• Practice
  • About 15 min
  • 5 practice questions

Mass wasting and the gradational processes

Classify mass wasting by material and motion, describe falls, slides, slumps, flows and creep with their causes, and explain gradation, degradation and aggradation.

If something looks wrong, please tell us.

By the end of this lesson you can

  • Define mass wasting and classify it by material and type of motion.
  • Describe rock fall, rock slide, landslide, slump, debris slide, debris flow, mudflow, debris avalanche and creep.
  • Explain gradation, degradation and aggradation.

In the hills of the Nilgiris, heavy monsoon rain sometimes sends soil and rock sliding down onto roads and houses. Gravity is always pulling loose material downhill; when water, steep slopes or shaking weaken the slope, it gives way. Understanding the kinds of movement helps people plan safer roads and homes.

What mass wasting is

Mass wasting (also mass movement or slope movement) is the downslope movement of rock, soil and debris under the pull of gravity. It may be sudden or very slow. It is classified by the material involved (rock, soil, mud) and the type of motion: a fall (pieces drop freely), a slide (material moves along a surface on the slope), or a flow (material mixed with water moves like a fluid).

Kinds of mass wasting

  • Falls
    • Rock fall; debris piles up as talus
  • Slides
    • Rock slide
    • Landslide
    • Slump (rotational)
    • Debris slide
  • Flows
    • Earth flow
    • Mudflow (lahar on a volcano)
    • Debris avalanche
  • Very slow
    • Soil creep

The types

  • Rock fall: pieces of rock break from a cliff and drop, often loosened by frost wedging. The pile of debris at the foot of the slope is talus.
  • Rock slide: a rock mass slides along a zone of weakness such as a bedding plane; water increases slippage and collisions break it into rubble.
  • Landslide: a large mass of rock or earth breaks away and slides downhill, often set off by earthquakes or very heavy rain.
  • Slump: a mass of bedrock or sediment moves down with a rotational slip, tilting backward as it goes; the commonest cause is erosion at the base of the slope removing support.
  • Debris slide: larger than a slump, a mixture of soil and rock fragments slides with only a little water.
  • Debris flow: when much water is present, the mass loses coherence and flows like liquid mud with turbulence throughout, carrying boulders. It includes earth flows (fluid-like masses on steep, clay-rich, saturated slopes in humid areas), mudflows and debris avalanches.
  • Mudflow: a liquid mass of soil, debris and water rushing down a defined channel, most often in semi-arid mountains; one on a volcano's slope is a lahar.
  • Debris avalanche: the deadliest flow, a fast churning mass of debris, soil, water and air on steep slopes; trapped air can cushion it and raise its speed.
  • Creep: a very slow movement of soil downhill, usually less than a centimetre a year, helped by freezing and thawing. It shows as tilted poles, fences and trees. Vegetation slows it.

Gradation

Gradation is the levelling of the earth's surface. It has two parts: degradation, the wearing down of high ground by erosion, and aggradation, the filling up of low ground by deposition. The forces that do this work - running water, waves, wind and ice - are the gradational agents, studied in the next three lessons.

How gradation levels the land

  1. Weathering Rock loosened in place
  2. Mass wasting Gravity moves debris downslope
  3. Erosion and transport (degradation) Agents carry material away from high ground
  4. Deposition (aggradation) Material fills valleys, plains and sea floors

Fall = drops, slide = slips on a surface, flow = moves like a liquid, creep = so slow you see only tilted poles.

Staying safe on hill slopes: in heavy rain, watch for new cracks in the ground, tilting trees or poles, and sudden muddy water in streams; move away from steep slopes and stream channels and follow local warnings. Keeping vegetation on slopes and draining water properly reduce the risk.

Worked example 1: classify the movement

(a) After a week of rain, a hillside of wet clay moves down slowly as a tongue of soft earth. (b) Boulders crash down from a road cutting after a frosty night. (c) Fence posts on a grassy slope lean more each year. Step by step: soft saturated earth moving like a fluid is an earth flow; free-falling rock is a rock fall; slow tilting over years is creep.

Worked example 2: how far does creep move?

If soil on a slope creeps 0.8 cm a year (illustrative), how far does a fence post's base shift in 25 years? Step 1: 0.8 × 25 = 20 cm. Answer: about 20 cm, enough to tilt the post visibly although nobody saw it move.

Key takeaways: mass wasting is gravity-driven movement classified by material and motion; falls, slides, slumps, flows and creep differ in speed and water content; earthquakes, heavy rain and undercutting trigger them; gradation combines degradation and aggradation.

Check your understanding

  1. 1. The accumulation of rock debris at the base of a steep slope is called:

    1. talus
    2. lahar
    3. slump
    4. loess
    Show answer

    Answer: A. Talus is the heap of fallen rock fragments at the foot of a cliff or steep slope.

  2. 2. A mudflow originating on the slope of a volcano is called a:

    1. slump
    2. creep
    3. lahar
    4. debris slide
    Show answer

    Answer: C. A lahar is a volcanic mudflow of ash, debris and water.

  3. 3. A mass that moves down with a backward-tilting rotational slip is a:

    1. rock fall
    2. creep
    3. debris avalanche
    4. slump
    Show answer

    Answer: D. A slump moves along a curved surface with rotational slip, often after the base of the slope is eroded.

  4. 4. Tilted utility poles and fences on a slope are evidence of:

    1. soil creep
    2. rock fall
    3. debris avalanche
    4. aggradation
    Show answer

    Answer: A. Creep is too slow to see directly, usually under a centimetre a year, but it gradually tilts poles, fences and trees.

  5. 5. The filling up of depressions on the earth's surface by deposition is called:

    1. degradation
    2. aggradation
    3. exfoliation
    4. deflation
    Show answer

    Answer: B. Aggradation builds up low areas by deposition; degradation wears down high areas by erosion.

Privacy · Terms · Refunds · Delivery