• Foundation
  • About 20 min
  • 5 practice questions

Thermal expansion of solids, liquids and gases

Use the coefficients of linear, area and volume expansion, prove αv = 3αl, explain the anomalous expansion of water, find αv for an ideal gas and calculate thermal stress.

If something looks wrong, please tell us.

By the end of this lesson you can

  • Define the coefficients of linear and volume expansion and calculate changes in length and volume.
  • Prove that the coefficient of volume expansion is three times the linear one, and area expansion twice.
  • Explain the anomalous expansion of water and its importance for life in lakes.
  • Show that αv = 1/T for an ideal gas and calculate thermal stress in a clamped rod.

A stuck metal lid on a glass jar loosens when dipped in hot water; mercury rises in a thermometer; a partly filled balloon swells in warm water. Most substances expand on heating and contract on cooling. The increase in size of a body due to a rise in temperature is thermal expansion: in length (linear), in area (superficial) or in volume (cubical).

Linear, area and volume expansion

For a rod of length l and a small temperature rise ΔT, the fractional change in length is proportional to ΔT: Δl/l = αl ΔT. The constant αl is the coefficient of linear expansion, a property of the material, in K⁻¹. Similarly ΔA/A = αA ΔT for area and ΔV/V = αv ΔT for volume. Metals expand more than glass: approximate textbook values are αl ≈ 1.2 × 10⁻⁵ K⁻¹ for iron and steel, 1.7 × 10⁻⁵ K⁻¹ for copper and 0.32 × 10⁻⁵ K⁻¹ for Pyrex glass. Invar, an iron-nickel alloy, expands very little. αv is not strictly constant; it depends somewhat on temperature.

Proof that αv = 3αl

  1. Take a cube of side l that expands equally in all directions; Δl = αl l ΔT.
  2. New volume (l + Δl)³ = l³ + 3l²Δl + 3l(Δl)² + (Δl)³.
  3. Δl is tiny compared with l, so the (Δl)² and (Δl)³ terms are negligible: ΔV ≈ 3l²Δl.
  4. Divide by V = l³: ΔV/V = 3Δl/l = 3αl ΔT.
  5. Comparing with ΔV/V = αv ΔT gives αv = 3αl. The same argument for a rectangle gives αA = 2αl.

Δl = αl l ΔT, ΔA = 2αl A ΔT, ΔV = 3αl V ΔT, so αl : αA : αv = 1 : 2 : 3.

The anomalous expansion of water

Water behaves unusually: when cooled from room temperature it contracts until 4 °C, but below 4 °C it expands again. So water has its maximum density at 4 °C. When a lake cools in winter, the surface water cools, becomes denser and sinks, until the whole lake is at about 4 °C. Further cooling makes the surface water lighter, so it stays on top and freezes there. Ice therefore forms at the top first, and the water below stays at about 4 °C, so fish and plants survive. If lakes froze from the bottom up, much of their life would be destroyed.

Why a lake freezes from the top

  1. Surface water cools Above 4 °C it becomes denser and sinks.
  2. Whole lake reaches about 4 °C Water at 4 °C is densest and stays at the bottom.
  3. Surface cools below 4 °C It is now less dense, so it stays on top.
  4. Ice forms on the surface Water below remains near 4 °C; life survives.

Expansion of gases

Gases expand much more than solids or liquids. For an ideal gas at constant pressure, PV = μRT gives PΔV = μRΔT. Dividing by PV = μRT: ΔV/V = ΔT/T, so αv = 1/T. At 0 °C (273 K) this is about 3.7 × 10⁻³ K⁻¹, hundreds of times larger than for typical solids, and it gets smaller as the temperature rises.

Thermal stress

If a rod's ends are fixed rigidly so it cannot expand, heating it produces a compressive strain equal to the expansion it was denied, Δl/l = αl ΔT. The resulting thermal stress is Y × strain = Y αl ΔT, and the force on the supports is Y αl ΔT × A. These forces can bend railway tracks or crack roads, which is why expansion gaps are left.

Worked example 1: a steel rail

A steel rail is 10 m long at 15 °C. How much longer is it at 45 °C? (αl = 1.2 × 10⁻⁵ K⁻¹) ΔT = 30 K. Δl = αl l ΔT = 1.2 × 10⁻⁵ × 10 × 30 = 3.6 × 10⁻³ m = 3.6 mm.

