• Foundation
  • About 16 min
  • 5 practice questions

Rate of a chemical reaction: average and instantaneous

Define the average and instantaneous rate of a reaction, express the rate using any reactant or product with the right stoichiometric factor, give its units and list the factors that change it.

If something looks wrong, please tell us.

By the end of this lesson you can

  • Explain what chemical kinetics adds to thermodynamics and equilibrium.
  • Calculate an average rate from concentration–time data, in different time units.
  • Explain how an instantaneous rate is found from the slope of a tangent.
  • Write the rate of a reaction with unequal coefficients so that it is the same whichever species is used.

Thermodynamics tells us whether a reaction can happen (ΔG < 0) and equilibrium tells us how far it goes. Neither says how fast. Diamond should turn into graphite, but it does so too slowly for anyone to notice. How fast food spoils, how quickly a dental filling sets, how fuel burns in an engine: these are questions of chemical kinetics, the study of reaction rates, the factors that control them and the steps (mechanisms) by which reactions happen.

Fast, slow and moderate reactions

Ionic reactions are very fast: silver chloride precipitates the instant silver nitrate and sodium chloride solutions are mixed. Rusting of iron is very slow. Inversion of cane sugar and hydrolysis of starch go at a moderate, measurable speed. Kinetics usually studies reactions of this middle kind.

Average rate

The rate of a reaction is the change in concentration of a reactant or a product per unit time. For R → P, if concentrations change from [R]₁, [P]₁ at time t₁ to [R]₂, [P]₂ at t₂:
Rate of disappearance of R = −Δ[R] ÷ Δt
Rate of appearance of P = +Δ[P] ÷ Δt
The minus sign makes the rate positive, since Δ[R] is negative. These expressions give the average rate over the interval Δt. Units: concentration time⁻¹, for example mol L⁻¹ s⁻¹; for gases measured by partial pressure, atm s⁻¹.

Instantaneous rate

The average rate falls as a reaction proceeds, because reactants are used up, so an average over a long interval says little about any one moment. The instantaneous rate is the average rate over a vanishingly small interval: r_inst = −d[R] ÷ dt = d[P] ÷ dt. On a graph of concentration against time it equals the slope of the tangent drawn to the curve at that instant (taken with a minus sign for a reactant).

Average and instantaneous rate

  • Average rate
    • Measured over a finite interval Δt
    • r_av = −Δ[R] ÷ Δt
    • Slope of a chord joining two points on the curve
    • Hides how the rate changes within the interval
  • Instantaneous rate
    • Rate at one moment, as Δt → 0
    • r_inst = −d[R] ÷ dt
    • Slope of the tangent at that point
    • Falls as the reaction proceeds

Reactions with unequal coefficients

For Hg(l) + Cl₂(g) → HgCl₂(s), every species changes at the same rate. But in 2HI(g) → H₂(g) + I₂(g), HI is used up twice as fast as H₂ forms. To get one value for the rate of the reaction, divide each rate by its stoichiometric coefficient:
Rate = −½ Δ[HI] ÷ Δt = Δ[H₂] ÷ Δt = Δ[I₂] ÷ Δt.

For aA + bB → cC + dD: Rate = −(1/a) Δ[A]/Δt = −(1/b) Δ[B]/Δt = +(1/c) Δ[C]/Δt = +(1/d) Δ[D]/Δt.

Worked example 1: average rate in two time units

In a reaction R → P, [R] falls from 0.060 mol L⁻¹ to 0.045 mol L⁻¹ in 5.0 minutes. Find the average rate in mol L⁻¹ min⁻¹ and in mol L⁻¹ s⁻¹.

r_av = −Δ[R] ÷ Δt = −(0.045 − 0.060) ÷ 5.0 = 0.015 ÷ 5.0 = 3.0 × 10⁻³ mol L⁻¹ min⁻¹.
In seconds: 3.0 × 10⁻³ ÷ 60 = 5.0 × 10⁻⁵ mol L⁻¹ s⁻¹.

Worked example 2: relating rates through coefficients

For N₂(g) + 3H₂(g) → 2NH₃(g), [NH₃] rises by 0.040 mol L⁻¹ in 20 s. Find the rate of formation of NH₃, the rate of the reaction and the rate of disappearance of H₂.

