- Practice
- About 24 min
- 5 practice questions
Motion in a vertical circle and power
Analyse a body whirled in a vertical circle (tension, the 6mg difference, minimum speeds √(gr) and √(5gr)), then define power, its units, the kilowatt hour and P = F⃗ · v⃗.
If something looks wrong, please tell us.
By the end of this lesson you can
- Write Newton's second law in the tangential and radial directions for a body in a vertical circle.
- Explain why vertical circular motion is not uniform and why the tension changes.
- Prove T₁ − T₂ = 6mg and find the minimum speeds √(gr) at the top and √(5gr) at the bottom.
- Define average and instantaneous power and use the watt, kilowatt, horse power and kilowatt hour.
- Derive and use P = F⃗ · v⃗.
Swing a bucket of water quickly in a vertical circle and the water stays in, even upside down; swing it slowly and you get wet. Energy conservation and Newton's laws together explain how fast you must swing. In the second half of the lesson we look at how quickly work is done, which is power.
Forces on a body in a vertical circle
A body of mass m is tied to a light, inextensible string of length r and whirled in a vertical plane about the fixed end O. When the string makes an angle θ with the downward vertical, two forces act: the weight mg (downward) and the tension T (along the string, towards O). Resolve mg into mg cos θ along the string (away from O) and mg sin θ along the tangent.
- Tangential direction: mg sin θ = m a_t = −m (dv/dt). The tangential component of gravity slows the body as it rises.
- Radial direction: T − mg cos θ = m v²/r, where v²/r is the centripetal acceleration.
From these two equations the textbook draws four facts. (i) There is a tangential acceleration g sin θ at all points except the lowest, so this is not uniform circular motion. (ii) The speed changes, so the tension also changes around the circle. (iii) In the lower half, cos θ > 0, so T = mg cos θ + mv²/r can never be zero, even if the body stops: the string stays tight. (iv) In the upper half, cos θ < 0, so mv²/r = T − mg cos θ is always positive: the speed can never be zero there, even when the tension becomes zero.
Lowest and highest points
At the lowest point 1 (speed v₁), the tension T₁ acts up towards the centre and the weight acts down: T₁ − mg = mv₁²/r, so T₁ = mv₁²/r + mg. At the highest point 2 (speed v₂), both the tension and the weight act down towards the centre: T₂ + mg = mv₂²/r, so T₂ = mv₂²/r − mg. Subtracting, T₁ − T₂ = (m/r)(v₁² − v₂²) + 2mg.
The tension is always perpendicular to the motion, so it does no work; only gravity, a conservative force, does work, so mechanical energy is conserved. Taking point 1 as the zero of potential energy, point 2 is 2r higher: ½mv₁² = ½mv₂² + mg(2r), giving v₁² − v₂² = 4gr. Substituting, T₁ − T₂ = (m/r)(4gr) + 2mg = 6mg. The string is always 6mg tighter at the bottom than at the top.
Minimum speeds to complete the circle
If the body is too slow at the top, the string goes slack and the body leaves the circle. The limiting case is T₂ = 0: then mv₂²/r = mg, so the minimum speed at the highest point is v₂ = √(gr). Using v₁² = v₂² + 4gr = gr + 4gr = 5gr, the minimum speed at the lowest point is v₁ = √(5gr). So the body must have v₂ ≥ √(gr) at the top, which needs v₁ ≥ √(5gr) at the bottom; the minimum speed needed at the bottom is √5 (about 2.24) times the minimum speed needed at the top.
Finding the minimum speed at the lowest point
- Top: string just slack Put T₂ = 0 in T₂ + mg = mv₂²/r
- Minimum top speed v₂² = gr, so v₂ = √(gr)
- Energy conservation v₁² = v₂² + 4gr (the top is 2r higher)
- Minimum bottom speed v₁² = 5gr, so v₁ = √(5gr)
Vertical circle: T₁ − T₂ = 6mg; v_top(min) = √(gr); v_bottom(min) = √(5gr).
Worked example 1: a stone on a string
A 0.2 kg stone on a string 0.9 m long is whirled in a vertical circle (g = 10 m s⁻²). Minimum top speed: v₂ = √(gr) = √(10 × 0.9) = √9 = 3 m s⁻¹. Minimum bottom speed: v₁ = √(5gr) = √45 ≈ 6.7 m s⁻¹. Tension at the bottom in this case: T₁ = m v₁²/r + mg = 0.2 × 45/0.9 + 0.2 × 10 = 10 + 2 = 12 N. Check: T₂ = 0 here, so T₁ − T₂ should be 6mg = 6 × 0.2 × 10 = 12 N. It is.
Worked example 2: does it loop?
A 0.5 kg ball on a 1.0 m string has speed 8 m s⁻¹ at the lowest point (g = 10 m s⁻²). Step 1: v₂² = v₁² − 4gr = 64 − 40 = 24, so v₂ ≈ 4.9 m s⁻¹. This is more than √(gr) = √10 ≈ 3.2 m s⁻¹, so it completes the circle. Step 2: T₂ = 0.5 × 24/1.0 − 0.5 × 10 = 12 − 5 = 7 N; T₁ = 0.5 × 64/1.0 + 5 = 32 + 5 = 37 N. Check: T₁ − T₂ = 30 N = 6 × 0.5 × 10. Correct.
