• Practice
  • About 25 min
  • 15 practice questions

Final self-assessment: Heat

Test yourself on the whole course: 15 questions with answers explained.

If something looks wrong, please tell us.

Attempt all 15 questions without looking back at the lessons, then check each answer and read the explanation. Use: specific heat of water 1 cal/g °C, latent heat of fusion of ice 80 cal/g, latent heat of vaporisation of water 540 cal/g.

Final self-assessment

  1. 1. On the temperature-time graph for heating ice, why is the graph flat at 0 °C?

    1. The burner is switched off
    2. Heat is absorbed as latent heat of fusion and the temperature does not rise until all the ice melts
    3. Ice cannot absorb heat
    4. The thermometer stops working
    Show answer

    Answer: B. During melting, heat is used to weaken the bonds between molecules, so the temperature stays at the melting point until all the ice has melted.

  2. 2. How much heat is needed to change 5 g of ice at 0 °C into water at 20 °C?

    1. 400 cal
    2. 100 cal
    3. 500 cal
    4. 2700 cal
    Show answer

    Answer: C. Melt: 5 × 80 = 400 cal. Warm: 5 × 1 × 20 = 100 cal. Total = 500 cal.

  3. 3. During the change of a liquid into a solid, the latent heat is:

    1. Given out
    2. Absorbed
    3. Zero
    4. Converted into mass
    Show answer

    Answer: A. Freezing is the reverse of melting, so the latent heat absorbed during melting is given out during freezing.

  4. 4. Two pieces of ice pressed together for a while stick to each other. The reason is:

    1. Anomalous expansion
    2. High specific heat of ice
    3. Regelation: ice melts under pressure and refreezes when pressure is released
    4. Evaporation
    Show answer

    Answer: C. At the points of contact, pressure lowers the melting point and a thin layer melts. When the pressure is released, it refreezes and joins the pieces.

  5. 5. When water is cooled from 4 °C to 0 °C, its volume:

    1. Decreases
    2. Stays the same
    3. First increases then decreases
    4. Increases
    Show answer

    Answer: D. Water has its minimum volume at 4 °C. Cooling it below 4 °C makes it expand, so its volume increases.

  6. 6. Why do water pipes burst in very cold regions in winter?

    1. Water contracts on freezing
    2. Water expands as it cools below 4 °C and on freezing, pushing on the pipe walls
    3. Ice is heavier than water
    4. The pipes contract and crush the water
    Show answer

    Answer: B. Below 4 °C water expands, and it expands further when it turns to ice. This expansion exerts great force on the pipe and can burst it.

  7. 7. Air in a room holds 7.5 g/m³ of vapour; 15 g/m³ would saturate it. The relative humidity and how the air feels are:

    1. 50%, dry
    2. 50%, humid
    3. 200%, humid
    4. 7.5%, dry
    Show answer

    Answer: A. Relative humidity = (7.5 / 15) × 100 = 50%. This is below about 60%, so the air feels dry.

  8. 8. Drops form on the outside of a cold bottle from the refrigerator because:

    1. Water leaks through the glass
    2. The bottle sweats
    3. Air touching the bottle is cooled below its dew point and vapour condenses
    4. The bottle absorbs water from inside
    Show answer

    Answer: C. The cold surface cools the nearby air below its dew point. The air becomes saturated and the excess vapour condenses as droplets on the bottle.

  9. 9. On a humid day, the white trail behind a high-flying aircraft:

    1. Does not form at all
    2. Disappears at once
    3. Turns into rain at once
    4. Lasts for a long time
    Show answer

    Answer: D. The trail is condensed vapour. In air with high relative humidity it evaporates slowly, so it lasts long; in dry air it is short or absent.

  10. 10. Why is the range 14.5 °C to 15.5 °C stated in the definition of the calorie?

    1. Because water boils at 15 °C
    2. Because the heat needed to warm water by 1 °C differs slightly in different ranges
    3. Because water is densest there
    4. Because it is room temperature everywhere
    Show answer

    Answer: B. The heat needed for a 1 °C rise is slightly different at different temperatures, so a definite range is fixed to make the unit exact.

  11. 11. A 500 g aluminium pan (c = 0.2 cal/g °C) is heated from 30 °C to 130 °C. How much heat does it absorb?

    1. 100 cal
    2. 50000 cal
    3. 13000 cal
    4. 10000 cal
    Show answer

    Answer: D. Q = m c ΔT = 500 × 0.2 × (130 − 30) = 500 × 0.2 × 100 = 10000 cal.

  12. 12. Which statement about specific heat capacity is correct?

    1. It is the same for all substances
    2. It is the heat needed to raise unit mass of a substance by 1 °C
    3. Its SI unit is J/kg
    4. Water has a very low specific heat capacity
    Show answer

    Answer: B. Specific heat capacity is heat per unit mass per degree; its SI unit is J/kg °C. It differs between substances, and water's is very high.

  13. 13. 50 g of water at 90 °C is mixed with 100 g of water at 30 °C with no heat loss. What is the final temperature?

    1. 50 °C
    2. 60 °C
    3. 45 °C
    4. 40 °C
    Show answer

    Answer: A. 50(90 − T) = 100(T − 30): 4500 − 50T = 100T − 3000, so 150T = 7500 and T = 50 °C.

  14. 14. A 200 g copper ball (c = 0.1 cal/g °C) at 100 °C is put in 180 g of water at 20 °C. Ignoring the container, what is the final temperature?

    1. 60 °C
    2. 28 °C
    3. 20 °C
    4. 32 °C
    Show answer

    Answer: B. Heat lost by copper = 200 × 0.1 × (100 − T) = 20(100 − T). Heat gained by water = 180 × 1 × (T − 20). So 2000 − 20T = 180T − 3600, 200T = 5600 and T = 28 °C.

  15. 15. How much steam at 100 °C must condense and cool to 0 °C to melt 160 g of ice at 0 °C?

    1. 20 g
    2. 16 g
    3. 23.7 g
    4. 12800 g
    Show answer

    Answer: A. Heat needed to melt the ice = 160 × 80 = 12800 cal. Each gram of steam gives 540 + 100 = 640 cal when it condenses and cools to 0 °C. Steam needed = 12800 / 640 = 20 g.

Questions 1-3: lesson 1 (latent heat). Questions 4-6: lesson 2 (regelation and anomalous behaviour of water). Questions 7-9: lesson 3 (humidity and dew point). Questions 10-12: lesson 4 (units of heat and specific heat). Questions 13-15: lesson 5 (heat exchange and calorimetry).

Sign in to keep track of the lessons you finish.

Privacy · Terms · Refunds · Delivery