₃.
  4. Hydrogen Ready for ammonia, methanol or hydrogenation.

Key takeaways: pure hydrogen comes from electrolysis, laboratory hydrogen from metals and dilute acids, and industrial hydrogen from steam reforming, water gas and the shift reaction. Deuterium is concentrated by electrolysis of water; tritium is made from lithium-6 and neutrons. Hydrogen burns to water, forms HX with halogens and MH hydrides with active metals, and adds to unsaturated compounds.

Read the full lesson

Lesson 3

Water: properties, reactions and hard and soft water

Types of hardness and how to remove them

  • Temporary hardness
    • Caused by Ca(HCO₃)₂ and Mg(HCO₃)₂
    • Removed by boiling and filtering
    • Or by Clark's method: adding a calculated amount of lime
  • Permanent hardness
    • Caused by chlorides and sulphates of Ca and Mg
    • Removed by washing soda, Na₂CO₃
    • Or by ion exchange with zeolite or resin

Key takeaways: hydrogen bonding gives water its high melting and boiling points. Water reacts with active metals to give hydrogen, with chlorine to give HCl and HOCl, and with fluorine to give oxygen; it is amphoteric and hydrolyses covalent halides and oxides. Temporary hardness (bicarbonates) goes on boiling or with lime; permanent hardness (chlorides, sulphates) needs washing soda or ion exchange.

Read the full lesson

Lesson 4

Heavy water and hydrogen peroxide

Water and heavy water compared (values given in the textbook)
Property (at 298 K unless stated)H₂OD₂O
Molar mass (g mol⁻¹)18.01520.028
Melting point (K)273.0276.8
Boiling point (K)373.0374.4
Temperature of maximum density (K)277.0284.2
Density (g cm⁻³)0.9971.104

Molarity of H₂O₂ = volume strength ÷ 11.2, because 1 mol of H₂O₂ gives ½ mol O₂ = 11.2 L at 273 K and 1 atm.

— Volume strength shortcut

H₂O₂ as oxidant and as reductant

  • Oxidising agent
    • Usually in acidic medium
    • H₂O₂ + 2H⁺ + 2e⁻ → 2H₂O
    • Fe²⁺ → Fe³⁺; PbS → PbSO₄
  • Reducing agent
    • Usually in basic medium
    • HO₂⁻ + OH⁻ → O₂ + H₂O + 2e⁻
    • MnO₄⁻ → MnO₂, with O₂ given off

Key takeaways: D₂O is denser and boils and melts higher than H₂O; it exchanges with ionisable hydrogens and is a moderator, coolant and tracer. H₂O₂ is made from peroxides and acid or by anthraquinol autoxidation; molarity = volume strength ÷ 11.2. It oxidises in acid and reduces in base, is a clean bleach and antiseptic, and has a non-planar open-book structure.

Read the full lesson

Lesson 5

Hydrides, hydrogen bonding and hydrogen as a fuel

Classification of hydrides

  • Ionic (saline) hydrides
    • Alkali and alkaline earth metals (not Be, Mg)
    • Made from the elements at about 400 °C
    • Salt-like white crystalline solids containing H⁻
    • Examples: LiH, NaH, CaH₂
  • Covalent (molecular) hydrides
    • Electron-precise: CH₄, C₂H₆, SiH₄, GeH₄
    • Electron-deficient: B₂H₆
    • Electron-rich (lone pairs): NH₃, H₂O
    • Usually gases or volatile liquids
  • Metallic (interstitial) hydrides
    • Hydrogen in voids of a metal lattice
    • Often non-stoichiometric: TiH₁.₅₋₁.₈, PdH₀.₆₋₀.₈
    • Properties like the parent metal
    • Useful for hydrogen storage

Strength: covalent bond (> 100 kJ mol⁻¹) > hydrogen bond (about 20-50 kJ mol⁻¹) > van der Waals forces (< 20 kJ mol⁻¹)

— Comparing attractions

Two kinds of hydrogen bond

  • Intramolecular
    • Within one molecule
    • Examples: ortho-nitrophenol, salicylaldehyde
    • Forms a ring inside the molecule
  • Intermolecular
    • Between two or more molecules, alike or different
    • Examples: water with water, ammonia with ammonia, ammonia with water
    • Links molecules into larger groups

Key takeaways: hydrides are ionic (with s-block metals, containing H⁻), covalent (electron-precise, electron-deficient or electron-rich) or metallic (interstitial, often non-stoichiometric). A hydrogen bond forms between H bonded to F, O or N and another electronegative atom; it is intermediate in strength. Hydrogen bonding explains water's high boiling point, ice's low density and DNA's double strand. Hydrogen is a clean fuel with real storage problems.

Read the full lesson

Privacy · Terms · Refunds · Delivery