Power
Two people can climb the same staircase and do the same work, but the one who climbs faster is more powerful. Power is the rate of doing work or of delivering energy: P = W/t. The average power is P_av = total work done/total time taken. The instantaneous power is the power at an instant, as the time interval approaches zero: P_inst = dW/dt.
Power is a scalar with dimensions [ML²T⁻³]. Its SI unit is the watt (W), named after James Watt: 1 W = 1 J s⁻¹. Larger units are 1 kW = 10³ W, 1 MW = 10⁶ W and 1 GW = 10⁹ W. Motors and engines are still often rated in horse power: 1 hp = 746 W. A 100 W bulb uses 100 J of electrical energy every second.
For electrical energy used over long hours, the joule is inconveniently small, so electricity bills use the kilowatt hour: 1 kWh = (10³ W) × (3600 s) = 3.6 × 10⁶ J, called one unit of electrical energy. Remember that the kWh is a unit of energy, not of power.
Power and velocity
Work done by a force is W = ∫ F⃗ · dr⃗. Write the left side as ∫ (dW/dt) dt and, since v⃗ = dr⃗/dt, the right side as ∫ F⃗ · v⃗ dt. So ∫ (dW/dt − F⃗ · v⃗) dt = 0 for any time interval, which can only be true if P = dW/dt = F⃗ · v⃗. For a vehicle on a level road, the engine force must overcome the resistive force and also provide the accelerating force ma, so P = (F_resistive + ma) × v.
P = W/t; P_inst = dW/dt = F⃗ · v⃗. 1 W = 1 J s⁻¹; 1 hp = 746 W; 1 kWh = 3.6 × 10⁶ J.
Worked example 3: an electricity bill
A 1.5 kW water heater runs for 40 minutes every day for 30 days. Step 1: time = (40/60) h × 30 = 20 h. Step 2: energy = P × t = 1.5 kW × 20 h = 30 kWh = 30 units. Step 3: in joules, 30 × 3.6 × 10⁶ = 1.08 × 10⁸ J.
Worked example 4: a water pump
A pump lifts 600 kg of water through 10 m in 2 minutes (g = 9.8 m s⁻²). Work: W = mgh = 600 × 9.8 × 10 = 58 800 J. Time: 120 s. Power: P = 58 800/120 = 490 W, which is 490/746 ≈ 0.66 hp.
Worked example 5: power of a car engine
A 1000 kg car accelerates at 0.5 m s⁻² on a level road against a resistive force of 400 N. Find the engine's power at the instant its speed is 20 m s⁻¹. Step 1: force needed = 400 + 1000 × 0.5 = 400 + 500 = 900 N. Step 2: P = F v = 900 × 20 = 18 000 W = 18 kW.
Key takeaways
- Vertical circular motion is non-uniform; T = mg cos θ + mv²/r varies round the circle.
- T₁ − T₂ = 6mg; minimum speeds are √(gr) at the top and √(5gr) at the bottom.
- Power = rate of doing work; SI unit watt; 1 hp = 746 W.
- The kilowatt hour (3.6 × 10⁶ J) is the unit of electrical energy; P = F⃗ · v⃗.
Check your understanding
-
1. A body is whirled in a vertical circle of radius 2.5 m (g = 10 m s⁻²). The minimum speed it must have at the highest point is:
- 25 m s⁻¹
- 5 m s⁻¹
- 11.2 m s⁻¹
- 2.5 m s⁻¹
Show answer
Answer: B. At the top, with T = 0, mg = mv²/r, so v = √(gr) = √(10 × 2.5) = √25 = 5 m s⁻¹. 11.2 m s⁻¹ is √(5gr), the minimum speed at the lowest point.
-
2. A 0.1 kg mass moves in a vertical circle on a string (g = 10 m s⁻²). The tension at the lowest point exceeds the tension at the highest point by:
- 2 N
- 1 N
- 4 N
- 6 N
Show answer
Answer: D. T₁ − T₂ = 6mg = 6 × 0.1 × 10 = 6 N, whatever the speed or radius.
-
3. For a stone to just complete a vertical circle of radius 0.4 m (g = 10 m s⁻²), its speed at the lowest point must be at least:
- 4.47 m s⁻¹
- 2 m s⁻¹
- 20 m s⁻¹
- 6.32 m s⁻¹
Show answer
Answer: A. v₁(min) = √(5gr) = √(5 × 10 × 0.4) = √20 ≈ 4.47 m s⁻¹. 2 m s⁻¹ is √(gr), the minimum at the top.
-
4. A 2 kW heater is used for 3 hours. The electrical energy used is:
- 6 kW
- 2.16 × 10⁷ J
- 6 × 10³ J
- 2.16 × 10⁴ J
Show answer
Answer: B. Energy = P × t = 2 kW × 3 h = 6 kWh = 6 × 3.6 × 10⁶ J = 2.16 × 10⁷ J. '6 kW' is a power, not an energy.
-
5. A horse pulls a cart with a steady force of 200 N along the road while the cart moves at a constant 5 m s⁻¹. The power delivered by the horse is:
- 40 W
- 205 W
- 1000 W
- 1 hp exactly
Show answer
Answer: C. P = F v = 200 × 5 = 1000 W (about 1.34 hp, since 1 hp = 746 W).
Sign in to keep track of the lessons you finish.