• Practice
  • About 30 min
  • 15 practice questions

Final self-assessment: Surface Chemistry

Test yourself on the whole course: 15 questions with answers explained.

If something looks wrong, please tell us.

Attempt all 15 questions in one sitting of about 30 minutes, with rough paper for the few calculations. The questions are harder than the lesson checks and mix ideas from all five lessons. Check your answers only after you have finished, and read every explanation, including those for the questions you got right.

Final self-assessment

  1. 1. Which statement about physisorption is INCORRECT?

    1. It is reversible.
    2. It increases with increase in temperature.
    3. Its heat of adsorption is low.
    4. It increases with the surface area of the adsorbent.
    Show answer

    Answer: B. Physisorption is exothermic and held by weak forces, so raising the temperature makes molecules desorb: the amount adsorbed falls. The other three statements are true.

  2. 2. The chemisorption isobar first rises and then falls with temperature. What causes the initial rise?

    1. Desorption of the adsorbate
    2. The weakening of van der Waals forces
    3. The need for activation energy to form the chemisorbed activated complex
    4. The formation of multilayers
    Show answer

    Answer: C. Chemisorption needs appreciable activation energy, so at low temperature few molecules can be chemisorbed. Warming supplies this energy and x/m rises; at still higher temperature desorption wins and x/m falls.

  3. 3. For a Freundlich isotherm, x/m = 0.30 at 1 atm and 0.60 at 4 atm (same temperature). What is the value of n?

    1. 2
    2. 0.5
    3. 4
    4. 1
    Show answer

    Answer: A. At p = 1, x/m = k = 0.30. Then 0.60 = 0.30 × 4¹ᐟⁿ, so 4¹ᐟⁿ = 2 and 1/n = log 2 ÷ log 4 = 0.5. Therefore n = 2 (the exponent 1/n is 0.5).

  4. 4. Which of these statements about catalysts is correct?

    1. A catalyst increases the yield of ammonia at equilibrium in the Haber process.
    2. A catalyst can start a reaction that is not thermodynamically possible.
    3. A catalyst is used up in the reaction and must be replaced in equal amount.
    4. A catalyst provides a path of lower activation energy for both forward and backward reactions.
    Show answer

    Answer: D. A catalyst lowers the activation energy of the forward and reverse reactions alike, so equilibrium is reached faster but its position (and the yield) is unchanged. It cannot make an impossible reaction occur and is not consumed.

  5. 5. In 2SO₂ + O₂ → 2SO₃ over platinum, traces of As₂O₃ in the gases stop the reaction. In terms of the adsorption theory, this is because As₂O₃

    1. acts as a promoter
    2. occupies the active centres of the platinum
    3. reacts with SO₃ to form SO₂
    4. is a homogeneous catalyst
    Show answer

    Answer: B. As₂O₃ is a catalytic poison for platinum: it is strongly adsorbed on the active centres, leaving no sites where SO₂ and O₂ can be adsorbed and activated.

  6. 6. Which pair of reactions shows the intermediate compound theory for the formation of water from H₂ and O₂ over copper?

    1. 2Cu + ½O₂ → Cu₂O, then Cu₂O + H₂ → H₂O + 2Cu
    2. Cu + H₂ → CuH₂, then CuH₂ → Cu + H₂
    3. 2Cu + O₂ → 2CuO, then 2CuO → 2Cu + O₂
    4. H₂ + O₂ → H₂O₂, then H₂O₂ → H₂O + ½O₂
    Show answer

    Answer: A. Copper first forms the intermediate Cu₂O with oxygen; hydrogen then reduces it to water and copper. Adding the steps gives H₂ + ½O₂ → H₂O with copper regenerated. The other pairs either give no water or do not pass through a copper intermediate.

  7. 7. Which is NOT a characteristic of enzyme catalysis?

    1. It is highly specific.
    2. It has an optimum pH.
    3. Its rate keeps increasing with temperature without limit.
    4. It can be inhibited by poisons.
    Show answer

    Answer: C. Enzyme activity rises only up to the optimum temperature; above it the protein is denatured and the rate falls sharply, even to zero. The other three are genuine features of enzymes.

  8. 8. In the decomposition of H₂O₂, the textbook gives activation energies of 18 kcal mol⁻¹ (no catalyst), 11.7 kcal mol⁻¹ (colloidal platinum) and less than 2 kcal mol⁻¹ (enzyme). By how much more does the enzyme lower the barrier than platinum does, at least?

