- Foundation
- About 20 min
- 5 practice questions
Osmosis, osmotic pressure and the van't Hoff factor
Explain osmosis and reverse osmosis, use π = CRT to find osmotic pressure and molar masses, classify isotonic, hypertonic and hypotonic solutions, and correct colligative properties for dissociation and association with i.
If something looks wrong, please tell us.
By the end of this lesson you can
- Define osmosis, osmotic pressure and a semipermeable membrane.
- Use π = CRT and M₂ = w₂RT ÷ (πV) in calculations.
- Explain isotonic, hypertonic and hypotonic solutions and reverse osmosis.
- Define the van't Hoff factor and use it for electrolytes and associating solutes.
A raw mango shrivels in salty brine, a limp carrot becomes firm in fresh water and red blood cells burst in pure water. All three are examples of osmosis, the fourth colligative property. Osmosis is also the most sensitive colligative property, which makes it the method of choice for finding the molar masses of proteins and polymers.
Osmosis and osmotic pressure
Some membranes, such as parchment, an animal bladder or cellophane, contain tiny pores that let small solvent molecules pass but hold back larger solute particles. These are semipermeable membranes (SPM). If an SPM separates a pure solvent from a solution, solvent flows through it into the solution. This net flow of solvent from the pure solvent (or a more dilute solution) to the more concentrated solution through an SPM is osmosis.
The flow can be stopped by pushing on the solution side. The osmotic pressure (π) of a solution is the excess pressure that must be applied to the solution to just prevent osmosis. For dilute solutions, experiments show:
π = C R T = (n₂ ÷ V) R T, where C is the molarity, R the gas constant and T the temperature in kelvin. With n₂ = w₂ ÷ M₂: M₂ = (w₂ R T) ÷ (π V).
We use R = 0.083 L bar mol⁻¹ K⁻¹ when π is in bar and V in litres. Osmotic pressure has clear advantages for macromolecules: it is measured at room temperature (useful for biomolecules that break down on heating), it uses molarity instead of molality, and it is large even for very dilute solutions (useful for polymers that dissolve only slightly).
Worked example 1: osmotic pressure of a glucose solution
Find the osmotic pressure of a 0.10 M glucose solution at 300 K.
π = CRT = 0.10 mol L⁻¹ × 0.083 L bar mol⁻¹ K⁻¹ × 300 K = 2.49 bar. Compare: the same solution would lower the freezing point of water by only about 0.19 K, which is far harder to measure precisely.
Worked example 2: molar mass of a polymer
2.0 g of a polymer dissolved in water to make 250 mL of solution has an osmotic pressure of 8.3 × 10⁻³ bar at 300 K. Find the molar mass.
M₂ = (w₂ R T) ÷ (π V) = (2.0 × 0.083 × 300) ÷ (8.3 × 10⁻³ × 0.250) = 49.8 ÷ (2.075 × 10⁻³) = 2.4 × 10⁴ g mol⁻¹ (24 000 g mol⁻¹).
Isotonic, hypertonic and hypotonic solutions
Two solutions with the same osmotic pressure at the same temperature are isotonic; no osmosis occurs between them. The fluid inside red blood cells is isotonic with 0.9% (mass/volume) sodium chloride, the 'normal saline' used for drips. A more concentrated (hypertonic) solution draws water out of cells, which shrink; a less concentrated (hypotonic) one lets water flow in, and cells swell and may burst.
- Raw mangoes in brine and salted meat lose water by osmosis; bacteria on salted meat or sugared fruit lose water and die, which preserves the food.
- Wilted flowers and limp carrots take in water and become firm again.
- Too much salt in the diet makes tissues retain water, causing swelling called edema.
- Water rises from soil into plant roots partly by osmosis.
Reverse osmosis
If a pressure larger than the osmotic pressure is applied on the solution side, the flow reverses: pure solvent is squeezed out of the solution through the membrane. This reverse osmosis is used to desalinate sea water, using membranes such as cellulose acetate film, which pass water but hold back ions and impurities.
