- Foundation
- About 14 min
- 5 practice questions
Controlling air pollution: filters, precipitators, scrubbers and catalytic converters
Match each air pollutant to the device that removes it, write the reactions in a catalytic converter and a lime scrubber, and do simple mass calculations on them.
If something looks wrong, please tell us.
Knowing how pollutants form is only half of environmental chemistry. The other half is stopping them from reaching the air. Different pollutants need different tools: a gas cannot be caught in a net and a fine dust cannot be washed away by a catalyst. This lesson pairs each problem with its remedy.
The first rule: prevent, then clean
The best control is at the source: use a cleaner fuel, improve the burning so that it is complete, and save energy so that less fuel is burnt at all. Taller chimneys only spread pollutants over a larger area, so they dilute but do not remove them. Cleaning devices are needed where prevention is not enough.
Removing particles
- Electrostatic precipitator: the smoke passes between plates carrying a high voltage. The dust particles become charged and are pulled onto oppositely charged plates, from which they are shaken off as a powder. It is widely used in power stations and cement works.
- Cyclone separator: the dusty gas is spun in a cone-shaped chamber, and heavy particles are thrown to the walls and fall into a bin.
- Bag filter: the gas passes through cloth bags that hold back the fine dust.
- Wet scrubber: a water spray washes the particles out, and it can also dissolve soluble gases.
Removing sulphur dioxide
Sulphur dioxide from burning coal can be cut by using coal or oil with little sulphur, or by flue gas desulphurisation, in which the waste gas is passed through a slurry of lime, Ca(OH)₂, or limestone. The acidic gas reacts with the base: SO₂ + Ca(OH)₂ → CaSO₃ + H₂O. The product can be oxidised further to calcium sulphate, which is gypsum.
Cleaning vehicle exhaust
A catalytic converter is a steel box with a honeycomb coated with the metals platinum, palladium and rhodium. As hot exhaust gases pass over them, three harmful gases are changed into harmless ones: 2CO + 2NO → 2CO₂ + N₂, and unburnt hydrocarbons are oxidised to carbon dioxide and water. Lead compounds coat the metals and stop them working, which is why a car with a converter must use unleaded petrol.
Dust: precipitator or filter. Acid gas (SO₂): lime scrubber. Vehicle CO, NO and hydrocarbons: catalytic converter with unleaded fuel.
Worked example 1: converter. 56 g of carbon monoxide (M = 28 g/mol) passes over the catalyst with enough NO. Moles of CO = 56 / 28 = 2 mol. From 2CO + 2NO → 2CO₂ + N₂, 2 mol of CO gives 2 mol of CO₂ = 2 × 44 = 88 g. The same 2 mol of CO consumes 2 mol of NO = 2 × 30 = 60 g, and 1 mol of N₂ (28 g) is formed. Mass check: 56 + 60 = 116 g in; 88 + 28 = 116 g out.
Worked example 2: lime scrubber. How much slaked lime is needed to remove 64 kg of sulphur dioxide? M(SO₂) = 64 and M(Ca(OH)₂) = 40 + 2 × 17 = 74. The equation shows 1 : 1 in moles, so 64 kg of SO₂ needs 74 kg of Ca(OH)₂, and gives 120 kg of CaSO₃ (M = 40 + 32 + 48 = 120). The check is 64 + 74 = 138 = 120 + 18 (water).
Worked example 3: choose the remedy. (a) Black dust from a brick kiln chimney: a cyclone or bag filter. (b) Acid gas from a coal power plant: lime scrubber. (c) Carbon monoxide and nitric oxide from a petrol car: catalytic converter and unleaded petrol. (d) Dust from a cement factory: electrostatic precipitator.
Key takeaways
- Prevention at source beats cleaning afterwards; taller chimneys only dilute.
- Precipitators, cyclones and filters remove particles; lime scrubbers remove SO₂.
- A catalytic converter turns CO, NO and hydrocarbons into CO₂, N₂ and water, and is poisoned by lead.
Check your understanding
-
1. An electrostatic precipitator removes
- carbon monoxide
- sulphur dioxide
- dust particles
- ozone
Show answer
Answer: C. It charges dust particles and collects them on oppositely charged plates. It does not remove gases.
-
2. Why must a car fitted with a catalytic converter use unleaded petrol?
- Lead makes the engine run too hot
- Lead poisons the catalyst surface
- Lead turns CO into CO₂ faster
- Lead burns to give more water
Show answer
Answer: B. Lead deposits on the platinum, palladium and rhodium surface and poisons it, so the converter no longer works.
-
3. In a lime scrubber, SO₂ reacts with Ca(OH)₂ to give
- CaCO₃ and water
- CaCl₂ and water
- CaO and hydrogen
- CaSO₃ and water
Show answer
Answer: D. The acidic oxide SO₂ reacts with the base: SO₂ + Ca(OH)₂ → CaSO₃ + H₂O.
-
4. How much CO₂ forms when 28 g of CO passes through a converter by 2CO + 2NO → 2CO₂ + N₂?
- 44 g
- 22 g
- 88 g
- 28 g
Show answer
Answer: A. 28 g is 1 mol of CO. It gives 1 mol of CO₂, which is 44 g.
-
5. Which method is a prevention at source, not a clean-up?
- Fitting a bag filter to the chimney
- Switching to a fuel with less sulphur
- Adding a wet scrubber to the chimney
- Fitting an electrostatic precipitator
Show answer
Answer: B. Using a low-sulphur fuel stops sulphur dioxide from forming at all. The other three treat the pollution after it is made.
Sign in to keep track of the lessons you finish.