• Foundation
  • About 14 min
  • 5 practice questions

Evaporation, sedimentation and decantation

Get a dissolved solid back from a solution by evaporation, as in making salt from seawater, and separate insoluble solids or oil from water by sedimentation and decantation.

If something looks wrong, please tell us.

By the end of this lesson you can

  • Explain how evaporation separates a dissolved solid from a liquid.
  • Describe how salt is obtained from seawater.
  • Explain sedimentation and decantation and their limits.

Some mixtures cannot be picked, blown or sieved. Salt dissolved in water is spread out in particles far too small to see. Tea leaves in tea are wet and float about. Here we need methods that use water itself.

Evaporation

Spread a few drops of salt solution on a sheet of black paper and leave it to dry. White patches appear where the drops were, and they feel gritty: the water has evaporated and the salt has been left behind. The same thing happens when white patches appear on dark clothes after you sweat on a hot day: sweat contains salt.

Evaporation can separate a solid dissolved in a liquid: the liquid changes into vapour and the solid is left behind.

Worked example 1: salt from seawater

Seawater has salts dissolved in it. Step 1: it is let into shallow pits or pans near the coast. Step 2: sunlight and wind evaporate the water over several days. Step 3: a solid layer of salts is left behind. Step 4: this is collected and further purified to give common salt. Salt is also obtained from some salty inland lakes, such as Sambhar Lake in Rajasthan. Shallow pans give a large exposed area, which, as we learnt, makes evaporation faster.

In the laboratory, a teacher can heat salt solution in a china dish until all the water boils away; when the dish cools, salt is left. This should be done only by or with the teacher, as the dish gets very hot. Note that this way the water is lost into the air; we get back only the salt.

Sedimentation and decantation

Leave a pan of freshly made tea undisturbed for a few minutes. The heavier tea leaves sink to the bottom. Now tilt the pan gently and pour the tea into a cup, leaving the leaves behind.

Sedimentation then decantation

  1. Leave the mixture undisturbed Do not stir or shake it.
  2. Sedimentation The heavier insoluble solid settles at the bottom.
  3. Decantation Gently tilt and pour off the liquid above.
  4. Separated Liquid in one vessel; sediment left in the other.

Sedimentation: the heavier insoluble component settles at the bottom of a liquid. Decantation: pouring off the liquid by tilting the vessel without disturbing the settled part.

Washing rice or dal uses decantation: the grains settle and the dirty water with dust and light husk is poured off. Oil and water can also be separated by decantation: let them stand until the oil forms a separate layer on top, then pour off the oil carefully. Decantation is quick, but it is not complete: a few tea leaves or a little sediment usually slip out with the liquid.

Worked example 2: muddy water from a well

A bucket of muddy water is left standing. Step 1, sedimentation: after an hour, most of the mud has settled at the bottom. Step 2, decantation: the cleaner water on top is gently poured into another vessel. Step 3, check: the water is clearer but slightly cloudy, because very fine particles still float in it. Conclusion: decantation removes most of the mud but not all; a further method (filtration, next lesson) is needed. Even filtered water may contain germs, so drinking water must also be made safe, for example by boiling.

Key takeaways: evaporation recovers a dissolved solid, such as salt from seawater, by turning the liquid into vapour. Sedimentation lets heavy insoluble solids settle; decantation pours off the liquid above. Decantation also separates oil from water, but it is quick rather than complete.

Check your understanding

  1. 1. How is salt obtained from seawater?

    1. By sieving seawater
    2. By evaporating the water in shallow pans using sunlight and wind
    3. By handpicking salt grains from the sea
    4. By using a magnet
    Show answer

    Answer: B. Seawater is left in shallow pans; the water evaporates and salts are left behind, then purified.

  2. 2. What is sedimentation?

    1. Heating a liquid until it boils
    2. Pouring a liquid through a cloth
    3. Settling of a heavier insoluble solid at the bottom of a liquid
    4. Beating stalks to remove grain
    Show answer

    Answer: C. In sedimentation, the heavier insoluble component settles at the bottom when the mixture is left undisturbed.

  3. 3. After tea leaves settle, the tea is gently poured into a cup. What is this pouring called?

    1. Decantation
    2. Evaporation
    3. Winnowing
    4. Churning
    Show answer

    Answer: A. Pouring off the liquid by tilting the vessel, leaving the settled solid behind, is decantation.

  4. 4. Which mixture can be separated by decantation?

    1. Salt dissolved in water
    2. Iron filings and sawdust
    3. Flour and bran
    4. Oil and water
    Show answer

    Answer: D. Oil forms a separate layer on water, so it can be poured off. Dissolved salt cannot be poured off.

  5. 5. Why are white patches sometimes seen on dark clothes after sweating?

    1. Sweat turns into chalk
    2. Water in the sweat evaporates and leaves salt behind
    3. The cloth loses its colour
    4. Dust from the air sticks to sweat
    Show answer

    Answer: B. Sweat contains dissolved salt. When the water evaporates, the salt is left as white patches.

Sign in to keep track of the lessons you finish.

Next lesson → Filtration and churning

Privacy · Terms · Refunds · Delivery