• Practice
  • About 25 min
  • 5 practice questions

Propagation of errors, significant figures and rounding off

Combine errors in sums, differences, products, quotients and powers, count significant figures, round off by the textbook's rules and keep the right number of figures in calculations.

If something looks wrong, please tell us.

By the end of this lesson you can

  • State and use the rules for the error in a sum, difference, product, quotient and power.
  • Apply the general rule for Z = AᵖBᵠ/Cʳ.
  • Count significant figures using the seven rules.
  • Round off numbers, including the special rule when the dropped digit is exactly 5.
  • Keep the correct decimal places or significant figures after adding, subtracting, multiplying or dividing.

Most results are calculated from several measured quantities: resistance from voltage and current, density from mass and volume, g from length and period. The error in the result depends on the errors in each reading and on the mathematical operation. Then we must also report the result with a sensible number of digits.

Propagation of errors

Rules for combining errors
OperationResultMaximum error
SumZ = A + BΔZ = ΔA + ΔB
DifferenceZ = A − BΔZ = ΔA + ΔB (errors still add)
ProductZ = ABΔZ/Z = ΔA/A + ΔB/B
QuotientZ = A/BΔZ/Z = ΔA/A + ΔB/B
PowerZ = AⁿΔZ/Z = n ΔA/A

Why do fractional errors add for a product? Write Z ± ΔZ = (A ± ΔA)(B ± ΔB) = AB ± AΔB ± BΔA ± ΔAΔB. Divide by Z = AB: 1 ± ΔZ/Z = 1 ± ΔB/B ± ΔA/A ± (ΔA/A)(ΔB/B). The last term is the product of two small fractions, so it is neglected, and the maximum fractional error is ΔA/A + ΔB/B. For a quotient the same result follows using (1 + x)ⁿ ≈ 1 + nx when x ≪ 1.

General rule: if Z = AᵖBᵠ/Cʳ, then ΔZ/Z = p(ΔA/A) + q(ΔB/B) + r(ΔC/C). Errors always add, even when quantities are subtracted or divided.

Worked example 1: sum, difference and quotient

(a) Two rods of (12.5 ± 0.2) cm and (8.3 ± 0.1) cm are placed end to end: L = (20.8 ± 0.3) cm. (b) An empty beaker weighs (20.4 ± 0.1) g and with liquid (52.6 ± 0.1) g. Mass of liquid = (32.2 ± 0.2) g. (c) A body has m = (25.0 ± 0.5) g and V = (10.0 ± 0.2) cm³. Density ρ = 25.0/10.0 = 2.50 g cm⁻³. Fractional error = 0.5/25.0 + 0.2/10.0 = 0.02 + 0.02 = 0.04. Δρ = 0.04 × 2.50 = 0.10 g cm⁻³, so ρ = (2.50 ± 0.10) g cm⁻³.

Worked example 2: powers and the simple pendulum

(a) The radius of a sphere has a 1% error. Since V = (4/3)πr³, the error in V is 3 × 1% = 3% (4/3 and π are exact). (b) For a simple pendulum g = 4π²l/T². If l has a 1% error and T a 2% error, the error in g is 1% + 2 × 2% = 5%. (c) If Z = A²B³/√C with errors 2%, 1% and 4% in A, B and C, the error in Z = 2 × 2% + 3 × 1% + ½ × 4% = 4% + 3% + 2% = 9%.

Significant figures

The significant figures of a measurement are the digits known reliably plus the first uncertain digit. If three students measure a stick with a metre scale (LC 0.1 cm) as 7.20, 7.22 and 7.23 cm, all agree on the first two digits; the third is uncertain. Each result has three significant figures, which tells the reader both the value and the precision of the instrument.

