- Foundation
- About 16 min
- 5 practice questions
Distillation and paper chromatography
Separate miscible liquids and recover a solvent by distillation, choose between simple and fractional distillation, and use paper chromatography to separate dyes.
If something looks wrong, please tell us.
By the end of this lesson you can
- Describe distillation and name the parts of a distillation set-up.
- Decide, from boiling points, whether simple or fractional distillation is needed.
- Carry out and explain paper chromatography, including why the pencil line and solvent level matter.
Evaporating salt water gives you the salt, but the water is lost to the air. What if you want the water too, or you need to separate two liquids that mix completely, such as acetone and water? And how can you find out how many dyes are hidden in a black ink? This lesson covers two methods for separating homogeneous mixtures: distillation and paper chromatography.
Distillation
Distillation separates the parts of a liquid mixture by boiling one of them away and then cooling its vapour back into a liquid. It is used to separate two miscible liquids (liquids that mix completely) whose boiling points are well apart, and to recover a pure liquid from a solution of a solid, such as pure water from salty water.
What happens during distillation
- Heat the mixture The liquid with the lower boiling point turns into vapour first.
- Vapour rises A thermometer at the side arm shows the temperature of the vapour leaving.
- Condense The vapour passes through a condenser cooled by flowing water and turns back into liquid.
- Collect the distillate The pure liquid drips into a separate flask; the rest stays in the distillation flask.
The main parts of the set-up are a distillation flask with the mixture, heated over a burner on a wire gauze; a thermometer whose bulb is level with the side arm; a water condenser (cold water usually enters at the lower end and leaves from the upper end so the jacket stays full); and a receiver flask for the distillate.
Simple distillation works when the boiling points of two miscible liquids differ by at least about 25 °C. For smaller differences, fractional distillation is used.
Worked example 1: simple or fractional?
A mixture contains methanol (boiling point about 65 °C) and water (boiling point 100 °C). Difference = 100 − 65 = 35 °C, which is more than 25 °C. So simple distillation will work. Methanol vapour forms first; the thermometer stays near 65 °C while methanol distils over. When almost all of it has been collected, the temperature starts rising towards 100 °C and the receiver should be changed.
Worked example 2: a close pair
Acetone boils at about 56 °C and chloroform at about 61 °C. Difference = 61 − 56 = 5 °C, far less than 25 °C. Both would boil off together in simple distillation, so fractional distillation is needed.
Fractional distillation and petroleum
In fractional distillation, the vapours pass up a tall column before reaching the condenser, so the liquids are separated even when their boiling points differ by less than about 25 °C. At a petroleum refinery, crude oil is separated this way into fractions such as petroleum gas, petrol, kerosene, diesel, lubricating oil and bitumen. Petroleum gas is filled into steel cylinders under high pressure, where it becomes a liquid: this is the LPG used in kitchens. Distillation is also used to obtain fragrances from flowers for perfumes and rose water.
Worked example 3: getting drinking water from salty water
A camper has only salty water. Boiling it in an open pan would leave salt behind but lose the water as vapour. Distillation solves this: heat the salty water, lead the steam through a tube cooled by cold water or wet cloth, and collect the drops. The salt stays in the vessel and the collected water is free of salt. The method that recovers the solvent is distillation; evaporation recovers only the solute.
Paper chromatography
Drop water on a word written with a black sketch pen and the ink spreads into bands of different colours. Black ink is a mixture of dyes. Paper chromatography uses this idea to separate the coloured parts of a mixture.
- Draw a straight line with a pencil about 2 cm above the bottom of a strip of chromatography or filter paper.
- Put a small, concentrated spot of the ink or colour on the middle of the line and let it dry.
- Stand the strip in a jar with a thin layer of solvent (water, or alcohol for leaf pigments). The solvent level must be below the spot.
- Cover the jar and watch. The solvent rises up the paper and carries the dyes with it.
- Remove the strip before the solvent reaches the top and let it dry.
Each dye interacts differently with the paper and the solvent, so each travels at its own speed and ends up at a different height. The word comes from Greek words meaning colour and writing. Why a pencil line? Graphite does not dissolve and move, but ink would. Why keep the solvent below the spot? Otherwise the spot would wash into the solvent pool instead of climbing the paper.
Worked example 4: reading a chromatogram
A spot of black sketch-pen ink gives three separate coloured spots (blue, yellow and red) at different heights; a spot of an orange food colour gives a single spot. Conclusion: the black ink is a mixture of at least three dyes. The orange colour behaves as a single dye in this solvent; another solvent might still separate it, so we say "at least" rather than "exactly". Chromatography can also separate the green and yellow pigments in spinach leaves.
Key takeaways: Distillation boils off the lower-boiling liquid and condenses it, so both parts of a mixture are recovered. Use simple distillation for a boiling-point gap of about 25 °C or more, and fractional distillation for smaller gaps, as in oil refineries. Paper chromatography separates dyes because they travel up the paper at different speeds.
Check your understanding
-
1. In a distillation set-up, what is the job of the condenser?
- To heat the mixture
- To cool the vapour so that it turns back into liquid
- To measure the boiling point
- To filter out solid impurities
Show answer
Answer: B. The condenser is cooled by flowing water. Vapour passing through it loses heat and condenses into the liquid that is collected as the distillate.
-
2. Two miscible liquids boil at 65 °C and 100 °C. Which method should be used to separate them?
- Simple distillation
- Separating funnel
- Filtration
- Sublimation
Show answer
Answer: A. The boiling points differ by 100 − 65 = 35 °C, which is more than about 25 °C, so simple distillation can separate them. A separating funnel works only for liquids that do not mix.
-
3. Alcohol boils at about 78 °C and benzene at about 80 °C. They mix completely. How can they be separated?
- Separating funnel
- Evaporation
- Fractional distillation
- Simple filtration
Show answer
Answer: C. The difference is only about 2 °C, much less than 25 °C, so simple distillation would not separate them well. Fractional distillation is used for close boiling points.
-
4. Why is the starting line in paper chromatography drawn with a pencil and not with a pen?
- Pencil lines are darker
- Ink from a pen would also dissolve and move up with the solvent, spoiling the result
- Pencil helps the solvent rise
- A pen would tear the paper
Show answer
Answer: B. Graphite from a pencil does not dissolve in the solvent and stays put. Pen ink is itself a mixture of dyes that would travel up the paper and mix with the spots being studied.
-
5. A spot of a green colour gives two spots, yellow and blue, on a paper chromatogram. What can you conclude?
- The green colour is a single pure dye
- The paper was faulty
- The solvent was coloured
- The green colour is a mixture of at least two dyes
Show answer
Answer: D. Each spot is a separate component that travelled at its own speed. Two spots show that the green colour contains at least two dyes, here a yellow and a blue one.
Sign in to keep track of the lessons you finish.