• Foundation
  • About 13 min
  • 5 practice questions

Counting particles: comparing solutions and everyday uses of colligative properties

Rank solutions by how many particles they contain, and explain antifreeze, salt on icy roads, swelling raisins and water purification in terms of colligative properties.

If something looks wrong, please tell us.

The last lesson of the course gave you four formulas. This lesson lets you use the idea behind them without a calculator: the more particles a solution has per kilogram of water, the greater the effect on freezing point, boiling point, vapour pressure and osmotic pressure. With a little counting you can rank solutions, and with the same idea you can explain things you see every day.

Count the particles, then compare

For solutes that dissolve completely, the effect depends on the total number of dissolved particles. Sugar, urea and glucose do not split, so one mole gives one mole of particles. Sodium chloride splits into two ions, so one mole gives two. Calcium chloride gives three. The simplified comparison below assumes complete splitting into ions, as in textbook problems; real solutions behave a little less strongly.

Counting particles
0.1 molal solution ofParticles per formula unitParticles per kg of waterEffect on freezing point
Glucose10.1 molSmallest lowering
Sodium chloride20.2 molTwice that of glucose
Calcium chloride30.3 molThree times that of glucose

So among these three solutions of equal molality, calcium chloride has the lowest freezing point and the highest boiling point, and glucose has the highest freezing point and the lowest boiling point. For vapour pressure the order reverses: the solution with the most particles has the lowest vapour pressure.

Worked example 1: antifreeze

Ethylene glycol (molar mass 62 g/mol) is added to the water in a car radiator. If 124 g of ethylene glycol is dissolved in 1 kg of water, Step 1: moles = 124 ÷ 62 = 2 mol, so the solution is 2 molal. Step 2: ΔTf = 1.86 × 2 = 3.72 K. Step 3: the water now freezes at 0 − 3.72 = −3.72 °C. Ethylene glycol does not split into ions, so no factor of 2 is needed.

Worked example 2: salt on icy roads

Salt spread on ice dissolves in the thin film of water on the surface and forms a solution that freezes at a lower temperature than pure water, so the ice melts. Take a 1 molal NaCl solution, assuming complete splitting into two ions. Step 1: effective particles = 2 × 1 = 2 mol per kg. Step 2: ΔTf = 1.86 × 2 = 3.72 K. In this idealised case the freezing point falls to about −3.7 °C. On a night much colder than that, salt cannot stop the road from freezing.

Worked example 3: salted water for cooking

A 1 molal solution of salt (complete splitting) has ΔTb = 0.52 × 2 = 1.04 K, so it would boil at 101.04 °C. In a kitchen a pinch of salt in a litre of water is a tiny fraction of 1 molal, so its effect on boiling point is much less than 1 K and cannot be noticed.

Osmosis in daily life

  • Dry raisins soaked in water swell, because water passes through the skin into the sweeter, more concentrated inside.
  • Pickles and salted fish keep for a long time because salt draws water out of any germ that settles on them, so the germ shrivels.
  • A plant given too much fertiliser may wilt: the soil solution becomes more concentrated than the root cells, and water leaves the roots.
  • A drip given to a patient is made isotonic with blood so the blood cells neither swell nor shrink.
  • Reverse osmosis purifiers push water through a membrane against the natural direction of flow, using pressure greater than the osmotic pressure, leaving dissolved salts behind.

More particles per kilogram of water means a larger change: lower freezing point, higher boiling point, lower vapour pressure, higher osmotic pressure. Count ions, not formula units.

Key takeaways

  • Rank solutions of equal molality by number of particles per formula unit: glucose 1, NaCl 2, CaCl2 3.
  • Antifreeze and road salt lower the freezing point of water.
  • Osmosis explains swollen raisins, wilting plants and the strength of drips.
  • Reverse osmosis needs pressure greater than the osmotic pressure.

Check your understanding

  1. 1. Among 0.1 molal solutions of glucose, NaCl and CaCl2 (complete splitting), the lowest freezing point belongs to:

    1. Glucose
    2. NaCl
    3. They are equal
    4. CaCl2
    Show answer

    Answer: D. CaCl2 gives 3 particles per formula unit, so 0.3 mol of particles per kg, the largest lowering.

  2. 2. Salt is spread on icy roads because:

    1. Salt makes the ice warmer and softer
    2. Salt lowers the freezing point so ice melts
    3. Salt raises the boiling point of the ice
    4. Salt turns the ice into steam
    Show answer

    Answer: B. Dissolved salt lowers the freezing point of the water film, so ice melts at a lower temperature than 0 °C.

  3. 3. 124 g of ethylene glycol (62 g/mol) is dissolved in 1 kg of water (Kf = 1.86 K kg/mol). The freezing point of the solution is:

    1. −1.86 °C
    2. −3.72 °C
    3. −7.44 °C
    4. −0.93 °C
    Show answer

    Answer: B. Moles = 2, molality = 2 m, ΔTf = 1.86 × 2 = 3.72 K, so the freezing point is −3.72 °C.

  4. 4. Dry raisins swell when soaked in water because:

    1. Water enters through the skin by osmosis
    2. Sugar leaves the raisin through the skin
    3. Air enters the raisin through its skin
    4. The skin of the raisin slowly dissolves
    Show answer

    Answer: A. The inside of a raisin is more concentrated than the water outside, so water moves in through the skin, which acts as a semipermeable membrane.

  5. 5. The boiling-point elevation of a 1 molal NaCl solution, assuming complete splitting into ions (Kb = 0.52 K kg/mol), is:

    1. 1.04 K
    2. 0.52 K
    3. 2.08 K
    4. 0.26 K
    Show answer

    Answer: A. Effective molality = 2, so ΔTb = 0.52 × 2 = 1.04 K.

Privacy · Terms · Refunds · Delivery