Worked example 2: fitting a ring on a shaft

A copper ring has an inner diameter of 10.00 cm at 27 °C. It must slip over a shaft of diameter 10.02 cm. To what temperature must the ring be heated? (αl = 1.7 × 10⁻⁵ K⁻¹) Needed Δd = 0.02 cm. ΔT = Δd/(αl d) = 0.02/(1.7 × 10⁻⁵ × 10.00) = 0.02/(1.7 × 10⁻⁴) ≈ 118 K. Final temperature ≈ 27 + 118 = 145 °C. On cooling, the ring grips the shaft tightly.

Worked example 3: thermal stress in a clamped rod

A steel rod is clamped between rigid walls at 20 °C and heated to 40 °C. Take Y = 2.0 × 10¹¹ N m⁻² and αl = 1.2 × 10⁻⁵ K⁻¹. Thermal stress = Y αl ΔT = 2.0 × 10¹¹ × 1.2 × 10⁻⁵ × 20 = 4.8 × 10⁷ N m⁻². For a cross-section of 10 cm² (1.0 × 10⁻³ m²) the force on each wall is 4.8 × 10⁴ N.

Key takeaways

  • Δl/l = αl ΔT; αA = 2αl and αv = 3αl for an isotropic solid.
  • Water is densest at 4 °C, so lakes freeze from the top down.
  • For an ideal gas at constant pressure αv = 1/T.
  • A rod prevented from expanding feels thermal stress Y αl ΔT.

Check your understanding

  1. 1. A brass rod 2.0 m long is heated through 50 K. If αl = 1.8 × 10⁻⁵ K⁻¹, by how much does it lengthen?

    1. 0.9 mm
    2. 1.8 mm
    3. 3.6 mm
    4. 18 mm
    Show answer

    Answer: B. Δl = αl l ΔT = 1.8 × 10⁻⁵ × 2.0 × 50 = 1.8 × 10⁻³ m = 1.8 mm.

  2. 2. A solid has a coefficient of linear expansion of 1.0 × 10⁻⁵ K⁻¹. What is its coefficient of volume expansion?

    1. 1.0 × 10⁻⁵ K⁻¹
    2. 2.0 × 10⁻⁵ K⁻¹
    3. 3.0 × 10⁻⁵ K⁻¹
    4. 1.0 × 10⁻¹⁵ K⁻¹
    Show answer

    Answer: C. For a solid expanding equally in all directions αv = 3αl = 3 × 1.0 × 10⁻⁵ = 3.0 × 10⁻⁵ K⁻¹. Twice the value would be the coefficient of area expansion.

  3. 3. In a cold winter a pond freezes at the top first, and water at the bottom stays at about 4 °C. This is because

    1. ice is denser than water
    2. the bottom of the pond is heated by the sun
    3. heat flows downward in water
    4. water is densest at 4 °C, so colder water stays on top
    Show answer

    Answer: D. Water contracts on cooling only down to 4 °C and expands below it. So water at 4 °C sinks and stays at the bottom, while colder, lighter water stays at the surface and freezes there.

  4. 4. What is the coefficient of volume expansion of an ideal gas at constant pressure at 300 K?

    1. 3.3 × 10⁻³ K⁻¹
    2. 300 K⁻¹
    3. 3.7 × 10⁻⁵ K⁻¹
    4. 1.0 × 10⁻³ K⁻¹
    Show answer

    Answer: A. For an ideal gas αv = 1/T = 1/300 K⁻¹ ≈ 3.3 × 10⁻³ K⁻¹. It is far larger than the value for solids and liquids.

  5. 5. Assertion (A): A metal lid stuck tightly on a glass bottle can be loosened by dipping it in hot water. Reason (R): Metals generally have a larger coefficient of thermal expansion than glass.

    1. Both A and R are true, and R is the correct explanation of A
    2. Both A and R are true, but R is not the correct explanation of A
    3. A is true, but R is false
    4. A is false, but R is true
    Show answer

    Answer: A. On heating, the metal lid expands more than the glass neck because metals have larger expansion coefficients, so the lid becomes loose. R explains A.

Privacy · Terms · Refunds · Delivery