Rate of formation of NH₃ = 0.040 ÷ 20 = 2.0 × 10⁻³ mol L⁻¹ s⁻¹.
Rate of reaction = ½ × 2.0 × 10⁻³ = 1.0 × 10⁻³ mol L⁻¹ s⁻¹.
Rate of disappearance of H₂ = 3 × rate of reaction = 3.0 × 10⁻³ mol L⁻¹ s⁻¹.
Check: −(1/3) Δ[H₂]/Δt = (1/2) Δ[NH₃]/Δt, i.e. 3.0 × 10⁻³ ÷ 3 = 2.0 × 10⁻³ ÷ 2 = 1.0 × 10⁻³ mol L⁻¹ s⁻¹.

Factors that influence the rate

Factors that change the rate of a reaction

  • Concentration (pressure for gases) More reactant particles per unit volume usually means a faster rate; described by the rate law (next lesson).
  • Temperature Most reactions speed up when heated; the Arrhenius equation describes this (lesson 5).
  • Catalyst Provides a path of lower activation energy (lesson 5).

Key takeaways

  • Rate = change in concentration per unit time; units mol L⁻¹ s⁻¹ (or atm s⁻¹ for gases).
  • Average rate uses a finite interval; instantaneous rate is the slope of the tangent.
  • Divide each species' rate by its coefficient to get a single rate of reaction.
  • Rate depends on concentration, temperature and catalysts.

Check your understanding

  1. 1. For R → P, [R] falls from 0.050 M to 0.035 M in 20 minutes. What is the average rate in mol L⁻¹ s⁻¹?

    1. 7.5 × 10⁻⁴
    2. 1.25 × 10⁻⁵
    3. 1.5 × 10⁻²
    4. 4.5 × 10⁻²
    Show answer

    Answer: B. r_av = (0.050 − 0.035) ÷ 20 min = 0.015 ÷ 20 = 7.5 × 10⁻⁴ mol L⁻¹ min⁻¹. Dividing by 60 gives 1.25 × 10⁻⁵ mol L⁻¹ s⁻¹.

  2. 2. For 2A → products, [A] falls from 0.60 mol L⁻¹ to 0.48 mol L⁻¹ in 8 minutes. What is the rate of the reaction?

    1. 0.015 mol L⁻¹ min⁻¹
    2. 0.030 mol L⁻¹ min⁻¹
    3. 0.0075 mol L⁻¹ min⁻¹
    4. 0.12 mol L⁻¹ min⁻¹
    Show answer

    Answer: C. Rate of disappearance of A = 0.12 ÷ 8 = 0.015 mol L⁻¹ min⁻¹. Rate of reaction = ½ × 0.015 = 0.0075 mol L⁻¹ min⁻¹, because 2 mol of A react per unit of reaction.

  3. 3. In 2N₂O₅ → 4NO₂ + O₂, N₂O₅ disappears at 4.0 × 10⁻⁴ mol L⁻¹ s⁻¹. At what rate does NO₂ form?

    1. 8.0 × 10⁻⁴ mol L⁻¹ s⁻¹
    2. 2.0 × 10⁻⁴ mol L⁻¹ s⁻¹
    3. 4.0 × 10⁻⁴ mol L⁻¹ s⁻¹
    4. 1.6 × 10⁻³ mol L⁻¹ s⁻¹
    Show answer

    Answer: A. −½ d[N₂O₅]/dt = ¼ d[NO₂]/dt. So d[NO₂]/dt = (4 ÷ 2) × 4.0 × 10⁻⁴ = 8.0 × 10⁻⁴ mol L⁻¹ s⁻¹.

  4. 4. How is the instantaneous rate at a time t found from a graph of [reactant] against time?

    1. From the area under the curve
    2. From the slope of a straight line joining the start and the end
    3. From the intercept on the concentration axis
    4. From the negative of the slope of the tangent drawn at time t
    Show answer

    Answer: D. The instantaneous rate is −d[R]/dt, which is the slope of the tangent to the concentration–time curve at that time, with a minus sign because [R] is decreasing.

  5. 5. Assertion (A): The average rate of a reaction usually decreases as the reaction proceeds. Reason (R): The rate of a reaction is always independent of the concentration of reactants.

    1. Both A and R are true, and R is the correct explanation of A
    2. Both A and R are true, but R is not the correct explanation of A
    3. A is true, but R is false
    4. A is false, but R is true
    Show answer

    Answer: C. A is true: as reactants are consumed their concentration falls, and for most reactions the rate falls too. R is false: the rate usually depends on reactant concentration (only zero order reactions are an exception).

Sign in to keep track of the lessons you finish.

Next lesson → Rate law, order and molecularity

Privacy · Terms · Refunds · Delivery