• Foundation
  • About 20 min
  • 5 practice questions

Vapour pressure, Raoult's law and ideal and non-ideal solutions

State Raoult's law for volatile and non-volatile components, calculate total vapour pressure and vapour composition, and explain positive and negative deviations and azeotropes from molecular forces.

If something looks wrong, please tell us.

By the end of this lesson you can

  • State Raoult's law and derive p_total = p₁⁰ + (p₂⁰ − p₁⁰) x₂.
  • Calculate the mole fractions of components in the vapour using Dalton's law.
  • Show that Raoult's law is a special case of Henry's law.
  • Distinguish ideal and non-ideal solutions and explain positive and negative deviations and azeotropes.

Every liquid in a closed container evaporates until its vapour exerts a steady pressure, the vapour pressure. When two liquids are mixed, or a solid is dissolved in a liquid, the vapour pressure changes in a predictable way. This lesson gives the law behind that change and uses it to sort solutions into ideal and non-ideal.

Raoult's law for a mixture of two volatile liquids

Take a binary solution of two volatile liquids, 1 and 2, in a closed vessel at constant temperature. Both evaporate until the liquid and vapour are in equilibrium. Let p₁ and p₂ be their partial vapour pressures and x₁ and x₂ their mole fractions in the liquid.

Raoult's law: for a solution of volatile liquids, the partial vapour pressure of each component is directly proportional to its mole fraction in the solution: p₁ = p₁⁰ x₁ and p₂ = p₂⁰ x₂, where p⁰ is the vapour pressure of the pure component at the same temperature.

Deriving the total pressure. By Dalton's law of partial pressures, p_total = p₁ + p₂.
Substitute Raoult's law: p_total = p₁⁰ x₁ + p₂⁰ x₂.
Since x₁ = 1 − x₂: p_total = p₁⁰ (1 − x₂) + p₂⁰ x₂.
Rearranging: p_total = p₁⁰ + (p₂⁰ − p₁⁰) x₂.
So the total vapour pressure (i) can be written using the mole fraction of either component, (ii) varies linearly with x₂, and (iii) lies between p₁⁰ and p₂⁰.

Composition of the vapour. If y₁ and y₂ are the mole fractions in the vapour, Dalton's law gives p₁ = y₁ p_total and p₂ = y₂ p_total, so y_i = p_i ÷ p_total. The vapour is always richer than the liquid in the more volatile component (the one with the larger p⁰). This is the basis of fractional distillation.

Worked example 1: total pressure and vapour composition

At a certain temperature, pure liquid A has a vapour pressure of 450 mm Hg and pure B 150 mm Hg (illustrative values). An ideal solution contains 1 mol of A and 3 mol of B. Find p_total and the mole fraction of A in the vapour.

x_A = 1 ÷ 4 = 0.25; x_B = 0.75.
p_A = 450 × 0.25 = 112.5 mm Hg; p_B = 150 × 0.75 = 112.5 mm Hg.
p_total = 112.5 + 112.5 = 225 mm Hg.
y_A = 112.5 ÷ 225 = 0.50. A is only 25% of the liquid but 50% of the vapour, because A is more volatile.

Worked example 2: finding the liquid composition

Pure liquids P and Q have vapour pressures 600 and 200 mm Hg at a given temperature (illustrative values). An ideal mixture has a total vapour pressure of 360 mm Hg. Find x_P and y_P.

p_total = p_Q⁰ + (p_P⁰ − p_Q⁰) x_P → 360 = 200 + 400 x_P → x_P = 160 ÷ 400 = 0.40.
p_P = 600 × 0.40 = 240 mm Hg; y_P = 240 ÷ 360 = 0.667.

Raoult's law as a special case of Henry's law

Henry's law says p = K_H x for a gas in a liquid; Raoult's law says p = p⁰ x for a volatile liquid. Both say partial pressure is proportional to mole fraction; only the constant differs. Raoult's law is the special case of Henry's law in which K_H = p⁰.

A non-volatile solute lowers the vapour pressure

If the solute is non-volatile (glucose, urea, common salt), only the solvent contributes to the vapour. Some of the surface is now occupied by solute particles, so fewer solvent molecules can escape, and the vapour pressure falls. Raoult's law still applies to the solvent: p₁ = p₁⁰ x₁. A graph of p₁ against x₁ is a straight line from zero to p₁⁰. The lowering depends on how many solute particles are present, not on what they are.

Ideal and non-ideal solutions

An ideal solution obeys Raoult's law over the whole range of composition. It also has ΔmixH = 0 and ΔmixV = 0: no heat is absorbed or released on mixing, and the volumes simply add. At the molecular level, the A–B attractions are about the same as the A–A and B–B attractions. Perfect ideality is rare, but n-hexane + n-heptane, bromoethane + chloroethane and benzene + toluene come close.

