• Practice
  • About 18 min
  • 5 practice questions

Glaciers and karst (groundwater) landforms

Describe glaciers, their types and how they erode, identify glacial erosional and depositional landforms, and explain karst landforms made by groundwater in limestone.

If something looks wrong, please tell us.

By the end of this lesson you can

  • Explain snowfields, the snow line and the three types of glacier.
  • Identify glacial erosional and depositional landforms, including the types of moraine.
  • Describe karst erosional and cave depositional landforms.

Ice and underground water work far more slowly than a flooding river, yet given time they carve some of the most dramatic scenery on earth: sharp Alpine peaks, deep fjords, and limestone caves hung with stone icicles.

Glaciers

A glacier (from French glace, ice) is a large mass of ice moving slowly downslope, often called a 'river of ice'. It forms where more snow accumulates than melts or evaporates (ablation) over many years. Areas with snow all year are snowfields, which lie above the snow line, the line above which snow is permanent. The snow line varies with latitude, amount of snowfall, wind direction and relief. Under the weight of upper layers, the lower snow turns to ice and the mass flows downslope. The textbook gives an average speed of about 1 metre a day, depending on the glacier's size and the slope. Most of the world's glacier ice lies in Antarctica and Greenland. Deep cracks in a glacier's surface are crevasses, dangerous to mountaineers.

Types of glacier
TypeDescriptionExample
Continental glacier (ice sheet)Vast sheet of ice covering a landmass in polar regions; edges breaking into the sea form icebergsAntarctica, Greenland
Ice capA smaller dome of ice and snow covering a highland areaSvartisen, northern Norway
Mountain or valley (Alpine) glacierTongue of ice flowing down a mountain valley; piedmont glaciers spread out at the foot of mountainsHigh Himalaya, Alps

Glaciers erode by plucking (ice freezes onto rock and tears out blocks, which are dragged along) and abrasion (ice armed with rock fragments grinds, scratches and grooves the bedrock).

Erosional landforms of glaciers

  • U-shaped valley: heavy, slow ice erodes the floor and sides evenly, giving steep sides and a broad curved floor.
  • Hanging valley: a tributary glacier cuts less deeply than the main one, so its valley is left 'hanging' high above the main valley floor, often with a waterfall.
  • Cirque (corrie) and tarn: an armchair-shaped hollow with steep walls on three sides, cut at the head of a glacier; a lake in it after the ice melts is a tarn.
  • Arête: a sharp, saw-toothed ridge between two cirques eroded from both sides.
  • Horn: a pyramid-shaped peak where several cirques cut into one summit, such as the Matterhorn in the Alps.
  • Nunatak: a rocky peak standing like an island above the surrounding ice.
  • Fjord: a long, deep, steep-sided inlet formed where a glaciated valley is drowned by the sea, common in Norway, Greenland and New Zealand.

Depositional landforms of glaciers

Moraines are ridges and sheets of unsorted rock debris deposited by glaciers, named by position: lateral (along the sides), medial (in the middle, where two lateral moraines merge as glaciers join), ground (on the valley floor), terminal or end (at the farthest point the ice reached) and recessional (behind the terminal moraine, where a retreating glacier paused). Meltwater spreads layered sand, gravel and clay as an outwash plain. Other features: eskers (long winding ridges of gravel, sometimes used for roads), drumlins (smooth hills shaped like an upturned boat) and kames (mounds and ridges of sand and gravel along the ice front).

Glacial landforms

  • Erosional
    • U-shaped valley
    • Hanging valley
    • Cirque and tarn
    • Arête and horn
    • Fjord, nunatak
  • Depositional
    • Moraines: lateral, medial, ground, terminal, recessional
    • Outwash plain
    • Esker
    • Drumlin
    • Kame

Groundwater and karst topography

Karst topography is the landscape formed by groundwater dissolving and redepositing rock in limestone, dolomite or gypsum regions. The name comes from the Kras region (Slovene kras, stony ground) in present-day Slovenia and Croatia, in the former Yugoslavia. Rainwater with dissolved carbon dioxide (carbonic acid) slowly dissolves calcium carbonate along joints.

  • Lappies: irregular grooves and sharp ridges left on bare limestone surfaces by solution.
  • Sinkhole: a hole, roughly circular at the top and funnel-shaped below; one formed only by solution is a solution sink. A doline (Slovene dolina, valley) is a closed depression draining underground.
  • Uvala: a larger hollow formed when several sinkholes join.
  • Polje: a large, elongated, flat-floored basin with steep walls, formed by the joining of many sinkholes; streams may disappear into it.
  • Caves: underground hollows dissolved along joints; a cave open at both ends is a tunnel.

Inside caves, water dripping from the roof loses carbon dioxide and deposits calcite. Stalactites hang down from the roof like icicles (sideways-growing ones are helictites); stalagmites grow up from the floor; when the two meet they form a pillar; calcite deposited from a long crack forms a curtain.

Stalactites hold tight to the ceiling; stalagmites might reach it from the ground.

Worked example 1: how long to grow?

Suppose (illustrative rate) a stalactite grows 0.15 mm a year and a stalagmite below it grows 0.25 mm a year, with a 1.2 m gap between them. When will they join to form a pillar? Step 1: combined growth = 0.15 + 0.25 = 0.40 mm a year. Step 2: 1.2 m = 1,200 mm. Step 3: 1,200 ÷ 0.40 = 3,000. Answer: about 3,000 years.

Worked example 2: reading a mountain landscape

A valley has a broad curved floor, a small side valley ending high on a cliff with a waterfall, and a curved ridge of unsorted boulders across its lower end. Step by step: broad curved floor = U-shaped valley; high side valley = hanging valley; ridge across the end = terminal moraine. Conclusion: a glacier once filled the valley and reached as far as the moraine.

Key takeaways: glaciers form above the snow line and are continental, ice caps or valley glaciers; they erode by plucking and abrasion, making U-shaped valleys, cirques, arêtes, horns and fjords, and deposit moraines, eskers, drumlins and outwash plains; groundwater in limestone forms lappies, sinkholes, uvalas, poljes and caves with stalactites, stalagmites and pillars.

Check your understanding

  1. 1. An amphitheatre-shaped hollow cut into a mountain by a glacier is a:

    1. horn
    2. fjord
    3. cirque
    4. drumlin
    Show answer

    Answer: C. A cirque or corrie is the armchair-shaped hollow at a glacier's head; it may later hold a tarn.

  2. 2. A moraine formed where two glaciers join and their lateral moraines merge is a:

    1. medial moraine
    2. terminal moraine
    3. ground moraine
    4. recessional moraine
    Show answer

    Answer: A. When two glaciers meet, their inner lateral moraines combine into a medial moraine down the middle.

  3. 3. Irregular grooves and ridges on a limestone surface caused by solution are:

    1. poljes
    2. nunataks
    3. eskers
    4. lappies
    Show answer

    Answer: D. Lappies form when solution removes much of a bare limestone surface, leaving grooves and sharp ridges.

  4. 4. A rocky peak standing above the surrounding ice like an island is a:

    1. horn
    2. nunatak
    3. arête
    4. kame
    Show answer

    Answer: B. A nunatak is a rock mass surrounded by glacier ice.

  5. 5. When a stalactite and a stalagmite meet, they form a:

    1. curtain
    2. pillar
    3. uvala
    4. doline
    Show answer

    Answer: B. The joined column of calcite from roof to floor is a pillar.

Privacy · Terms · Refunds · Delivery