Counting significant figures (the textbook's rules)
RuleExample
All non-zero digits are significant1342 has 4
Zeros between non-zero digits are significant2008 has 4
Zeros to the right of a non-zero digit but left of a written decimal point are significant30700. has 5
Without a decimal point, trailing zeros are not significant30700 has 3
In a number less than 1, zeros after the decimal point before the first non-zero digit are not significant0.00345 has 3
Zeros to the right of the decimal point after a non-zero digit are significant40.00 has 4; 0.030400 has 5
The count does not depend on units1.53 cm = 0.0153 m: both have 3

Exact factors such as 2 in 2πr have unlimited significant figures, and a power of ten does not change the count: 5.70 m = 5.70 × 10² cm, three significant figures either way.

Rounding off

  1. Digit to be dropped less than 5: leave the previous digit unchanged (6.43 → 6.4).
  2. Digit to be dropped greater than 5: raise the previous digit by 1 (6.47 → 6.5).
  3. Dropped digit 5 followed by non-zero digits: raise by 1 (6.451 → 6.5).
  4. Dropped digit exactly 5 (or 5 followed by zeros): leave the previous digit unchanged if it is even (6.45 → 6.4), raise it by 1 if it is odd (6.35 → 6.4).

Calculations with significant figures

Adding or subtracting: keep as many decimal places as the number with the fewest decimal places. 4.2 + 1.365 + 0.08 = 5.645, rounded to one decimal place = 5.6. Multiplying or dividing: keep as many significant figures as the number with the fewest significant figures. 2.31 × 1.4 = 3.234 → 3.2 (two significant figures). Example: the area of a square of side 2.45 m is 2.45² = 6.0025 m², reported as 6.00 m² (three significant figures).

Which rule to use

  • Adding or subtracting
    • Count decimal places
    • Keep the fewest decimal places
  • Multiplying or dividing
    • Count significant figures
    • Keep the fewest significant figures

Key takeaways

  • Absolute errors add in sums and differences; fractional errors add in products and quotients.
  • A power multiplies the fractional error by the power: for Aⁿ, ΔZ/Z = nΔA/A.
  • Significant figures = reliable digits + the first uncertain digit.
  • An exact 5 being dropped: keep an even previous digit, raise an odd one.
  • Addition and subtraction follow decimal places; multiplication and division follow significant figures.

Check your understanding

  1. 1. Two resistances (40 ± 2) Ω and (60 ± 1) Ω are connected in series. The equivalent resistance is:

    1. (100 ± 1) Ω
    2. (100 ± 3) Ω
    3. (100 ± 2) Ω
    4. (100 ± 1.5) Ω
    Show answer

    Answer: B. In series R = R₁ + R₂ = 40 + 60 = 100 Ω, and for a sum the absolute errors add: ΔR = 2 + 1 = 3 Ω. So R = (100 ± 3) Ω.

  2. 2. The error in measuring the side of a cube is 2%. The error in its volume is:

    1. 2%
    2. 4%
    3. 8%
    4. 6%
    Show answer

    Answer: D. V = a³, so ΔV/V = 3 × Δa/a = 3 × 2% = 6%.

  3. 3. How many significant figures does 0.005020 have?

    1. 4
    2. 3
    3. 6
    4. 7
    Show answer

    Answer: A. Leading zeros (0.00) are not significant. The digits 5, 0 (between 5 and 2), 2 and the trailing 0 after the decimal point are significant: four in all.

  4. 4. Rounded off to three significant figures by the textbook's rules, 4.865 becomes:

    1. 4.87
    2. 4.86
    3. 4.8
    4. 4.90
    Show answer

    Answer: B. The digit dropped is exactly 5, and the previous digit 6 is even, so it is left unchanged: 4.865 → 4.86.

  5. 5. The result of 12.11 + 0.3 + 4.256, written with the correct number of digits, is:

    1. 16.666
    2. 16.67
    3. 16.7
    4. 17
    Show answer

    Answer: C. The sum is 16.666. In addition the result keeps the fewest decimal places among the numbers; 0.3 has only one decimal place, so the answer is 16.7.

Privacy · Terms · Refunds · Delivery