• Practice
  • About 25 min
  • 5 practice questions

Water: properties, reactions and hard and soft water

Explain water's unusual physical properties through hydrogen bonding, write its reactions with metals, non-metals and compounds, describe hydrated salts, and remove temporary and permanent hardness with full equations.

If something looks wrong, please tell us.

By the end of this lesson you can

  • Relate the high melting and boiling points of water to hydrogen bonding.
  • Write the reactions of water with metals, halogens and covalent compounds, and show water acting as an acid and as a base.
  • Describe how water is held in hydrated salts.
  • Distinguish temporary and permanent hardness and write equations for their removal.

Water covers about 70% of the earth's surface and makes up about 65% of the human body (figures given in the textbook). Sea water holds too many dissolved salts to be used directly. Water's behaviour, both physical and chemical, explains much of what happens around us.

Physical properties

Water is a colourless, volatile liquid. Its unusual properties in the liquid and solid states come from intermolecular hydrogen bonding between molecules, which gives water much higher melting and boiling points than other hydrides of its size, such as H₂S.

Chemical properties

  • Alkali metals decompose water even in the cold: 2Na + 2H₂O → 2NaOH + H₂ (Na 2; O 2; H 4 = 2 + 2).
  • Group 2 metals (except beryllium) react similarly but less violently, giving less soluble hydroxides: Ba + 2H₂O → Ba(OH)₂ + H₂.
  • Some transition metals react with hot water or steam: 3Fe + 4H₂O → Fe₃O₄ + 4H₂ (Fe 3; O 4; H 8). Lead and copper react only at white heat; silver, gold, mercury and platinum do not react.
  • Non-metals such as carbon, sulphur and phosphorus normally do not react, though red-hot carbon gives water gas with steam.
  • Halogens give acidic solutions: Cl₂ + H₂O → HCl + HOCl. Hypochlorous acid explains the bleaching and germ-killing action of chlorine water. Fluorine instead liberates oxygen: 2F₂ + 2H₂O → 4HF + O₂.
  • Salts of weak acids give slightly alkaline solutions: CO₃²⁻ + H₂O → HCO₃⁻ + OH⁻.

Water is amphoteric: it can accept or donate a proton. With HCl it acts as a base, accepting H⁺: HCl + H₂O → H₃O⁺ + Cl⁻. With ammonia it acts as an acid, donating H⁺: NH₃ + H₂O → NH₄⁺ + OH⁻. Water dissolves ionic compounds and hydrolyses some covalent ones: SiCl₄ + 2H₂O → SiO₂ + 4HCl (Si 1; Cl 4; H 4; O 2) and P₄O₁₀ + 6H₂O → 4H₃PO₄ (P 4; O 10 + 6 = 16 = 4 × 4; H 12).

Water in hydrated salts

Many salts crystallise from water as hydrates, with water either bonded to the metal ion by coordinate bonds or simply sitting in spaces in the crystal. In [Cr(H₂O)₆]Cl₃ all six water molecules are coordinated to chromium. In BaCl₂·2H₂O both water molecules occupy interstitial positions. In CuSO₄·5H₂O, written [Cu(H₂O)₄]SO₄·H₂O, four water molecules are coordinated to Cu²⁺ and the fifth lies outside, held by hydrogen bonds.

Hard and soft water

Hard water contains dissolved calcium and magnesium salts (and sometimes iron, aluminium or manganese) as bicarbonates, chlorides and sulphates. Soft water is free of soluble calcium and magnesium salts. Hard water forms little lather with soap, because Ca²⁺ and Mg²⁺ turn the soluble sodium soap into an insoluble scum: M²⁺ + 2RCOONa → (RCOO)₂M + 2Na⁺ (M = Ca or Mg; R = C₁₇H₃₅).

Types of hardness and how to remove them

  • Temporary hardness
    • Caused by Ca(HCO₃)₂ and Mg(HCO₃)₂
    • Removed by boiling and filtering
    • Or by Clark's method: adding a calculated amount of lime
  • Permanent hardness
    • Caused by chlorides and sulphates of Ca and Mg
    • Removed by washing soda, Na₂CO₃
    • Or by ion exchange with zeolite or resin

Removing temporary hardness

  • Boiling: Ca(HCO₃)₂ → CaCO₃ + H₂O + CO₂ and Mg(HCO₃)₂ → MgCO₃ + H₂O + CO₂; the MgCO₃ is then hydrolysed: MgCO₃ + H₂O → Mg(OH)₂ + CO₂. The precipitates are filtered off.
  • Clark's method: Ca(HCO₃)₂ + Ca(OH)₂ → 2CaCO₃ + 2H₂O and Mg(HCO₃)₂ + 2Ca(OH)₂ → 2CaCO₃ + Mg(OH)₂ + 2H₂O (check the second: Ca 2 = 2; Mg 1 = 1; C 2 = 2; O 6 + 4 = 10 = 6 + 2 + 2; H 2 + 4 = 6 = 2 + 4).