A non-ideal solution does not obey Raoult's law over the whole range. Its vapour pressure is either higher (positive deviation) or lower (negative deviation) than Raoult's law predicts.

Positive and negative deviation from Raoult's law

  • Positive deviation
    • A–B attractions weaker than A–A and B–B
    • Molecules escape more easily
    • Vapour pressure higher than predicted
    • ΔmixH > 0 (heat absorbed), ΔmixV > 0
    • Examples: ethanol + acetone; carbon disulphide + acetone
    • Large deviation gives a minimum boiling azeotrope
  • Negative deviation
    • A–B attractions stronger than A–A and B–B
    • Molecules escape less easily
    • Vapour pressure lower than predicted
    • ΔmixH < 0 (heat released), ΔmixV < 0
    • Examples: chloroform + acetone; phenol + aniline
    • Large deviation gives a maximum boiling azeotrope

In ethanol, molecules are held by hydrogen bonds. Acetone molecules slip between them and break some of these bonds without forming equally strong new ones, so molecules escape more easily: a positive deviation. In chloroform + acetone, the C–H of chloroform forms a hydrogen bond with the oxygen of acetone, a new attraction that holds molecules back: a negative deviation.

Azeotropes

An azeotrope is a binary mixture that has the same composition in the liquid and the vapour and boils at a constant temperature, so it cannot be separated by fractional distillation. A large positive deviation gives a minimum boiling azeotrope: ethanol and water distilled from a fermented mixture stop at about 95% ethanol by volume. A large negative deviation gives a maximum boiling azeotrope: nitric acid and water form one at about 68% nitric acid by mass, boiling at 393.5 K.

Key takeaways

  • Raoult's law: p_i = p_i⁰ x_i; p_total = p₁⁰ + (p₂⁰ − p₁⁰) x₂ for an ideal binary solution.
  • The vapour is richer in the more volatile component: y_i = p_i ÷ p_total.
  • Ideal: obeys Raoult's law, ΔmixH = 0, ΔmixV = 0.
  • Positive deviation: weaker A–B forces, higher vapour pressure; negative deviation: stronger A–B forces, lower vapour pressure.

Check your understanding

  1. 1. Pure liquids A and B have vapour pressures of 300 mm Hg and 100 mm Hg. What is the total vapour pressure of an ideal solution with x_A = 0.40?

    1. 160 mm Hg
    2. 180 mm Hg
    3. 200 mm Hg
    4. 120 mm Hg
    Show answer

    Answer: B. p_A = 300 × 0.40 = 120 mm Hg. p_B = 100 × 0.60 = 60 mm Hg. p_total = 120 + 60 = 180 mm Hg.

  2. 2. For the solution in the previous question (p_A = 120 mm Hg, p_total = 180 mm Hg), what is the mole fraction of A in the vapour?

    1. 0.40
    2. 0.33
    3. 0.50
    4. 0.67
    Show answer

    Answer: D. y_A = p_A ÷ p_total = 120 ÷ 180 = 0.67. The vapour is richer in A (0.67) than the liquid (0.40) because A is the more volatile liquid.

  3. 3. Which mixture shows a negative deviation from Raoult's law?

    1. Chloroform and acetone
    2. Ethanol and acetone
    3. Benzene and toluene
    4. n-Hexane and n-heptane
    Show answer

    Answer: A. Chloroform's C–H forms a hydrogen bond with acetone's oxygen. The A–B attraction is stronger than in the pure liquids, so the vapour pressure is lower than Raoult's law predicts: a negative deviation. Ethanol + acetone deviates positively; the last two are nearly ideal.

  4. 4. For a solution showing a positive deviation from Raoult's law, which signs are correct?

    1. ΔmixH < 0 and ΔmixV < 0
    2. ΔmixH = 0 and ΔmixV = 0
    3. ΔmixH > 0 and ΔmixV > 0
    4. ΔmixH < 0 and ΔmixV > 0
    Show answer

    Answer: C. In a positive deviation the A–B attractions are weaker than A–A and B–B. Energy is needed to separate the stronger like-like attractions than is recovered from the weaker A–B ones, so heat is absorbed (ΔmixH > 0), and the molecules sit a little further apart, so the volume increases (ΔmixV > 0).

  5. 5. Assertion (A): An ethanol–water mixture cannot be made into pure ethanol by fractional distillation alone. Reason (R): Ethanol and water form a minimum boiling azeotrope in which the liquid and vapour have the same composition.

    1. Both A and R are true, and R is the correct explanation of A
    2. Both A and R are true, but R is not the correct explanation of A
    3. A is true, but R is false
    4. A is false, but R is true
    Show answer

    Answer: A. Both are true. Ethanol–water shows a large positive deviation and forms a minimum boiling azeotrope at about 95% ethanol by volume. At that composition the vapour has the same composition as the liquid, so further distillation gives no separation. R explains A.

Privacy · Terms · Refunds · Delivery