- Practice
- About 25 min
- 15 practice questions
Final self-assessment: Magnetism and Electromagnetism
Test yourself on the whole course: 15 questions with answers explained.
If something looks wrong, please tell us.
Attempt all 15 questions before you look at any answer. Write your choices on paper, then read every explanation, including those for questions you got right, and note which lessons to revisit.
Final self-assessment
-
1. Which statement about magnetic field lines is FALSE?
- They are closed continuous curves
- They never intersect
- They run from S to N outside the magnet
- They are crowded near the poles
Show answer
Answer: C. Outside a magnet field lines run from N to S, not S to N. The other statements (closed curves, never intersecting, crowded at the poles where the field is strongest) are all true.
-
2. A uniform field of 0.4 T passes normally through a coil of area 25 cm². What is the flux through it?
- 10 Wb
- 1 × 10⁻³ Wb
- 0.1 Wb
- 1.6 × 10⁻² Wb
Show answer
Answer: B. Area = 25 cm² = 25 × 10⁻⁴ m² = 2.5 × 10⁻³ m². ϕ = B × A = 0.4 × 2.5 × 10⁻³ = 1 × 10⁻³ Wb. Forgetting to convert cm² to m² gives 10.
-
3. Which pair is correctly matched?
- Magnetic material: wood
- Non-magnetic material: iron
- Current and magnetism: Faraday
- Electromagnetic induction: Faraday
Show answer
Answer: D. Faraday discovered electromagnetic induction in 1831. Iron is magnetic, wood is non-magnetic, and the link between current and magnetism was first shown by Oersted.
-
4. A vertical wire carries current downward. Seen from above, the magnetic field lines around it are
- clockwise circles
- anticlockwise circles
- straight lines pointing north
- absent
Show answer
Answer: A. Right-hand thumb rule: thumb pointing down (away from an eye above). The fingers then curl clockwise as seen from above.
-
5. Which of these does NOT affect the strength of the magnetic field at a point near a straight current-carrying wire?
- The current in the wire
- The distance of the point from the wire
- The magnetic nature of the medium
- The colour of the wire's insulation
Show answer
Answer: D. The field depends on the current, the distance and orientation of the point and the medium. The colour of the insulation has no effect.
-
6. What did Oersted's experiment show?
- A changing magnetic field produces current
- A current-carrying conductor produces a magnetic field around it
- Magnets lose their magnetism when heated
- Like poles attract
Show answer
Answer: B. Oersted saw a compass needle deflect near a current-carrying wire, showing that current produces a magnetic field. Producing current from a changing field was Faraday's later discovery.
-
7. A wire 20 cm long carrying 2.5 A lies at right angles to a field of 0.8 T. What is the force on it?
- 0.4 N
- 40 N
- 4 N
- 0.04 N
Show answer
Answer: A. F = ILB = 2.5 × 0.2 × 0.8 = 0.4 N. Using 20 instead of 0.2 m gives 40, a hundred times too large.
-
8. Fleming's left-hand rule is used in which device?
- Transformer
- ac generator
- Electric motor
- Compass
Show answer
Answer: C. The left-hand (motor) rule gives the direction of the force on a current in a magnetic field, which is how a motor turns. Generators use the right-hand rule.
-
9. Two parallel wires carry currents in opposite directions. What happens?
- They attract
- They repel
- They feel no force
- Only one wire feels a force
Show answer
Answer: B. Parallel currents in opposite directions repel each other; in the same direction they attract. The forces on the two wires are equal and opposite.
-
10. Why does a coil in a motor without a commutator only rock to and fro instead of turning continuously?
- The magnet is too weak
- The forces reverse their turning effect after each half turn because the current in the coil does not reverse
- The coil has too many turns
- There is no current in the coil
Show answer
Answer: B. After half a turn each side of the coil has swapped places. Unless the current in the coil reverses, the forces now turn it back. The split-ring commutator reverses the current each half turn to keep it rotating.
-
11. A magnet is pushed into a coil connected to a galvanometer, first slowly and then quickly. What do you observe?
- No deflection either time
- Same deflection both times
- A larger deflection when it is pushed quickly
- A larger deflection when it is pushed slowly
Show answer
Answer: C. The induced e.m.f. is proportional to the rate of change of flux. Pushing the magnet in quickly changes the flux faster, giving a larger deflection.
-
12. According to Lenz's law, the induced current
- always flows clockwise
- helps the change that causes it
- is always zero
- opposes the change that causes it
Show answer
Answer: D. Lenz's law says the induced current flows so as to oppose the change in flux producing it. For example, a north pole pushed into a coil makes a north pole at that end of the coil, which repels it.
-
13. What change turns an ac generator into a dc generator?
- Replacing the slip rings with a split-ring commutator
- Using a stronger magnet
- Removing the brushes
- Adding more turns
Show answer
Answer: A. With a split-ring commutator the connections to the outer circuit swap every half turn, so the output current always flows in the same direction.
-
14. An ideal transformer steps 220 V down to 11 V. If the secondary current is 4 A, what is the primary current?
- 80 A
- 2 A
- 0.2 A
- 4 A
Show answer
Answer: C. Turns ratio Ns/Np = 11/220 = 1/20. Ip = Is × Ns/Np = 4 ÷ 20 = 0.2 A. Stepping voltage down steps current up, so the primary current is smaller.
-
15. In a loudspeaker, what makes the cone vibrate?
- A heating element
- A coil whose changing magnetic field is pushed and pulled by a permanent magnet
- A transformer core
- Air pressure from the room
Show answer
Answer: B. The changing signal current keeps reversing the field of the coil attached to the cone, so the fixed permanent magnet alternately attracts and repels it, making the cone vibrate and produce sound.
Questions 1-3: lesson 1 (magnets and field lines). Questions 4-6: lesson 2 (magnetic effect of current). Questions 7-9: lesson 3 (force on a conductor). Questions 10-12: lesson 4 (motor and induction). Questions 13-15: lesson 5 (generators, transformers and uses).
Sign in to keep track of the lessons you finish.