• Practice
  • About 18 min
  • 5 practice questions

Landforms made by wind and by sea waves

Explain how wind and waves erode, and identify aeolian landforms (deflation hollows, mushroom rocks, yardangs, zeugen, dunes, loess) and coastal landforms (cliffs, caves, arches, stacks, beaches, bars, lagoons, spits, tombolos).

If something looks wrong, please tell us.

By the end of this lesson you can

  • Describe deflation, abrasion and attrition by wind and the main aeolian landforms.
  • Describe the four ways waves erode and the terms used for parts of a coast.
  • Explain coastal erosional and depositional landforms with Tamil Nadu examples.

In deserts, where there is little water or vegetation to hold loose grains, wind becomes the main sculptor. Along coasts, waves strike the land day and night. Tamil Nadu's long coastline, with features such as the Pulicat lagoon, shows the work of the sea clearly.

The work of wind

Landforms made by wind are aeolian landforms (after Aeolus, the Greek god of winds). Wind works in three ways: deflation (lifting and blowing away sand and dust, leaving hollows), abrasion (wind-blown sand blasting rock) and attrition (grains knocking against one another and becoming smaller and rounder).

Erosional landforms of wind

  • Deflation hollow: a shallow depression made by persistent deflation. Where deflation reaches down to water, an oasis forms.
  • Mushroom rock (pedestal rock): wind carries most sand close to the ground, so abrasion cuts the base of a rock more than its top, leaving a narrow stem and a broad cap.
  • Yardang: long, grooved ridges of rock, the textbook says about 1-10 m high, running parallel to the prevailing wind, where softer rock between harder ridges is scoured out (for example near Kom Ombo, Egypt).
  • Zeugen: a landscape of tabular ridges and furrows formed where a hard layer of rock lies over softer rock and abrasion attacks the softer rock beneath; the textbook gives heights up to about 30 m.

Depositional landforms of wind

Two kinds of sand dune

  • Barchan
    • Crescent-shaped
    • Horns point downwind (leeward)
    • Forms where sand is limited and wind direction steady
    • The textbook says it may exceed 27 m in height
  • Seif
    • Long, narrow ridge of sand
    • Lies parallel to the prevailing wind
    • Can run for several kilometres
    • Corridors between ridges are swept clear

Loess is a deposit of fine, wind-carried silt settled from dust storms over thousands of years; it forms fertile soils. A pediplain is a low, almost featureless plain left when desert uplands are worn down.

The work of sea waves

Waves are movements of the sea surface set up mainly by wind. They erode in four ways: abrasion (corrasion), when waves hurl sand and pebbles against the coast; hydraulic action, when waves force water and air into cracks and the trapped air expands explosively as the wave retreats, widening joints; corrosion (solution), the dissolving of soluble rock; and attrition, when boulders and pebbles grind each other smaller.

Terms used for a coast
TermMeaning
Sea shoreZone between high tide and low tide
ShorelineBoundary between land and water at a given time
CoastlineBoundary where land meets sea
ForeshorePart of the beach worked by waves in normal weather
BackshoreBeach from the limit of storm waves to the cliff base
OffshoreShallow zone of the continental shelf
SwashWater of a wave rushing up the beach

Erosional coastal landforms

How a headland is worn back

  1. Sea cliff Steep rock face rising from the sea; a flat wave-cut platform forms at its foot
  2. Sea cave Waves hollow out a weakness such as a joint or fault
  3. Blowhole Pressure opens a hole in the cave roof; spray spouts out
  4. Arch Caves on both sides meet and cut right through
  5. Stack The arch roof collapses, leaving a rock pillar in the sea
  6. Stump The stack is worn down to a low remnant

Depositional coastal landforms

  • Beach: a stretch of sand, pebbles or gravel deposited along the shore. The textbook names Praia do Cassino in Brazil as the longest and describes Chennai's Marina beach as the second longest.
  • Bar: a ridge of sand deposited offshore; a larger one is a barrier, and a long one rising above the sea is a barrier island.
  • Lagoon: a body of seawater enclosed between a bar and the coast, such as Pulicat lake on the Tamil Nadu-Andhra Pradesh border.
  • Spit: a narrow ridge of sand or pebbles joined to the land at one end and running out into the sea, as at the Dhanushkodi tip of Rameswaram island.
  • Tombolo: a bar that joins an island to the mainland.

Cave, arch, stack, stump: a headland's life story. Spit joins land at one end; tombolo joins land to an island.

Worked example 1: why is the mushroom rock's stem thin?

Step 1: wind can lift heavy sand grains only a short height, so most of the load moves within about the first metre or two above the ground. Step 2: abrasion is therefore strongest near the base. Step 3: the base wears back while the top is little touched. Result: a narrow stem under a broad cap.

Worked example 2: identify the feature

(a) A ridge of sand links a small rocky island to the shore. (b) Calm salty water lies between a long sand ridge and the mainland. (c) A lone pillar of rock stands a little offshore from a cliffed headland. Step by step: island-to-land link = tombolo; water behind a bar = lagoon; isolated pillar from a collapsed arch = stack.

Key takeaways: wind erodes by deflation, abrasion and attrition, forming deflation hollows, oases, mushroom rocks, yardangs and zeugen, and deposits barchans, seifs and loess; waves erode by abrasion, hydraulic action, corrosion and attrition, forming cliffs, platforms, caves, blowholes, arches, stacks and stumps, and deposit beaches, bars, lagoons, spits and tombolos.

Check your understanding

  1. 1. The removal of loose sand and dust by wind is called:

    1. abrasion
    2. deflation
    3. attrition
    4. saltation
    Show answer

    Answer: B. Deflation lifts and blows away loose particles, leaving deflation hollows.

  2. 2. A crescent-shaped dune with its horns pointing downwind is a:

    1. seif
    2. yardang
    3. barchan
    4. zeugen
    Show answer

    Answer: C. A barchan is crescent-shaped, with its horns stretching out in the leeward direction.

  3. 3. A stack is formed when:

    1. a sea arch collapses
    2. a cave fills with sand
    3. a spit joins an island
    4. a lagoon dries up
    Show answer

    Answer: A. Waves enlarge a cave into an arch; when the arch roof falls, the seaward part is left as a stack.

  4. 4. Pulicat lake, on the Tamil Nadu-Andhra Pradesh border, is an example of a:

    1. tombolo
    2. spit
    3. oxbow lake
    4. lagoon
    Show answer

    Answer: D. Pulicat is seawater enclosed behind a sand barrier along the coast, which is a lagoon.

  5. 5. Waves forcing air into cracks, which then expands explosively as they retreat, is called:

    1. corrosion
    2. hydraulic action
    3. attrition
    4. deflation
    Show answer

    Answer: B. Hydraulic action uses the force of water and compressed air to widen cracks and break rock.

Privacy · Terms · Refunds · Delivery