- Practice
- About 17 min
- 5 practice questions
The electric motor and electromagnetic induction
Explain how a dc motor uses a coil and split-ring commutator to turn continuously, describe Faraday's induction experiments, and apply Lenz's law and Fleming's right-hand rule.
If something looks wrong, please tell us.
By the end of this lesson you can
- Explain the principle and working of a dc electric motor.
- Describe the job of the split-ring commutator and brushes.
- List ways to make a motor turn faster.
- Describe Faraday's three induction experiments and his conclusion.
- Use Lenz's law and Fleming's right-hand rule.
Water pumps, fans, washing machines, mixers and grinders all contain an electric motor, a device that converts electrical energy into mechanical energy. A generator does the reverse. Both depend on the link between current and magnetism.
Principle of the motor
A current-carrying conductor placed at right angles to a magnetic field feels a force. Put a rectangular coil ABCD between the poles of a magnet. Current flows one way in side AB and the opposite way in side CD, so by Fleming's left-hand rule the two sides are pushed in opposite directions, one up and one down. The pair of forces produces a turning effect and the coil rotates about its axis.
Keeping it turning: the split-ring commutator
After half a turn, side AB would be where CD was. If the current kept the same direction in the coil, the forces would now turn it back, and the coil would just rock to and fro. To get continuous rotation, the current in the coil must reverse every half turn. This is done by a split-ring commutator: a ring cut into two halves, each joined to one end of the coil, which turns with the coil and presses against two fixed carbon brushes connected to the dc supply. As the gaps pass the brushes, each half-ring swaps from one brush to the other, reversing the current in the coil. Momentum carries the coil past the moment of no current.
How a dc motor works
- Supply switched on Current enters the coil through brushes and commutator
- Fields combine Coil's field and the magnet's field interact
- Opposite forces on the sides One side pushed up, the other down
- Coil turns Turning effect about the axis
- Commutator reverses current Every half turn, so rotation continues
The motor turns faster if you: (i) increase the current, (ii) increase the number of turns in the coil, (iii) increase the area of the coil, or (iv) use a stronger magnetic field. The main parts are the field magnet, the armature coil, the split-ring commutator, the brushes and the axle.
Electromagnetic induction
Oersted showed that current produces magnetism. Scientists then asked whether magnetism could produce current. In 1831 Michael Faraday showed that it can, if the magnetic flux linked with a circuit changes.
- Two coils on an iron ring: one coil was connected to a battery through a switch, the other to a galvanometer. At the instant the switch was closed the galvanometer deflected; when it was opened it deflected the opposite way. With a steady current, nothing happened.
- Moving a magnet: pushing a magnet into a coil or pulling it out produced a current; a coil with more turns gave a larger voltage.
- Moving the coil: keeping the magnet still and moving the coil into and out of its field also produced a current.
Faraday concluded that whenever the magnetic flux linked with a closed circuit changes, an e.m.f. is induced, and its size is proportional to the rate of change of flux. This is electromagnetic induction; the e.m.f. is the induced e.m.f. and the current it drives is the induced current.
Direction of the induced current
Lenz's law: the induced current flows in such a direction as to oppose the change that causes it. Push a north pole into a coil, and the coil's near end becomes a north pole that pushes back. Fleming's right-hand rule (the generator or dynamo rule): stretch the thumb, forefinger and middle finger of the right hand mutually at right angles. If the forefinger points along the field and the thumb along the motion of the conductor, the middle finger gives the induced current.
Fleming's two rules
-
Left-hand rule (motor rule)
- Given: field and current
- Find: force or motion
- Used for motors
-
Right-hand rule (generator rule)
- Given: field and motion
- Find: induced current
- Used for generators
Worked example 1: will current be induced?
Question: A magnet rests inside a coil connected to a galvanometer. Is there a current (a) while it rests, (b) while it is pulled out, (c) when it is pulled out twice as fast? Working: (a) No: the flux is not changing. (b) Yes: the flux through the coil is falling. (c) Yes, and larger: the flux changes at twice the rate, so the induced e.m.f. is about twice as large.
Worked example 2: the right-hand rule
Question: A wire is moved upward through a magnetic field that points north. Which way does the induced current flow? Working: Right hand: forefinger north (field), thumb up (motion). The middle finger then points west, so the induced current flows westward along the wire.
Motor: electrical to mechanical energy; split-ring commutator reverses the current every half turn. Induction: a changing flux induces an e.m.f. proportional to the rate of change. Lenz: the induced current opposes the change.
Key takeaways: in a motor, opposite forces on the two sides of a coil turn it, and the commutator keeps it turning one way. Faraday showed that a changing magnetic flux induces an e.m.f.; Lenz's law and Fleming's right-hand rule give the direction of the induced current.
Check your understanding
-
1. An electric motor converts
- mechanical energy into electrical energy
- electrical energy into mechanical energy
- heat energy into electrical energy
- chemical energy into electrical energy
Show answer
Answer: B. A motor uses electric current in a magnetic field to produce rotation, so it changes electrical energy into mechanical energy. A generator does the reverse.
-
2. What is the job of the split-ring commutator in a dc motor?
- To make the magnet stronger
- To reduce the current
- To reverse the current in the coil every half turn
- To stop the coil
Show answer
Answer: C. Without reversal, the forces would turn the coil back after half a turn. The split ring swaps the coil's connections to the brushes every half turn, so the coil keeps rotating in one direction.
-
3. Which change would make a dc motor turn more slowly?
- Decreasing the area of the coil
- Increasing the current
- Using a stronger magnet
- Adding more turns to the coil
Show answer
Answer: A. The turning effect grows with current, number of turns, area of the coil and field strength. Decreasing the coil's area reduces it, so the motor turns more slowly.
-
4. In Faraday's experiment with two coils on an iron ring, when did the galvanometer deflect?
- All the time the current was steady
- Never
- Only when the battery was removed from the room
- Only at the moments the switch was closed or opened
Show answer
Answer: D. An e.m.f. is induced only while the flux is changing. The flux changes when the current is switched on or off, not while it is steady.
-
5. Fleming's right-hand rule is used to find the direction of
- the force on a current in a motor
- the induced current in a generator
- the field around a straight wire
- the north pole of a compass
Show answer
Answer: B. The right-hand rule (generator rule) gives the induced current from the field and the motion. The left-hand rule gives the force in a motor, and the thumb rule gives the field around a wire.
Sign in to keep track of the lessons you finish.