Osmosis and reverse osmosis
-
Osmosis
- Happens on its own
- Solvent moves from pure solvent into the solution
- Stopped by applying a pressure equal to π
-
Reverse osmosis
- Needs an applied pressure greater than π
- Solvent moves out of the solution into the pure solvent side
- Used to purify sea water
Abnormal molar masses and the van't Hoff factor
Colligative properties count particles. If a solute dissociates (KCl → K⁺ + Cl⁻), there are more particles than formula units, the colligative effect is larger, and the molar mass calculated from it comes out lower than the true value. If a solute associates (ethanoic acid forms dimers in benzene through hydrogen bonding), there are fewer particles, the effect is smaller, and the calculated molar mass is higher. A molar mass that differs from the true value for these reasons is called abnormal.
van't Hoff factor: i = normal molar mass ÷ abnormal (observed) molar mass = observed colligative property ÷ calculated colligative property = total moles of particles after association or dissociation ÷ moles of particles before.
For dissociation i > 1 (close to 2 for dilute KCl, close to 3 for K₂SO₄); for association i < 1 (about 0.5 for ethanoic acid fully dimerised in benzene). The equations become: relative lowering = i n₂ ÷ n₁; ΔTb = i Kb m; ΔTf = i Kf m; π = i n₂ RT ÷ V.
Relating i to the degree of change. For dissociation into ν ions with degree α: i = 1 + (ν − 1) α. For association into n-mers with degree x: i = 1 − x + x ÷ n.
Worked example 3: freezing point of salt water
Find the freezing point of a 0.10 mol kg⁻¹ aqueous NaCl solution, assuming complete dissociation. Kf = 1.86 K kg mol⁻¹; water freezes at 273.15 K.
NaCl → Na⁺ + Cl⁻, so i = 2.
ΔTf = i Kf m = 2 × 1.86 × 0.10 = 0.372 K.
Tf = 273.15 − 0.372 = 272.78 K.
Worked example 4: degree of association
A carboxylic acid dimerises in benzene (2 RCOOH ⇌ (RCOOH)₂). Its observed freezing point depression is 0.60 times the value calculated for no association. Find the degree of association x.
i = 0.60. For dimers, i = 1 − x + x ÷ 2 = 1 − x ÷ 2.
1 − x ÷ 2 = 0.60 → x ÷ 2 = 0.40 → x = 0.80, i.e. 80% of the acid molecules are dimerised.
Key takeaways
- Osmosis: solvent flows through an SPM into the more concentrated solution; π = CRT.
- Isotonic solutions have equal π; normal saline (0.9% w/V NaCl) is isotonic with blood cells.
- Reverse osmosis needs pressure greater than π and is used to desalinate water.
- i > 1 for dissociation, i < 1 for association; multiply each colligative equation by i.
Check your understanding
-
1. What is the osmotic pressure of a 0.20 M solution of a non-electrolyte at 300 K? (R = 0.083 L bar mol⁻¹ K⁻¹)
- 4.98 bar
- 2.49 bar
- 0.498 bar
- 49.8 bar
Show answer
Answer: A. π = CRT = 0.20 × 0.083 × 300 = 4.98 bar.
-
2. Red blood cells are placed in a 2% (mass/volume) NaCl solution. What happens to them?
- They swell and may burst
- Nothing, because the solution is isotonic
- They shrink as water flows out
- They absorb salt and grow
Show answer
Answer: C. Blood cell fluid is isotonic with 0.9% NaCl. A 2% solution is hypertonic, so water moves out of the cells by osmosis and they shrink.
-
3. What is the van't Hoff factor for K₂SO₄ in a very dilute aqueous solution, assuming complete dissociation?
- 1
- 2
- 4
- 3
Show answer
Answer: D. K₂SO₄ → 2K⁺ + SO₄²⁻ gives three ions per formula unit, so i = 3 for complete dissociation.
-
4. Assertion (A): The molar mass of ethanoic acid found from the freezing point depression of its benzene solution is about twice its true value. Reason (R): Ethanoic acid molecules form dimers in benzene through hydrogen bonding.
- Both A and R are true, and R is the correct explanation of A
- Both A and R are true, but R is not the correct explanation of A
- A is true, but R is false
- A is false, but R is true
Show answer
Answer: A. Both are true. Dimerisation halves the number of particles, so ΔTf is about half the expected value. Since M₂ is inversely proportional to ΔTf, the calculated molar mass comes out about twice the true value. R explains A.
-
5. A weak acid HA (HA ⇌ H⁺ + A⁻) has a van't Hoff factor of 1.05 in a dilute aqueous solution. What is its degree of dissociation?
- 0.5%
- 5%
- 50%
- 10.5%
Show answer
Answer: B. For a solute giving two ions, i = 1 + α. So α = i − 1 = 1.05 − 1 = 0.05, which is 5% dissociation.
Sign in to keep track of the lessons you finish.