• Foundation
  • About 28 min
  • 5 practice questions

Capacitors: capacitance, dielectrics, combinations and energy

Define capacitance C = Q/V, derive C = ε₀A/d for a parallel plate capacitor and C = KC₀ with a dielectric, combine capacitors in series and parallel, and find stored energy ½CV² and energy density ½ε₀E².

If something looks wrong, please tell us.

By the end of this lesson you can

  • Define capacitance and its unit, the farad.
  • Derive the capacitance of a parallel plate capacitor and the effect of a dielectric.
  • Derive and apply formulas for capacitors in series and in parallel.
  • Derive the energy stored, U = Q²/2C = ½CV², and the energy density ½ε₀E².

A camera flash charges a capacitor slowly from a small battery and then dumps the stored energy into the lamp in a fraction of a second. Capacitors store charge and energy in an electric field, and they are found in almost every electronic circuit, including the ac circuits of Chapter 7.

Capacitor and capacitance

A capacitor is two conductors separated by an insulator. In use the conductors carry charges +Q and −Q, with a potential difference V between them (Q is called the charge of the capacitor, though its total charge is zero). Doubling Q doubles the field everywhere between them, and so doubles V. The ratio is therefore constant:

C = Q/V. SI unit: farad, 1 F = 1 C V⁻¹. Practical units: 1 μF = 10⁻⁶ F, 1 nF = 10⁻⁹ F, 1 pF = 10⁻¹² F.

C depends only on the shapes, sizes and separation of the conductors and on the insulator between them. A large C stores a large charge at a modest voltage. This matters because a high voltage means a strong field, and if the field exceeds the insulator's dielectric strength (about 3 × 10⁶ V m⁻¹ for air) the insulator breaks down and the charge leaks away in a spark.

The parallel plate capacitor

Two large plates of area A are a small distance d apart (d² ≪ A), with vacuum between them, carrying ±Q, so σ = Q/A.

  1. Each plate alone gives a field σ/2ε₀ on both sides of it.
  2. Between the plates the two fields point the same way: E = σ/ε₀, uniform, from + to −.
  3. Outside the plates they cancel: E = 0. (Near the edges the field lines bulge outward - fringing - which we ignore.)
  4. Potential difference V = Ed = σd/ε₀ = Qd/(ε₀A).
  5. So C = Q/V = ε₀A/d.

C = ε₀A/d (vacuum). With a dielectric filling the gap: C = Kε₀A/d = KC₀, where K = ε/ε₀ is the dielectric constant (K > 1) and ε = Kε₀ is the permittivity of the medium.

A farad is enormous: with d = 1 cm, C = 1 F needs A = Cd/ε₀ = 0.01 ÷ 8.85 × 10⁻¹² ≈ 1.1 × 10⁹ m², a square about 30 km on a side.

Why a dielectric raises C. The polarised dielectric carries bound surface charges ±σₚ facing the plates, which cancel part of the plates' charge. The field becomes (σ − σₚ)/ε₀ = σ/(Kε₀), smaller by the factor K, so for the same Q the voltage drops to V₀/K and C = Q/V rises to KC₀. This relation C = KC₀ holds for any shape of capacitor and can be taken as the definition of K. If a slab of thickness t (less than d) is inserted, the field is E₀/K in the slab and E₀ in the air gap, which gives C = ε₀A/(d − t + t/K).

Worked example 1: a parallel plate capacitor

Plates of area 0.02 m² are 2 mm apart in air. C = ε₀A/d = 8.854 × 10⁻¹² × 0.02 ÷ 0.002 = 8.854 × 10⁻¹¹ F ≈ 88.5 pF. Connected to 100 V, Q = CV = 8.85 × 10⁻⁹ C. If the gap is filled with a material of K = 5, C becomes 5 × 88.5 ≈ 443 pF.

Combining capacitors

Series: the capacitors are joined end to end. The battery puts +Q and −Q on the two outer plates, and charge flows between the inner plates until each capacitor carries the same ±Q (otherwise there would be a field in the connecting wire). The voltages add: V = V₁ + V₂ + ... = Q/C₁ + Q/C₂ + ... . Writing V = Q/C gives 1/C = 1/C₁ + 1/C₂ + ... .

Parallel: each capacitor is connected across the same V. The charges differ, Q₁ = C₁V, Q₂ = C₂V, and add: Q = Q₁ + Q₂ + ... = (C₁ + C₂ + ...)V, so C = C₁ + C₂ + ... .

Series and parallel combinations

  • Series
    • Same charge Q on each
    • Voltages add: V = V₁ + V₂ + ...
    • 1/C = 1/C₁ + 1/C₂ + ...
    • C is smaller than the smallest one
    • Larger share of V across the smaller C
  • Parallel
    • Same voltage V across each
    • Charges add: Q = Q₁ + Q₂ + ...
    • C = C₁ + C₂ + ...
    • C is larger than the largest one
    • Larger share of Q on the larger C

Worked example 2: a network

C₁ = 3 μF and C₂ = 6 μF are in series, and this pair is in parallel with C₃ = 4 μF, all across 12 V. Series pair: 1/C = 1/3 + 1/6 = 1/2, so 2 μF. Total: 2 + 4 = 6 μF. Charge on the series branch = 2 μF × 12 V = 24 μC, the same on C₁ and C₂, so V₁ = 24 ÷ 3 = 8 V and V₂ = 24 ÷ 6 = 4 V (they add to 12 V). Charge on C₃ = 4 × 12 = 48 μC. Total charge drawn = 72 μC = 6 μF × 12 V, as it should be.