Removing permanent hardness

  • Washing soda: MCl₂ + Na₂CO₃ → MCO₃ + 2NaCl and MSO₄ + Na₂CO₃ → MCO₃ + Na₂SO₄, where M is Ca or Mg; the carbonates precipitate.
  • Ion exchange: zeolites are hydrated sodium aluminosilicates, Na₂O·Al₂O₃·xSiO₂·yH₂O (x = 2 to 10, y = 2 to 6), with loosely held Na⁺ ions. Writing the zeolite as Na₂-Z: Na₂-Z + M²⁺ → M-Z + 2Na⁺. When exhausted, it is regenerated with sodium chloride solution: M-Z + 2NaCl → Na₂-Z + MCl₂. Ion-exchange resins work the same way.

Worked example 1: washing soda needed

A sample of hard water contains 1.11 g of CaCl₂. What mass of washing soda (anhydrous Na₂CO₃) removes it? Working: M(CaCl₂) = 40 + 71 = 111 g mol⁻¹, so n = 1.11 ÷ 111 = 0.01 mol. CaCl₂ + Na₂CO₃ → CaCO₃ + 2NaCl, so 0.01 mol Na₂CO₃ is needed; M(Na₂CO₃) = 106 g mol⁻¹; mass = 0.01 × 106 = 1.06 g.

Worked example 2: Clark's method

Water contains 1.62 g of Ca(HCO₃)₂. Working: M = 40 + 2 × (1 + 12 + 48) = 40 + 122 = 162 g mol⁻¹, so n = 0.01 mol. It needs 0.01 mol Ca(OH)₂ = 0.01 × 74 = 0.74 g of slaked lime, and gives 2 × 0.01 = 0.02 mol CaCO₃ = 0.02 × 100 = 2.0 g of precipitate.

Key takeaways: hydrogen bonding gives water its high melting and boiling points. Water reacts with active metals to give hydrogen, with chlorine to give HCl and HOCl, and with fluorine to give oxygen; it is amphoteric and hydrolyses covalent halides and oxides. Temporary hardness (bicarbonates) goes on boiling or with lime; permanent hardness (chlorides, sulphates) needs washing soda or ion exchange.

Check your understanding

  1. 1. What causes temporary hardness of water?

    1. Soluble bicarbonates of calcium and magnesium
    2. Chlorides of calcium and magnesium
    3. Sulphates of calcium and magnesium
    4. Dissolved sodium chloride
    Show answer

    Answer: A. Temporary hardness is due to Ca(HCO₃)₂ and Mg(HCO₃)₂, which decompose on boiling into insoluble carbonates (and Mg(OH)₂). Chlorides and sulphates cause permanent hardness.

  2. 2. What mass of anhydrous washing soda is needed to remove 0.95 g of MgCl₂ from hard water? (Mg = 24, Cl = 35.5, Na₂CO₃ = 106)

    1. 0.53 g
    2. 2.12 g
    3. 1.06 g
    4. 0.95 g
    Show answer

    Answer: C. M(MgCl₂) = 24 + 71 = 95 g mol⁻¹, so n = 0.95 ÷ 95 = 0.01 mol. MgCl₂ + Na₂CO₃ → MgCO₃ + 2NaCl needs 0.01 mol Na₂CO₃ = 0.01 × 106 = 1.06 g.

  3. 3. In which reaction does water act as a base?

    1. NH₃ + H₂O → NH₄⁺ + OH⁻
    2. 2Na + 2H₂O → 2NaOH + H₂
    3. CO₃²⁻ + H₂O → HCO₃⁻ + OH⁻
    4. HCl + H₂O → H₃O⁺ + Cl⁻
    Show answer

    Answer: D. A base accepts a proton. With HCl, water accepts H⁺ to become H₃O⁺. With NH₃ and CO₃²⁻ water donates a proton (acts as an acid), and with sodium it is reduced to hydrogen.

  4. 4. In copper sulphate pentahydrate, CuSO₄·5H₂O, how many water molecules are coordinated to the Cu²⁺ ion?

    1. 5
    2. 4
    3. 1
    4. 0
    Show answer

    Answer: B. The compound is [Cu(H₂O)₄]SO₄·H₂O: four water molecules form coordinate bonds with Cu²⁺, and the fifth lies outside the coordination sphere, held by hydrogen bonds.

  5. 5. How is an exhausted zeolite water softener regenerated?

    1. By washing with dilute HCl
    2. By adding washing soda
    3. By adding lime water
    4. By passing aqueous sodium chloride through it
    Show answer

    Answer: D. Brine replaces the trapped Ca²⁺ and Mg²⁺ with Na⁺: M-Z + 2NaCl → Na₂-Z + MCl₂, so the zeolite can soften water again.

Sign in to keep track of the lessons you finish.

Next lesson → Heavy water and hydrogen peroxide

Privacy · Terms · Refunds · Delivery