• Practice
  • About 25 min
  • 15 practice questions

Final self-assessment: Fuels and combustion

Test yourself on the whole course: 15 questions with answers explained.

If something looks wrong, please tell us.

Attempt all 15 questions without looking back at the lessons. Write down your working for the numerical questions, then check every answer and read the explanations, including for the questions you got right. These questions are a little harder than the lesson checks and mix ideas across the course.

Final self-assessment

  1. 1. When a lit match is brought near kerosene and near a log of wood, the kerosene catches fire at once but the wood does not. The reason is:

    1. Wood is non-combustible
    2. Kerosene has a lower ignition temperature than wood
    3. Kerosene contains oxygen
    4. Wood has a higher calorific value
    Show answer

    Answer: B. Both are fuels and air is present. Kerosene is inflammable: its ignition temperature is low, so a match flame heats it to that temperature quickly; a thick log takes far longer.

  2. 2. In a safety match, red phosphorus is found:

    1. In the match head along with sulphur
    2. In the wooden stick
    3. On the rubbing surface on the side of the box
    4. Nowhere; only white phosphorus is used
    Show answer

    Answer: C. The rubbing surface carries powdered glass and a little red phosphorus; the head carries antimony trisulphide and potassium chlorate.

  3. 3. Which of the following is a combustion reaction even though no carbon is involved?

    1. Rusting of iron
    2. Melting of wax
    3. Dissolving salt in water
    4. Burning of a magnesium ribbon in air
    Show answer

    Answer: D. Magnesium reacts with oxygen giving heat and a dazzling light, forming magnesium oxide. Rusting is slow oxidation; melting and dissolving are physical changes.

  4. 4. A lit candle is covered by a glass chimney placed directly on the table, and the top of the chimney is closed with a glass plate. What happens?

    1. It burns brighter as heat is trapped
    2. The flame goes out after the oxygen inside is used up
    3. The flame turns blue and steady
    4. Nothing changes
    Show answer

    Answer: B. With no fresh air entering, the oxygen inside is soon consumed and combustion stops.

  5. 5. A goldsmith melts gold using which part of the flame?

    1. The outermost zone, as it is the hottest
    2. The luminous zone, as it is the brightest
    3. The dark zone, as it contains vapour
    4. The wick
    Show answer

    Answer: A. The outermost zone has complete combustion and is the hottest, so the goldsmith blows air through a metal blowpipe to direct it onto the metal.

  6. 6. Why is carbon dioxide suitable for fires in electrical equipment?

    1. It conducts electricity away from the fire
    2. It is lighter than air and rises to the flame
    3. It is heavier than air, blankets the fire to cut off oxygen and does not harm the equipment
    4. It reacts with the burning material
    Show answer

    Answer: C. Carbon dioxide settles over the fire, cuts off oxygen and cools it, and being a non-conductor gas it neither causes shocks nor damages appliances.

  7. 7. Fuel P costs ₹40 per kg (calorific value 20,000 kJ/kg) and fuel Q costs ₹75 per kg (calorific value 50,000 kJ/kg). For 10,000 kJ of heat, which is cheaper and by how much? (Prices are illustrative.)

    1. P, by ₹5
    2. Q, by ₹35
    3. P, by ₹15
    4. Q, by ₹5
    Show answer

    Answer: D. P: 10,000 kJ needs 0.5 kg, costing ₹20. Q: 10,000 kJ needs 0.2 kg, costing ₹15. Q is cheaper by ₹5.

  8. 8. 5 kg of water is heated from 20 °C to 100 °C on a stove that passes 40% of the heat to the water. With LPG of calorific value 56,000 kJ/kg and specific heat of water 4.2 kJ per kg per °C, the LPG needed is:

    1. 30 g
    2. 75 g
    3. 120 g
    4. 187.5 g
    Show answer

    Answer: B. Heat for water = 5 × 4.2 × 80 = 1,680 kJ. Heat from fuel = 1,680 ÷ 0.4 = 4,200 kJ. Mass = 4,200 ÷ 56,000 = 0.075 kg = 75 g. Forgetting the efficiency gives 30 g.

  9. 9. Hydrogen has the highest calorific value of common fuels, yet it is not used as a household fuel mainly because:

    1. It leaves a lot of ash
    2. It produces carbon monoxide
    3. It is difficult and dangerous to store and transport
    4. It cannot burn in air
    Show answer

    Answer: C. Hydrogen burns cleanly to water, but storing and transporting it safely is difficult, so it is not yet an everyday fuel.

  10. 10. Which fuel gas contains a large proportion of a non-combustible gas, lowering its calorific value?

    1. Producer gas
    2. Water gas
    3. LPG
    4. CNG
    Show answer

    Answer: A. Producer gas is made by passing air over red-hot coke, so it is carbon monoxide diluted with nitrogen, which does not burn. Water gas is CO + H2, both combustible.

  11. 11. Which order shows the types of coal in increasing carbon content?

    1. Anthracite, bituminous, lignite, peat
    2. Lignite, peat, anthracite, bituminous
    3. Peat, bituminous, lignite, anthracite
    4. Peat, lignite, bituminous, anthracite
    Show answer

    Answer: D. Carbonisation progresses from peat to lignite to bituminous to anthracite, with carbon content rising at each stage.

  12. 12. The petroleum fraction used for making candles, ointments and petroleum jelly is:

    1. Bitumen
    2. Diesel
    3. Paraffin wax
    4. Lubricating oil
    Show answer

    Answer: C. Paraffin wax is the fraction used for candles, ointments and petroleum jelly. Bitumen is used for roads.

  13. 13. What mass of carbon dioxide forms when 8 g of methane burns completely? (C = 12, H = 1, O = 16)

    1. 11 g
    2. 22 g
    3. 44 g
    4. 8 g
    Show answer

    Answer: B. CH4 + 2O2 → CO2 + 2H2O. 8 g of methane is 8/16 = 0.5 mol, giving 0.5 mol of CO2 = 0.5 × 44 = 22 g.

  14. 14. 200 kg of coal containing 1.5% sulphur by mass is burnt. The mass of sulphur dioxide formed is: (S = 32, O = 16)

    1. 3 kg
    2. 1.5 kg
    3. 12 kg
    4. 6 kg
    Show answer

    Answer: D. Sulphur = 1.5% of 200 kg = 3 kg. S + O2 → SO2: 32 g gives 64 g, so the mass doubles: 6 kg of SO2.

  15. 15. Which balanced equation shows the incomplete combustion of methane forming carbon monoxide?

    1. 2CH4 + 3O2 → 2CO + 4H2O
    2. CH4 + 2O2 → CO2 + 2H2O
    3. CH4 + O2 → CO + H2O
    4. 2CH4 + O2 → 2CO + 2H2O
    Show answer

    Answer: A. Check atoms: left 2 C, 8 H, 6 O; right 2 C, 8 H, 2 + 4 = 6 O. Balanced. CH4 + 2O2 → CO2 + 2H2O is complete combustion; CH4 + O2 → CO + H2O and 2CH4 + O2 → 2CO + 2H2O do not balance.

If you missed any questions, revisit the matching lesson. Questions 1-3: lesson 1 (conditions, ignition temperature and types of combustion). Questions 4-6: lesson 2 (flame zones and fire control). Questions 7-9: lesson 3 (calorific value and the ideal fuel). Questions 10-12: lesson 4 (fossil fuels and gaseous fuels). Questions 13-15: lesson 5 (combustion products and calculations).

Privacy · Terms · Refunds · Delivery