Energy stored in a capacitor

Charge the capacitor bit by bit, moving small charges δQ′ from the negative plate to the positive one. When the charge is Q′, the potential difference is Q′/C, so the work for the next bit is δW = (Q′/C) δQ′. Adding from 0 to Q gives W = Q²/2C. This work is stored as electrostatic potential energy:

U = Q²/(2C) = ½CV² = ½QV. Energy density of an electric field: u = ½ε₀E² (energy per unit volume).

For a parallel plate capacitor, U = Q²/2C = (σA)²d/(2ε₀A) = ½ε₀E² × (Ad), and Ad is the volume between the plates where the field exists. So the energy can be pictured as stored in the field itself, with density ½ε₀E². This result holds for any electric field.

Worked example 3: sharing charge loses energy

A 10 μF capacitor charged to 200 V stores U = ½ × 10 × 10⁻⁶ × 200² = 0.2 J. It is disconnected and joined to an identical uncharged capacitor. Charge is conserved and shared equally, so each is at 100 V. Total energy = 2 × ½ × 10 × 10⁻⁶ × 100² = 0.1 J. Half the energy is lost - as heat in the connecting wires and as electromagnetic radiation during the brief current that flows while the charge redistributes.

Effect of inserting a dielectric
Dielectric (K) inserted fullyBattery kept connected (V fixed)Battery removed first (Q fixed)
CapacitanceBecomes KC₀Becomes KC₀
ChargeRises to KQ₀Stays Q₀
VoltageStays V₀Falls to V₀/K
Field between platesStays V₀/dFalls to E₀/K
EnergyRises to KU₀Falls to U₀/K

Key takeaways

  • C = Q/V, in farads; it depends on geometry and the dielectric only.
  • Parallel plates: C = ε₀A/d, and C = KC₀ with a dielectric of constant K.
  • Series: 1/C = Σ 1/Cᵢ (same Q). Parallel: C = Σ Cᵢ (same V).
  • U = Q²/2C = ½CV² = ½QV; energy density ½ε₀E².

Check your understanding

  1. 1. A parallel plate air capacitor has capacitance 5 pF. What is its capacitance if the plate separation is reduced to one-third and the gap is filled with a dielectric of constant 4?

    1. 20 pF
    2. 60 pF
    3. 15 pF
    4. 6.7 pF
    Show answer

    Answer: B. C = Kε₀A/d. Reducing d to d/3 triples C, and K = 4 multiplies it by 4: 5 × 3 × 4 = 60 pF.

  2. 2. Four capacitors of 8 pF each are connected in series across 200 V. What is the potential difference across each?

    1. 200 V
    2. 800 V
    3. 50 V
    4. 25 V
    Show answer

    Answer: C. Equal capacitors in series carry the same Q and have the same C, so they share the voltage equally: 200 ÷ 4 = 50 V each. The combined capacitance is 8 ÷ 4 = 2 pF.

  3. 3. Capacitors of 1 pF, 5 pF and 6 pF are connected in parallel across 50 V. What charge is on the 5 pF capacitor?

    1. 6 × 10⁻¹⁰ C
    2. 5 × 10⁻¹² C
    3. 1 × 10⁻¹¹ C
    4. 2.5 × 10⁻¹⁰ C
    Show answer

    Answer: D. In parallel each capacitor has the full 50 V, so Q = CV = 5 × 10⁻¹² × 50 = 2.5 × 10⁻¹⁰ C. (6 × 10⁻¹⁰ C is the total charge on all three.)

  4. 4. How much energy is stored in a 20 pF capacitor connected to a 30 V battery?

    1. 9 × 10⁻⁹ J
    2. 1.8 × 10⁻⁸ J
    3. 3 × 10⁻¹⁰ J
    4. 6 × 10⁻¹⁰ J
    Show answer

    Answer: A. U = ½CV² = ½ × 20 × 10⁻¹² × 30² = 10 × 10⁻¹² × 900 = 9 × 10⁻⁹ J.

  5. 5. Assertion (A): When a dielectric slab is inserted between the plates of an isolated charged capacitor, the energy stored decreases. Reason (R): The charge stays the same while the capacitance increases, and U = Q²/2C.

    1. Both A and R are true, and R is the correct explanation of A
    2. Both A and R are true, but R is not the correct explanation of A
    3. A is true, but R is false
    4. A is false, but R is true
    Show answer

    Answer: A. Both are true. With the battery removed, Q is fixed; the dielectric raises C to KC₀, so U = Q²/2C falls to U₀/K. R gives exactly this reason. (The capacitor in fact pulls the slab in, doing work on it.)

Privacy · Terms · Refunds · Delivery