Revision notes

Unit 5 Magnetism and Electromagnetism: Foundation

The key points, rules to remember, tables and diagrams from all 5 lessons, on one page for quick revision. To keep a copy, use your browser's Print and choose "Save as PDF".

Lesson 1

Magnets, magnetic field and magnetic field lines

Describing a magnetic field

  • Magnetic field B
    • Region where magnetic force is felt
    • Unit: tesla (T)
    • Direction: where a compass N pole points
  • Magnetic flux ϕ
    • Number of field lines through an area
    • Unit: weber (Wb)
  • Flux density
    • Field lines per unit normal area
    • Unit: Wb/m² (= T)

Field lines: N to S outside, S to N inside, closed, never crossing, crowded where the field is strong. Flux in Wb; flux density in Wb/m² = tesla.

Key takeaways: a magnetic field surrounds every magnet and is measured in tesla. Field lines are closed curves that never cross and show direction by their tangent. Flux counts the lines through an area; flux density counts them per unit area.

Read the full lesson

Lesson 2

Magnetic effect of current: Oersted and the right-hand thumb rule

Using the right-hand thumb rule

  1. Find the current direction Conventional current, + to −
  2. Point the right thumb along it Grip the wire with your right hand
  3. Read the curled fingers They give the direction of the field circles
  4. Check with a compass Its N pole points along the circles

A current-carrying wire is surrounded by circular magnetic field lines. Right-hand thumb rule: thumb along the current, fingers curl along the field.

Key takeaways: Oersted showed in 1820 that current produces a magnetic field. Around a straight wire the field lines are concentric circles whose sense is given by the right-hand thumb rule. The field is stronger for a larger current and closer to the wire.

Read the full lesson

Lesson 3

Force on a current-carrying conductor: F = ILB and Fleming's left-hand rule

Fleming's left-hand rule (motor rule)

  • Forefinger
    • Magnetic field
    • From N to S
  • Middle finger
    • Current
    • From + to −
  • Thumb
    • Force or motion of the conductor

Parallel current-carrying wires

  • Currents in the same direction
    • Wires attract each other
    • Forces equal and opposite
  • Currents in opposite directions
    • Wires repel each other
    • Forces equal and opposite

F = ILB (wire perpendicular to field; zero when parallel). Fleming's left-hand rule: Forefinger Field, middle finger Current, thuMb Motion. Like currents attract; unlike currents repel.

Key takeaways: a current across a magnetic field feels a force F = ILB, greatest at right angles and zero along the field. Its direction is found with Fleming's left-hand rule. Parallel currents in the same direction attract and in opposite directions repel.

Read the full lesson

Lesson 4

The electric motor and electromagnetic induction

How a dc motor works

  1. Supply switched on Current enters the coil through brushes and commutator
  2. Fields combine Coil's field and the magnet's field interact
  3. Opposite forces on the sides One side pushed up, the other down
  4. Coil turns Turning effect about the axis
  5. Commutator reverses current Every half turn, so rotation continues

Fleming's two rules

  • Left-hand rule (motor rule)
    • Given: field and current
    • Find: force or motion
    • Used for motors
  • Right-hand rule (generator rule)
    • Given: field and motion
    • Find: induced current
    • Used for generators

Motor: electrical to mechanical energy; split-ring commutator reverses the current every half turn. Induction: a changing flux induces an e.m.f. proportional to the rate of change. Lenz: the induced current opposes the change.

Key takeaways: in a motor, opposite forces on the two sides of a coil turn it, and the commutator keeps it turning one way. Faraday showed that a changing magnetic flux induces an e.m.f.; Lenz's law and Fleming's right-hand rule give the direction of the induced current.

Read the full lesson

Lesson 5

Generators, transformers and uses of electromagnets

ac and dc generators

  • ac generator
    • Two separate slip rings
    • Each coil end always meets the same brush
    • Output reverses every half turn
  • dc generator
    • One split-ring commutator
    • Connections swap every half turn
    • Output flows one way

Vs/Vp = Ns/Np and, for an ideal transformer, Is/Ip = Np/Ns. Stepping up voltage steps down current, and stepping down voltage steps up current.

Key takeaways: a generator turns mechanical energy into electrical energy; slip rings give ac and a split-ring commutator gives dc. A transformer changes ac voltage in the ratio of the turns, works only on ac and trades voltage for current. Electromagnets drive speakers, maglev trains and MRI scanners.

Read the full lesson

Privacy · Terms · Refunds · Delivery