    1. About 6.3 kcal mol⁻¹
    2. About 16 kcal mol⁻¹
    3. About 2 kcal mol⁻¹
    4. About 9.7 kcal mol⁻¹
    Show answer

    Answer: D. Platinum lowers it by 18 − 11.7 = 6.3 kcal mol⁻¹. The enzyme lowers it by more than 18 − 2 = 16 kcal mol⁻¹. The difference is at least 16 − 6.3 = 9.7 kcal mol⁻¹ (equivalently 11.7 − 2 = 9.7).

  9. 9. A zeolite catalyst cracks a straight-chain alkane but leaves a highly branched alkane in the same feed untouched, because the branched molecule cannot enter the pores. This is

    1. product selectivity
    2. transition-state selectivity
    3. reactant selectivity
    4. phase transfer catalysis
    Show answer

    Answer: C. When bulky reactant molecules are kept away from the active sites inside the pores, only the smaller reactants react: reactant shape selectivity.

  10. 10. Which colloid has a solid dispersed phase in a liquid dispersion medium?

    1. Butter
    2. Paint
    3. Pumice stone
    4. Milk
    Show answer

    Answer: B. Paint (like ink) is a sol: solid pigment particles in a liquid. Butter is a gel (liquid in solid), pumice a solid foam (gas in solid) and milk an emulsion (liquid in liquid).

  11. 11. In the preparation of gold sol, 2AuCl₃ + 3HCHO + 3H₂O → 2Au + 6HCl + 3HCOOH, which statement is correct?

    1. Formaldehyde is reduced and gold is oxidised.
    2. It is a hydrolysis method.
    3. Each Au³⁺ gains 3 electrons, and 6 electrons in all are supplied by 3 HCHO molecules.
    4. The equation is not balanced for hydrogen.
    Show answer

    Answer: C. Gold goes from +3 to 0, so 2 Au gain 6 electrons; carbon goes from 0 in HCHO to +2 in HCOOH, so 3 molecules lose 6 electrons. HCHO is the reducing agent (this is the reduction method). Hydrogen balances: 6 + 6 = 12 on the left, 6 + 6 = 12 on the right.

  12. 12. Which purification method would remove NaCl from a gold sol fastest?

    1. Ordinary filtration
    2. Electrodialysis
    3. Simple dialysis
    4. Adding more NaCl
    Show answer

    Answer: B. Ordinary filter paper lets both pass. Dialysis removes the ions slowly by diffusion; electrodialysis drives them through the membrane with an electric field, so it is faster. Adding NaCl would coagulate the sol.

  13. 13. Practice data: the flocculation values of three electrolytes for a sol (mmol L⁻¹) are: NaCl 52, BaCl₂ 0.69, AlCl₃ 0.09. What is the sign of charge on the sol and which electrolyte coagulates it best?

    1. Negative; AlCl₃
    2. Positive; NaCl
    3. Negative; NaCl
    4. Positive; AlCl₃
    Show answer

    Answer: A. The values fall sharply as the cation charge rises (Na⁺, Ba²⁺, Al³⁺) while the anion (Cl⁻) is the same, so the cations are doing the coagulating and the sol must be negative. The smallest flocculation value (AlCl₃, 0.09) means the greatest coagulating power.

  14. 14. Assertion (A): A small amount of gelatine added to a gold sol makes it much harder to coagulate with NaCl. Reason (R): Gelatine is a lyophilic colloid with a very small gold number.

    1. Both A and R are true, and R is the correct explanation of A.
    2. Both A and R are true, but R is not the correct explanation of A.
    3. A is true, but R is false.
    4. A is false, but R is true.
    Show answer

    Answer: A. Gelatine is lyophilic and protects lyophobic gold sol; its tiny gold number (about 0.005-0.01) means very little is needed. That protective power is exactly why A happens, so R explains A.

  15. 15. An oil-in-water emulsion stabilised by a potassium soap is shaken with a little CaCl₂ and becomes a water-in-oil emulsion. This change is called

    1. demulsification
    2. peptisation
    3. electro-osmosis
    4. inversion of phase
    Show answer

    Answer: D. Changing an emulsion from one type to the other (here O/W to W/O) is inversion of phase. Demulsification would separate the liquids into layers instead.

Questions 1-3: lesson 1 (adsorption and the Freundlich isotherm). Questions 4-6: lesson 2 (catalysis and its theories). Questions 7-9: lesson 3 (enzyme, zeolite, phase transfer and nano catalysis). Questions 10-12: lesson 4 (colloids: classification, preparation and purification). Questions 13-15: lesson 5 (properties of colloids, coagulation, protection and emulsions).

Sign in to keep track of the lessons you finish.

Privacy · Terms · Refunds · Delivery